Question is ⇒ The fabrication of microstrip line is done by, Options are ⇒ (A) photo etching, (B) printed circuit technique, (C) oxidation, (D) cladding, (E) , Leave your comments or Download question paper.

Question is ⇒ The fabrication of microstrip line is done by, Options are ⇒ (A) photo etching, (B) printed circuit technique, (C) oxidation, (D) cladding, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The fabrication of microstrip line is done by
A.	photo etching [Wrong Answer]
B.	printed circuit technique [Correct Answer]
C.	oxidation [Wrong Answer]
D.	cladding [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ For a system to work, as oscillator the total phase shift of the loop gain must be equal to
90°
45°
270°
360°

⇒

Assertion (A): When cathode temperature is increased from 2500 K to 2550 K, thermionic emission current may increase by about 50%.

Reason (R): Thermionic emission current ∝ T² e^-Ew/kT.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒

Assertion (A): In many materials, dielectric polarization causes mechanical distortion.

Reason (R): If dielectric polarization causes mechanical distortion then mechanical distortion must cause dielectric polarization.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ A series resonant circuit has R = 2 Ω, L = 0.1 H and C =10 μF. At resonance applied voltage = 10 ∠0 V. Voltage across inductance is likely to be
10 ∠0 V
10 ∠45° V
100 ∠90° V
100 ∠-90° V

⇒

Match the following:

	List I (Digital circuit)		List II (Circuit type)
A.	BCD to 7 segment decoder	1.	sequential circuit
B.	4-to-1 MUX	2.	combinational circuit
C.	4 bit shift register	3.	neither sequential nor combinational circuit

A-2, B-1, C-2, D-1
A-3, B-2, C-1, D-3
A-2, B-2, C-1, D-1
A-3, B-1, C-2, D-3

⇒ Push pull amplifier is
voltage amplifier
current amplifier
power amplifier
none of the above

⇒ In a combination limiter with sinusoidal input voltage the output wave can be nearly square.
TRUE
FALSE

⇒ The induced magnetic dipole moment has a direction opposite to the applied magnetic field.
TRUE
FALSE

⇒ In a linear bilateral passive element two port which of the following holds for z parameters?
z₁₁ = z₂₂
z₁₂ z₂₂ = z₁₁ z₂₂
z₁₁ z₁₂ = z₂₂ z₂₁
z₁₂ = z₂₁

⇒ In the given figure the E and H lines in a coaxial c
The radial lines are E lines and circular lines are H lines
Radial lines are H lines and circular lines are E lines
The directions of E and H lines are wrong
Radial lines may be E and H lines depending an direction of current

⇒ The band gap of silicon at 300K is
1.36 eV
1.10 eV
0.80 eV
0.67 eV

⇒ Find E at P(1, 1, 1) caused by four identical 3 nC point charges located at P₁(1, 1, 0), P₂(- 1, 1, 0), P₃(- 1, - 1, 0) P₄(1, - 1, 0)
21.58a_x + 21.58a_y + 12a_z V/m
6.82a_x + 6.82a_y + 32.89a_z V/m
-6.82a_x - 6.82a_y - 32.89a_z V/m
-21.58a_x - 21.58a_y - 12az V/m

⇒ In a driving point function, the degrees of numerator and denominator polynomials in s may differ by either zero or one only.
TRUE
FALSE

⇒ A 4 bit ripple counter is in 0000 state. The clock pulses are applied and then removed. The counter reads 0011. The number of clock pulses which have occurred are
3
3 or 19
3 or 19 or 35
none of the above

⇒ When all the seven segments of a display are energized, the number shown is
0
1
7
8

⇒ Which statement out of the following statement is wrong?
Attenuation of satellite signals by rain and fog varies almost inversely with the angle of elevation
At 12/4, GHz link frequencies, signal power loss due to rain and fog is much greater than at 4/6 GHz frequencies
The distance between satellite and Earth station varies slightly with angle of elevation
At present 4/6 GHz geostationary satellites are being parked in geosynchronous, orbits at least 10° apart

⇒ Mc Murray full bridge inverter uses
4 thyristors and 2 diodes
4 thyristors and 4 diodes
8 thyristors and 4 diodes
8 thyristors and 8 diodes

⇒ The circuit in figure(1) is replaced by that in figure(2). It remains same R₀ wil
zero
R
2R
4R

⇒ In metals, the flow of current is due to
electrons
ions
holes
electrons and ions

⇒ In a highly capacitive circuit the
apparent power is equal to the actual power
reactive power is more than the apparent power
reactive power is more than the actual power
actual power is more than its reactive power

⇒

Assertion (A): Demodulation of SSB and AM signals is exactly similar

Reason (R): The basic SSB demodulation device is product detector.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ In the human eye, an image persists for a time of about
1 second
0.1 second
0.05 second
0.02 second

⇒

Assertion (A): In direct addressing the address of operand is specified in the instruction.

Reason (R): Direct addressing is also called absolute addressing.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ Which amplifier has the higher power gain?
Common emitter
Common collector
Common base
Both CC and CE

⇒ The two modes of operation of three phase bridge inverters are known as
60° mode and 120° mode
90° mode and 120° mode
120° mode and 180° mode
120° mode and 240° mode

⇒ The skip distance is the maximum distance upto which ionospheric reflection is possible.
TRUE
FALSE

⇒ In PAL system
phase of U signal is reversed on alternating lines
phase of V signal is reversed on alternating lines
phases of both U and V signals are reversed on alternating lines
none of the above

⇒ Which of the following are true for magic tee in the given figure select the answer as per given c
1, 2 and 3
1, 2 and 4
2, 3 and 4
1, 3 and 4

⇒ The amplifier network is shown bel
6.42 kΩ, 5.6 kΩ
6.42 Ω, (5.62) kΩ
6.4kΩ, (5.62) kΩ
6.42 Ω, 5.6 kΩ

⇒ In PAL system weighting of R - Y and B - Y signals is done to
prevent over modulation on saturated colours
prevent under modulation of saturated colours
allow over modulation of saturated colours
allow under modulation on saturated colours