Question is ⇒ The entries in the first column of Routh array of a fourth order are 5, 2, - 0.1, 2, 1. The number of poles in the right half plane are, Options are ⇒ (A) 1, (B) 2, (C) 3, (D) 4, (E) , Leave your comments or Download question paper.

Question is ⇒ The entries in the first column of Routh array of a fourth order are 5, 2, - 0.1, 2, 1. The number of poles in the right half plane are, Options are ⇒ (A) 1, (B) 2, (C) 3, (D) 4, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The entries in the first column of Routh array of a fourth order are 5, 2, - 0.1, 2, 1. The number of poles in the right half plane are
A.	1 [Wrong Answer]
B.	2 [Correct Answer]
C.	3 [Wrong Answer]
D.	4 [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A thermistor is used for
over voltage protection
temperature alarm circuit
automatic light control
none of the above

⇒ A cable has an insulation resistance of 10¹⁰ ohms. If the length is doubled, the insulation resistance will be
2 x 10¹⁰ Ω
0.5 x 10¹⁰ Ω
10¹⁰ Ω
4 x 10¹⁰ Ω

⇒ When the height of a vertical earthed antenna is less than λ/4
the base input impedance will be capacitive
the base input impedance will be purely resistive
the base input impedance will be inductive
the base input impedance will be negligibly small

⇒ An LED is
an ohmic device
a display device
a voltage regulated device
all of the above

⇒ In TE mode of waveguide E_z = 0
TRUE
FALSE

⇒ An input voltage V(t) = 10 2 cos (t + 10°) + 10 3 cos (2t + 10°)V is applied to a series combination of resistance R = 1 kΩ inductance L = 1H. The resulting steady-state current i(t) in ampere is
10 cos (t + 55°) + 10 cos (2t + 10° tan^-12)
10 cos (t + 55°) + 103/2 cos (2t + 55°)
10 cos (t - 35) + 10 cos (2t + 10° - tan^-12)
10 cos (t - 35) + 103/2 cos (2t + 35°)

⇒ In a half wave voltage doubler circuit the input frequency is 50 Hz. The ripple frequency is
25 Hz
50 Hz
100 Hz
150 Hz

⇒ Each term in POS form is called max terms.
TRUE
FALSE

⇒ Circuit shown in the figur
astable multivibrator
monostable multivibrator
VCO
ramp Generator

⇒ Which of the following insulating material is restricted to temperatures below 100°C?
Micanite
Asbestos
Teflon
Polythene

⇒ NMOS devices have __________ switching speeds and __________ on-state resistance; as compared with PMOS devices.
slower, higher
faster, lower
faster, higher
slower, lower

⇒ In a Vidicon camera tube,
both sides of the target plate have the coating of tin oxide
both sides of the target plate have the coating of antimony tri-sulphide
the side of target plate facing the light has a coating of tin oxide and the side facing electron gun has a coating of antimony trisulphide
the side of target plate facing the light has a coating of antimony trisulphide while the side facing the electron gun has a coating of tin oxide

⇒ Integral error compensation changes a second order system to
first order system
third order system
fourth order system
either (a) or (b) depending on the system

⇒ The absorption of EM wave by the atmosphere depends on
polarization of waves
frequency in use
dist. from T_y
height of antenna

⇒ The inductance of a single layer solenoid of 10 turns is 5 μH. Which one of the following is the correct value of inductance when the number of turns is 20 and the length is doubled.
10 μH
20 μH
40 μH
5 μH

⇒ In terms of signum function sgn(t), unit step function u(t) =
1 + sgn(t)
1 - sgn(t)
0.5 + 0.5 sgn(t)
0.5 - 0.5 sgn(t)

⇒ In cell communication, cell stands for
Geographical Area
Battery
Location
No meaning

⇒ An 8 bit data is to be entered into a parallel in register. The number of clock pulses required is
8
4
2
1

⇒

Assertion (A): Thermistors are commonly used to measure hot spot temperatures in electric machines.

Reason (R): Thermistor has the advantages of high temperature coefficient, small size and high speed of response.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ The current wave of figure, is passed through a 3 H inductor during the period 0 to 2 sec
is 3 V
is 6 V
increases from 0 at t = 0 to 6 V at t = 2 seconds
increases from 0 at t = 0 to 6 V at t = 2 seconds and then decreases

⇒ A line of characteristic impedance 400 Ω is terminated by a resistance of 400 Ω. The reflected quantities are
zero
equal to incident quantities
half the incident quantities
double the incident quantities

⇒ Positive feedback is mainly used in
oscillators
thyristors
voltage regulators
both (a) and (b)

⇒ While using Maxwell bridge, the Q factor of a coil is obtained as
1/ωCR
ωCR
ωC/R
R/ωC

⇒ The hexadecimal number (3E8)₁₆ is equal to decimal number
1000
982
768
323

⇒ If A = 3 + j1, A⁴ =
3.16 ∠18.4°
100 ∠73.72°
100 ∠18.4°
3.16 ∠73.22°

⇒ A presettable counter with 4 flip flops can start counting from
0
1000
any number from 0000 to 1000
any number from 0000 to 1111

⇒ At corner frequency the phase angle of factor 1/(1 + jωT) is
+90°
-90°
+45°
-45°

⇒ In a half bridge inverter, the freewheeling diodes are needed
even when load is resistive
only when load is inductive
only when load is inductive or capacitive
for all types of loads

⇒ To prevent a DC return between source and load, it is necessary to use
resistor between source and load
inductor between source and load
capacitor between source and load
either (a) or (b)

⇒ If the drift velocity of holes under a field gradient of 100 V/m is 5m/sec. Their mobility is
0.05
0.5
50
500