Question is ⇒ The first dominant pole encountered in the frequency response of a compensated op-amp is approximately at, Options are ⇒ (A) 5 Hz, (B) 10 kHz, (C) 1 MHz, (D) 100 MHz, (E) , Leave your comments or Download question paper.

Question is ⇒ The first dominant pole encountered in the frequency response of a compensated op-amp is approximately at, Options are ⇒ (A) 5 Hz, (B) 10 kHz, (C) 1 MHz, (D) 100 MHz, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The first dominant pole encountered in the frequency response of a compensated op-amp is approximately at
A.	5 Hz [Correct Answer]
B.	10 kHz [Wrong Answer]
C.	1 MHz [Wrong Answer]
D.	100 MHz [Wrong Answer]
View Answer 2 -5 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In figure what is the base current if V_BE = 0
10 mA
9.3 mA
10 μA
9.3 μA

⇒ Two coil have their axis perpendicular to each other. The coefficient of coupling k is
1
0.5
more than 0 but less than 1
0

⇒ A conductor in x-y plane and having length 1 m is moving with a velocity V = (2i + 3j + k) m/sec. A magnetic induction field B = (i + 2j) Wb/m² is applied to the conductor. The potential difference between the ends of the conductor is
0
4.88 V
6 V
None of these

⇒ In an impedance smith chart, a clockwise movement along a constant resistance circle gives rise to
decrease in the value of reactance
an increase in the value of reactance
no change in the reactance value
no change in the impedance value

⇒

Assertion (A): The speed of a shaft can be measured by using a dc tacho generator.

Reason (R): A two phase servometer can also be used as a speed transducer.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ The hexadecimal number given below represent decimal numbers which are multiples of DC, C8, BE, 46, IE
2
6
7
10

⇒ A 3 phase star-connected load has one capacitor C in R phase and two equal resistances in Y and B phases.The phase sequence is RBY. Then
V_B0 > V_Y0
V_B0 < V_Y0
V_B0 = V_Y0
V_B0 = V_BY

⇒ For 10 bit PCM system, the signal to quantization noise ratio is 62 dB. If the number of bits is increased by 2, then the signal to quantization noise ratio will
increased by 6 dB
increased by 12 dB
decreased by 6 dB
decreased by 12 dB

⇒ A coil of resistance R and inductance L is connected in series with 10 mF capacitor. The resonant frequency is 1000 Hz. Another 10 F capacitor is connected in parallel with the above capacitor. The new resonance frequency will be
1000 Hz
more than 1000 Hz
less than 1000 Hz
may be more or less than 10000 Hz

⇒ A function will have only sine terms if
f(t) = - f(t)
f(-t) = f(t)
f(-t) = -f(t)
none of the above

⇒ In the network shown in figure, the voltage drops across R₂ and R₃ are 10 V and 16 V with polarities as shown. The current in R_{1is 9 A and directed towards node 0
is 9 A and directed away from node 0
is 9 A but directed of current cannot be found
is impossible to be found}

⇒ Ridge waveguide is essentially a form of capacitively loaded guide.
TRUE
FALSE

⇒ In a rectifier only a portion of input power is converted into DC power. The rest is AC power.
TRUE
FALSE

⇒ Figure shows a pole zero plot of I(s). The likely current response in time domai
i (t) = e^-1 - e^-3t
i (t) = e^-1 - 2e^-2t
i (t) = e^-1 - e^-2t
i (t) = e^-1 - e^-4t

⇒

Match the following:

	List I		List II
A.	Fourier transform of a Gaussian function	1.	Gaussian function
B.	Convolution of a rectangular pulse with itself	2.	Rectangular pulse
C.	Current through inductor for step input voltage	3.	Triangular pulse
		4.	Ramp function
		5.	Zero

A-1, B-2, C-3
A-2, B-4, C-5
A-1, B-3, C-4
A-2, B-3, C-5

⇒ If J = 12 and X = 24.4 the result of the following FORTRAN 77 program will be 12, 144, 73.2
15.0, 144.0, 73.2
15.0, 144.0, 73
15. 144. 73

⇒ Transverse magnetic (TM) waves have
magnetic field component H in the direction of propagation
electric field component E in the direction of propagation
magnetic field component H in the direction of propagation and no component of electric field E in this direction
electric field component E in the direction of propagation and no component of magnetic field H in this direction

⇒ The bandwidth of DSB suppressed carrier modulation system when the modulating frequency varies between 500 Hz and 5 kHz is
555 kHz
505 kHz
500 kHz
9 kHz

⇒ Consider a 300 Ω, quarter wave long at 1 GHz transmission line as shown in figure. It is connected to a 10 V, 50 Ω source at one end is left open circuited at the other end. The magnitude of the voltage at the open circuit end of the line
10 V
5 V
60 V
60/7 volt

⇒ Three resistance of 15 Ω each are connected in delta. The resistance of equivalent star will have a value of
15 Ω
5 Ω
5/3 Ω
45 Ω

⇒ A pulse function can be represented as difference of two equal step functions.
TRUE
FALSE

⇒ A + (B . C) =
A . B + C
A . B + A . C
A
(A + B) . (A + C)

⇒ The hexadecimal number 5 F is equal to binary number
1010011
1011001
1010101
1011111

⇒ The maximum usable frequency for the 'E' layer is 10 MHz.
TRUE
FALSE

⇒ For a MOS capacitor fabricated on a P-type semiconductor, strong inversion occurs when
surface potential is equal to Fermi potential
surface Potential is greater than Fermi potential
surface potential is - ve and equal to Fermi potential in magnitude
surface potential is + ve and equal to twice the Fermi potential

⇒ Semiconductors have
aero temperature coefficient of resistance
positive temperature coefficient of resistance
negative temperature coefficient of resistance
none of the above

⇒ In the circuit of figure, the load current when thyristor is
is constant
increases exponentially
decreases exponentially
zero

⇒ Which one of the following materials is used for making permanent magnets?
Steel
Carbon
Carbon-Steel
Graphite

⇒ In a series operated thyristor configuration, each thyristor should support 100 V. However, the three thyristors only support voltage of 100 V, 90 V and 85 V respectively. Hence, the string efficiency in the case is :
0.9845
0.4584
0.9167
none of these

⇒ A long specimen of P type semiconductor material
is + vely charged
is electrically neutral
has an electric field directed along its length
acts as a dipole