Question is ⇒ The energy of highest value of Autocorrelation of a function 100 cos 50 pt is, Options are ⇒ (A) 50, (B) 10, (C) 200, (D) zero, (E) , Leave your comments or Download question paper.

Question is ⇒ The energy of highest value of Autocorrelation of a function 100 cos 50 pt is, Options are ⇒ (A) 50, (B) 10, (C) 200, (D) zero, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The energy of highest value of Autocorrelation of a function 100 cos 50 pt is
A.	50 [Wrong Answer]
B.	10 [Correct Answer]
C.	200 [Wrong Answer]
D.	zero [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The attraction between the nucleus and valence electron of copper atom is
zero
weak
strong
either zero or strong

⇒ The minimum charge carried by an ion is
zero
equal to the change of an electron
equal to the change of a pair of electrons
equal to the change of electrons left in the atom

⇒ The pole zero diagram of an impedance Z has a pole at s = - 6 and zero at s = - 4 as shown in figure the constant multiplier k = 1. For a signal I_s = cos 6t, the steady state voltage across Z is given in magnitude as u
0.6
0.84
7.2
none

⇒ Higher value of ripple factor indicates
poor rectification
ideal rectification
r.m.s. value to peak value
none of the above

⇒ Consider the following DO statement in Fortran 77 1
11
10
4

⇒ If the poles lie in second quadrant, damping ratio is
1
less than 1
zero
more than 1

⇒ A microwave junction is matched at all ports if the S matrix
has all diagonal elements zero
has all diagonal elements equal but not zero
has all diagonal elements complex
is Hermitian

⇒ Self bias is an example of __________ feedback that tends to stabilize the drain current against changes in temperature and JFET replacement.
variable
low
negative
positive

⇒ In a single phase full wave regulator feeding R-L load, the minimum firing angle can be zero.
TRUE
FALSE

⇒ Which of the following is most likely to be found in an SSB transmitter?
Class A, RF output amplifier
Class B, RF amplifier
Tuned modulator
Class C, audio amplifier

⇒ A phase shifting transformer is used in conjunction with
DC slide wire potentiometer
Crompton potentiometer
AC coordinate potentiometer
Drysdale potentiometer

⇒ A radiation thermometer is suitable for temperatures
below 500°C
below 100°C
above 500°C
above 1400°C

⇒ Soft iron is suitable for making temporary magnets.
TRUE
FALSE

⇒ The value of VSWR is taken as ∞ when the line is
short-circuited
open-circuited
terminated with full load
terminated with load equal to the characteristic impedance of the load

⇒ Regulation of the DC power supply of 12 V, 100 mA is the effective resistance of power supply is 20 Ω
0.22
1.31
0.3
0.2

⇒ An ac circuit has two branches in parallel. The impedances of the two branches are equal. Their power factors are 0.8 lagging and 0.8 leading. The overall p.f. is
1
zero
about 0.7 lagging
about 0.7 leading

⇒ In a homogeneous magnetic field H of a solenoid, the core carries a magnetic dipole moment M per unit volume equal to
μ₀ H
μ_r H
(μ_r - 1) H
μ_oμ_r H

⇒ The accuracy of an instrument is determined by
closeness of indicated value to the actual value
repeatability of measured value
speed with which the reading approaches final value
least value which can be measured

⇒ In a microwave resistor the wall thickness is made as small as possible to
have high value of R
have low value of R
minimize capacitive effect
reduce inductance

⇒ In a power amplifier the collector current flows for 270° of the input cycle. The operations is
class A
class B
class AB
class C

⇒ Why npn-transistors are preferred over pnp-transistors?
Leakage current in npn-transistors is less than pnp-transistors
Mobility of majority carrier in npra-transistors is greater than the mobility of majority carrier in pnp-transistors
Bias voltage required in npn is less than in/wp-transistors
Bias voltage required in npn is greater than in pnp-transistors

⇒

Assertion (A): Temperature control of the passenger compartment of car uses both feed forward and feedback controls.

Reason (R): Feed forward control gives corrective action before the disturbance affects the output and feedback control applies corrective action after output changes.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ Consider the following library functions

EXP (i.e., e^x)
ARCTAN (i.e. tan^-1 x)
SQRT (i.e., x)
AES (i.e. |x|)
<
All
1 and 3 only
1, 3, 4 only
1, 2 and 3 only

⇒ Refraction of electromagnetic waves occurs when they
pass through a small slot in a conducting plane
pass into a medium of different dielectric constant
are polarized at right angles to the direction of propagation
encounter a perfectly conduction surface

⇒ Two linearly polarized plane waves A and B travelling in free space in the positive x direction meet at a point. Wave A is polarized in the y direction and the wave B is polarized in the z direction. If the two waves are of equal amplitude and are in phase quadrature, the resultant wave will be
circularly polarized
elliptically polarized
linearly polarized
vertically polarized

⇒ The first dominant pole encountered in the frequency response of a compensated op-amp is approximately at
5 Hz
10 kHz
1 MHz
100 MHz

⇒ Assertion (A): The resistance of a copper specimen changes by about 22% when temperature is increased from room temperature to 700°C.
Reason (R): The physical properties of a material are determined mostly by the extent of impurities.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ Of the four INSAT-I satellites planned by India so for, only __________ has proved to be successful.
INSAT-IA
INSAT-IB
INSAT-IC
INSAT-ID

⇒ The speed at which axial electric field due to signal advances in a TWT is equal to
speed of light
(speed of light) (helix pitch helix circumference)
(speed of light) (helix circumference helix pitch)
(speed of light) (helix pitch) (helix circumference)

⇒ The number of inputs and outputs of a full adder are
3 and 2 respectively
2 and 3 respectively
4 and 2 respectively
2 and 4 respectively









Users Also Read
Previous Papers
Aptitude
Reasoning
Gen.Knowledge
Speak English
English / Verbal
Online / Mock Test
Vedic Math







    
	
	




    
	StudySite.org is world's best free online study content provider, Copyright © 2024 by 
StudySite.org All Rights Reserved