Question is ⇒ The elevation in boiling point of a solution is proportional to the __________ of the solution., Options are ⇒ (A) molal concentration, (B) reciprocal of the molal concentration, (C) normality, (D) molarity, (E) , Leave your comments or Download question paper.

Question is ⇒ The elevation in boiling point of a solution is proportional to the __________ of the solution., Options are ⇒ (A) molal concentration, (B) reciprocal of the molal concentration, (C) normality, (D) molarity, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The elevation in boiling point of a solution is proportional to the __________ of the solution.
A.	molal concentration [Correct Answer]
B.	reciprocal of the molal concentration [Wrong Answer]
C.	normality [Wrong Answer]
D.	molarity [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Enthalpy of formation of NH₃ is - 46 kJ/kg mole. The enthalpy change for the gaseous reaction, 2NH₃ → N₂ + 3H₂, is equal to __________ kJ/kg. mole.
46
92
-23
-92

⇒ The reaction A + B → C has been conducted in a reactor as shown bel
1
6
3
4

⇒ The vapor pressure of water at 100°C is
100N/m²
76 cms of Hg
13.6 cms of Hg
760 mm wc

⇒ Compressibility factor of a real gas is the ratio of the actual volume to that predicted by ideal gas law. As the pressure of the gas approaches zero, the compressibility factor approaches
∞
0
1
0.24

⇒ A fluid gas produced on burning furnace oil contains 0.15 gm mole of CO₂, 0.05 gm mole of oxygen and 0.80 gm mole of N₂. What is its molecular weight ?
28.6
30
30.6
32.6

⇒ Saturated solution of benzene in water is in equilibrium with a mixture of air and vapours of benzene and water at room temperature and pressure. Mole fraction of benzene in liquid is x_B and the vapour pressures of benzene and water at these conditions are p_v^B and p_v^w respectively. The partial pressure of benzene in air-vapour mixture is
P_v^B
x_B.P_v^B
(P_atm - P_v^w)x_B
x_B.P_atm

⇒ An equation for calculating vapour pressure is given by, log₁₀ P = A - B(t + c). This is called the
Kistyakowsky equation
Antonic equation
Kopp's rule
Trouton's rule

⇒ "The heat capacity of a solid compound is approximately equal to the sum of the heat capacities of the constituent elements." This is the statement of
Law of Petit and Dulong
Kopp's rule
Nearnst heat theorem
Trouton's rule

⇒ Osmotic pressure exerted by a solution prepared by dissolving one gram mole of a solute in 22.4 litres of a solvent at 0°C will be __________ atmosphere.
0.5
1
1.5
2

⇒ A sample of well water contains 140 gm/m³ Ca²⁺ ions and 345 gm/m³ Na⁺ions. The hardness of the sample of water, expressed in terms of equivalent CaCO₃ in gm/m³ is (assuming atomic masses of Ca :40, Na : 23, C : 12, O : 16)
350
485
140
345

⇒ 1 BTU/lb.^←°F is equivalent to __________ kcal/kg.°C.
1
2.42
1.987
4.97

⇒ In a chemical process, the recycle stream is purged for
increasing the product yield.
enriching the product.
limiting the inerts.
heat conservation.

⇒ The heat of vaporisation __________ with increase in pressure.
increases
decreases
becomes zero at critical pressure
both (b) and (c)

⇒ Volume percent for gases is equal to the
weight percent.
mole percent.
weight percent only for ideal gases.
mole percent only for ideal gases.

⇒ A perfectly insulated container of volume V is divided into two equal halves by a partition. One side is under vacuum, while the other side has one mole of an ideal gas (with constant heat capacity) at 298 K. If the partition is broken, the final temperature of the gas in the container
will be greater than 298 K.
will be 298 K.
will be less than 298 K.
can not be determined.

⇒ C_p is expressed in S.I. unit as
J/kg.°K
0°K
W/m². °C
W/m. °K

⇒ In osmosis through a semi-permeable membrane, diffusion of the
solvent is from low concentration to high concentration region.
solvent is from high concentration to low concentration region.
solute takes place.
none of these.

⇒ With increase in the solute concentration, the specific heat of aqueous solutions
increases
decreases
remains unchanged
either (a) or (b); depends on the type of solution

⇒ The effect of pressure on the heat capacity of the gases __________ is negligible.
at pressure below one atmosphere
below the critical temperature
both(a)&(b)
neither (a) nor (b)

⇒ The chemical nature of an element is independent of
its atomic number.
the number of protons or electrons present in it.
the number of neutrons present in it.
none of these.

⇒ On addition of 1 c.c. of dilute hydrochloric acid (1% concentration) to 80 c.c. of a buffer solution of pH = 4, the pH of the solution becomes
1
8
4
2

⇒ The weight fraction of methanol in an aqueous solution is 0.64. The mole fraction of methanol X_M satisfies
X_M < 0.5
X_M = 0.5
0.5 < X_M < 0.64
X_M ≥ 0.64

⇒ Gases having same reduced temperatures and reduced pressures
deviate from ideal gas behaviour to the same degree.
have nearly the same compressibility factor.
both (a) and (b).
neither (a) nor (b).

⇒ Which of the following is not a unit of length ?
Parsec
Angstrom
Barn
Fermi

⇒ For an endothermic reaction, the minimum value of energy of activation will be (where, ΔH = enthalpy of the reaction)
Δ H
>ΔH
<ΔH
0

⇒ Isotonic solutions must have the same
viscosity
molar concentration
normality
critical temperature

⇒ What is the total pressure exerted by a mixture of 0.45 kg mole of benzene, 0.44 kg mole of toluene and 0.23 kg mole of o-xylene at 100°C, if their vapor pressures at 100°C are 1340, 560 and 210 mmHg respectively ?
756.2
780.5
801.5
880.5

⇒ __________ fuels require the maximum percentage of 'excess air' for complete combustion.
Solid
Liquid
Gaseous
Nuclear

⇒ Pick out the wrong unit conversion of thermal conductivity.
1 BTU/ft².hr.°F/ft = 1.488 kcal/m². hr.°C/m
1 BTU/ft².hr.°F/inch = 1.488 kcal/m². hr.°C/m
1 kcal/m.hr.°C = 0.672 BTU/ft.hr.°F = 1.163 W/m. °K
1 W/cm.°C = 85.985 kcal/m.hr.°C = 57.779 BTU/ft.hr.°F

⇒ Othmer chart is useful in estimating the heat of
mixing
wetting
adsorption
none of these