Question is ⇒ The ending part of the popular teleserial Mahabharat will be beamed to the viewers, Options are ⇒ (A) WESTAT, (B) INSAT-IC, (C) ARABSAT, (D) INSAT-ID, (E) , Leave your comments or Download question paper.

Question is ⇒ The ending part of the popular teleserial Mahabharat will be beamed to the viewers, Options are ⇒ (A) WESTAT, (B) INSAT-IC, (C) ARABSAT, (D) INSAT-ID, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The ending part of the popular teleserial Mahabharat will be beamed to the viewers
A.	WESTAT [Wrong Answer]
B.	INSAT-IC [Wrong Answer]
C.	ARABSAT [Correct Answer]
D.	INSAT-ID [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In integral cycle control of ac regulator, the input power factor is equal to
duty cycle a
a²
a
(a)^1/3

⇒ The log magnitude curve for a constant gain K is a horizontal straight line at a magnitude 20 log K dB.
TRUE
FALSE

⇒

Assertion (A): The TTL output acts as a current sink in low state

Reason (R): The TTL input current is largest in low state.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ In a hi-fi system the frequency response over the audio frequency range should be within
± 10 dB
5 dB
2 dB
1 dB

⇒ If e = 10 sin(10⁸ t + 3 sin 10⁴ t) then carrier frequency is
0.159 MHz
1.59 MHz
15.9 MHz
159 MHz

⇒ Consider the following features:

negative operands cannot be used
when immediate operand changes, the program should be reassembled
the program is difficult to read
the size of operand is restricted by word length of the computer

Disadvantages of immediate addressing include
1 and 2
2 and 4
2 and 3
1 and 4

⇒ If V_dc1 is the dc output voltage in half wave controlled rectifier circuit feeding resistive load and V_dc2 is the dc output voltage in full wave controlled rectifier circuit (M - 2 connection) feeding resistive load, then
V_dc1 = 0.5 V_dc2 for all values of firing angle
V_dc1 = V_dc2 for all values of firing angle
V_dc1 ≤ 0.5 V_dc2 for all values of firing angle
V_dc1 ≥ 0.5 V_dc2 for all values of firing angle

⇒ The arrangement in the given figure is a hybid T. If 100 mW fed at port 1, the power reflected back at port
0
25 mW
50 mW
100 mW

⇒ The poles of an RC function
are simple and lie on jω axis
are simple and lie on negative real axis
may be complex conjugate
may be anywhere in s plane

⇒

Assertion (A): Microprocessors 8086 and 8088 are very similar in organisation and have identical instruction sets.

Reason (R): If clock speed is same the execution time of 8088 and 8086 are exactly equal.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒

Assertion (A): If an atom of polarizability a is placed in homogeneous field E, the energy stored is 0.5 aE².

Reason (R): Capacitance of an isolated conducting sphere R in vacuum is 4 p∈₀ R farads.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ The realization of a reactance function gives
a network having inductances only
a network having capacitances only
a network having resistances only
a network having inductances and capacitances only

⇒ The word size accessible at a time from the memory subsystem depends on
width of data bus
width of address bus
width of control bus
both (b) and (c)

⇒ Dielectric loss due to polarisation occurs in
bipolar dielectrics
non-metallic dielectrics
liquid dielectrics
all of the above

⇒ Measurement of Hall coefficient enables the determination of
transportation factor decreases and a increases
transportation factor increases and a increases
transportation factor increases and a decreases
transportation factor decreases and a decreases

⇒

Assertion (A): Microprocessor 8085 has facility of interrupt control.

Reason (R): TRAP, RST 7.5, RST 6.5, RST 5.5 and 1NTR are interrupt signals in 8085.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ A digital system is required to amplify a binary encoded audio signal. The user should be able to control the gain of the amplifier from a minimum to a maximum in 100 increments. The minimum number of bits required to encode, in straight binary is,
8
6
5
7

⇒ The number of registers and flags in 8086 are
13 and 5 respectively
9 and 5 respectively
13 and 9 respectively
9 and 9 respectively

⇒

Assertion (A): A demultiplexer can be used as a decoder.

Reason (R): A demultiplexer can be built by using AND gates only.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ In the graphical analysis of CE amplifier circuit, the upper end of load line is called
saturation point
cut off point
Q point
none of the above

⇒ PCM : Quantising Noise :: Transistor :
Partition noise
Shot noise
Whirl
No noise

⇒ Poynting vector is the rate of energy flow having
W/m²
W-m
kWh/s
W/m

⇒ The inductance of a single layer solenoid of 10 turns is 5 μH. Which one of the following is the correct value of inductance when the number of turns is 20 and the length is doubled.
10 μH
20 μH
40 μH
5 μH

⇒

Assertion (A): In a CRT, grid is kept at negative potential with respect to cathode.

Reason (R): The function of grid in an electronic tube is to control the number of electrons.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ If the oscillator output is modulated by audio frequencies upto 10 kHz, the frequency range occupied by the side bands will be
711.9 kHz to 712.1 kHz
702 kHz to 722 kHz
692 kHz to 732 kHz
71.2 kHz to 71.20 kHz

⇒ In a gate output is Low if and only if all inputs are High. The gate is
OR
AND
NOR
NAND

⇒ The resistivity of a semiconductor
increases as the temperature increases
decreases as the temperature increases
remains constant even when temperature varies
none of the above

⇒ In one's complement 8 bit representation 11111111 represents
0
0
1
-1

⇒ The response of D'Arsonval galvanometer is over damped if
D² > 4CJ
D² > 2CJ
D² < 4CJ
D² < 2CJ

⇒ In measurements using CRO, Lissajous patterns are used to
measure magnitude of peak voltage
measure frequency
measure impedance
measure current