Question is ⇒ The encapsulation of transistor is necessary for, Options are ⇒ (A) preventing radio interference, (B) preventing photo-emission effects, (C) avoiding loss of free electrons, (D) mechanical ruggedness, (E) , Leave your comments or Download question paper.

Question is ⇒ The encapsulation of transistor is necessary for, Options are ⇒ (A) preventing radio interference, (B) preventing photo-emission effects, (C) avoiding loss of free electrons, (D) mechanical ruggedness, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The encapsulation of transistor is necessary for
A.	preventing radio interference [Wrong Answer]
B.	preventing photo-emission effects [Wrong Answer]
C.	avoiding loss of free electrons [Wrong Answer]
D.	mechanical ruggedness [Correct Answer]
View Answer 3 -2 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In a transistor receiver, the use of FET as the first stage amplifier is likely to
improve selectivity of the receiver
improve the effectiveness of the AGC
reduce the effect of negative peak clipping
reduce the effect of noise at all frequencies

⇒

Match the following:

	List I		List II
A.	Interface	1.	A measure of rate of data transmission
B.	A bit	2.	A binary digit
C.	Band speed	3.	The common boundary between various sections and subsections
		4.	A/D converter

A-3, B-2, C-1
A-3, B-1, C-2
A-2, B-4, C-1
A-4, B-2, C-3

⇒

Match the following:

	List I (Laws of Boolean)		List II (Relation algebra)
A.	Distributive law	1.	x + x = x
B.	DeMorgans law	2.	x(y + z) = xy + xz
C.	Idempotent law	3.	(x) = x
D.	Involution law	4.	(x + y) = xy

A-1, B-2, C-3, D-4
A-2, B-4, C-1, D-3
A-3, B-4, C-1, D-2
A-4, B-1, C-2, D-3

⇒ In the circuit of figure the switch is open for a long time, At t = 0 the switch is closed. At t = 0⁺ the current supplied by batter
0.25
0.125
3.6 A
1.5 A

⇒ Some ADCs are

Parallel
Updown
Single slope
Dual slope
Successive approximation
Stair step

Out of above which ones do not use DAC?
1 only
1, 3, 4
1, 2, 3
1, 5, 6

⇒ To multiply a number by 8 in 8085 we have to use RAL instruction
once
twice
thrice
four times

⇒ An electric charge Q is placed in a dielectric medium which of the following quantities are independent of the dielectric constant ε of the medium
electric potential V and electric field intensity E
displacement density D and displacement φ
electric field intensity E and displacement φ
electric potential V and displacement φ

⇒ Pick the odd-one out
Hartley Oscillator
Colpitt oscillator
Clapp oscillator
Weinbridge oscillator

⇒ In orthogonal BFSK. the energy of information bearing term is :
the same as total transmitted energy
one half of total transmitted energy
one fourth of total transmitted energy
None

⇒ For the collector-feedback amplifier shown below the voltage gain A_v will be _________
-113.07
-103.07
-107.07
-93

⇒

Match the following:

	List I (DOS commands)		List II (Meaning)
A.	ATTRIB	1.	Displays all directories and subdirectories
B.	SCAN DISK	2.	Moves files to another director
C.	MOVE	3.	Checks the status of disc
D.	TREE	4.	Hides a file

A-1, B-2, C-3, D-4
A-3, B-4, C-2, D-1
A-2, B-3, C-4, D-1
A-4, B-3, C-2, D-1

⇒ For a logic fa
V_IH > V_0H > V_IL > V_0L
V_OH > V_IH > V_IL > V_0L
V_IH > V_OH > V_OL > V_IL
V_OH > V_IH > V_OL > V_IL

⇒ A conditionally stable system is stable for the value of gain between two critical values. It is unstable if
the gain is increased beyond upper critical value
the gain is decreased below lower critical value
both (a) and (b)
none of the above

⇒ The factors which govern fan out of CMOS gates are
maximum permissible propagation delay
input capacitance of each load
both (a) and (b)
neither (a) nor (b)

⇒ Which one of the following theorem can be conveniently used to calculate the power consumed by the 10 Ω resistor in the network shown in the above fig
Thevenin's theorem
Maximum power transfer theorem
Millman's theorem
Superposition theorem

⇒ ECL can be used to high frequencies in the order of
500 kHz
1 MHz
100 MHz
500 MHz

⇒ A digital system is required to amplify a binary encoded audio signal. The user should be able to control the gain of the amplifier from a minimum to a maximum in 100 increments. The minimum number of bits required to encode, in straight binary is,
8
6
5
7

⇒ For maximum output the width of air gap of audio head should be
equal to wavelength
half the wavelength
one quarter the wavelength
very small as compared to wavelength

⇒ Which one of the following statement is correct?
Satellite spacing is not affected by the bandwidth of the transmitting earth station
Beamwidth is independent of antenna size and frequency band used
The width of a beam in space is inversely proportional to the width of the transmitting antenna
Use of high-frequency bands permits less number of satellites to share the orbit

⇒ Which of the following ICs has only one NAND gate?
7410
7420
7430
7447

⇒ For underdamped second order systems the rise time is the time required for the response to rise from
0% to 100% of its final value
10% to 90% of its final value
5% to 95% of its final value
either (a) or (b)

⇒ In figure what is the base current if V_BE = 0
10 mA
9.3 mA
10 μA
9.3 μA

⇒ In telephone, the dial tone has a frequency of
5 Hz
15 Hz
33 Hz
233 Hz

⇒ A polyphase wattmeter basically consists of two wattmeters. The moving system of two wattmeters
are common
are separate
are generally common
are generally separate

⇒ For frequency up to 1650 kHz, the transmitting antenna is used a
parabolic dish
vertical antenna
yagi antenna
turnstile antenna

⇒ Hay bridge is suitable for measuring inductance of which one of the following inductors?
Having Q value less than 10
Having Q value greater than 10
Having any value of Q
Having phase angle of reactance very large

⇒ FM broadcast is used in
VHP range
UHF range
MF range
both VHP and UHF range

⇒

Assertion (A): KCL is dual of KVL.

Reason (R): Node is dual of mesh.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ Which of the following methods is used for solving differential equations numerically?
Runge-Kutta method
Gauss-elimination method
Newton-Raphson method
Any one of these

⇒ In a dual converter both converters work as rectifiers.
TRUE
FALSE