Question is ⇒ The electrical energy required to heat a bucket of water to a certain temperature is 2 kWh. If heat losses, are 25%, the energy input is, Options are ⇒ (A) 2.67 kWh, (B) 3 kWh, (C) 2.5 kWh, (D) 3.5 kWh, (E) , Leave your comments or Download question paper.

Question is ⇒ The electrical energy required to heat a bucket of water to a certain temperature is 2 kWh. If heat losses, are 25%, the energy input is, Options are ⇒ (A) 2.67 kWh, (B) 3 kWh, (C) 2.5 kWh, (D) 3.5 kWh, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The electrical energy required to heat a bucket of water to a certain temperature is 2 kWh. If heat losses, are 25%, the energy input is
A.	2.67 kWh [Correct Answer]
B.	3 kWh [Wrong Answer]
C.	2.5 kWh [Wrong Answer]
D.	3.5 kWh [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A 3 phase induction motor is controlled by voltage and frequency control such that the ratio V/f is constant. At 50 Hz, the speed is 1440 rpm. At 25 Hz, the speed is likely to be
about 1350 rpm
about 720 rpm
about 360 rpm
either (b) or (c)

⇒ In ASCII, letter B is coded as
1000001
1000010
100100
1001000

⇒ In ALU 1C 74181 the addition and subtraction is in
2's complement
1's complement
binary
none of the above

⇒ In the circuit, S was initially open. At time t = 0, S is closed. When the current through the inductor is 6 A, the rate of change of current through the resistor is 6 A/s. The value of the inductor woul
1 H
2 H
3 H
4 H

⇒ When a P-N junction is unbiased, the junction current at equilibrium is
zero as no charges cross the junction
zero as equal number of carriers cross the barrier
mainly due to diffusion of majority carriers
mainly due to diffusion of minority carriers

⇒ The silicon sample with unit cross-sectional area shown below is in thermal equilibrium. The following information is given: T = 300 K, electronic charge = 1.6 x 10^-19C, thermal voltage = 26mV and electron mobility = 1350 cm²
2.16 x 10⁴ A/cm²
1.08 x 10⁴ A/cm²
4.32 x 10³ A/cm²
6.48 x 10² A/cm²

⇒ In the given figure the reflection coefficient at source en
1
-1
42738
-1/3

⇒ Due to the formation of Schottky defects the density of the crystal
increases slightly
increases appreciably
decreases slightly
decreases appreciably

⇒ The current gain of a bipolar transistor drops at high frequencies because of
transistor capacitance
high current effects in the base
parasitic inductive elements
the early effect

⇒ The number of spectral component when two cosine waves are multiplied of different frequency
1
2
8
4

⇒ In figure, I_D = 4 mA. Then V_{D20 V
10 V
30 V
1 V}

⇒ The terminals of a power MOSFET are called
emitter, base, collector
source, gate, drain
source, base, drain
emitter, gate, drain

⇒ The modulation index of an AM wave is measured using a CRO. The waveform is as shown in figure, the modulation index is nea
0.43
0.3
0.23
0.17

⇒ Watthour meter is an integrating instrument
TRUE
FALSE

⇒ The data about p the pull required to lift a weight wby a pulley bloc
3.2 + 0.171 w
2.28 + 0.1879 w
1.2 + 0.25 w
0.6 + 0.3 w

⇒

Assertion (A): When a photoconductive device is exposed to light, its bulk resistance increases.

Reason (R): When exposed to light, electron hole pairs are generated in the photoconductive device.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ The input to an op-amp integrating amplifier is a constant voltage. The output will be
a constant voltage
a sawtooth wave
a ramp
ac voltage

⇒ A string constant in basic is
a string of capital alphabets A to Z, included in question mark
a string of capital alphabets A to Z and digits 0 to 9 included in question mark
a string of capital alphabets A to Z, digits 0 to 9 and special characters
a string of capital alphabets A to Z, digits 0 to 9 and special characters included in question mark

⇒

Assertion (A): When a wattmeter is used for low impedance loads, the pressure coil is connected across the load.

Reason (R): A wattmeter measures apparent power.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ For the system in the given figure G varies slightly, the ratio of open loop sensitivity to closed loop sensitivit
1 : (1 + GH)
1 : (1 + GH)^-1
1 : (1 - GH)
1 : (1 - GH)^-1

⇒ A digital voltmeter has a read out range from 0 to 999 counts. If the full scale reading is 9.999 V, the resolution is
1 V
0.01 V
1 mV
1 μV

⇒ Consider the following operation in a computer

Multiplication of scalar
Iversion of matrix
Printing a line of 120 characters on a printer

Which of the above is a subroutine?
1 and 2 only
1 and 3 only
1, 2 and 3
2 only

⇒ Calculate the directivity of an antenna for θ_E = 30°, θ_H = 60
46
23
50
100

⇒ A pure tone at 1000 Hz has a dB level of 50 dB. If two such tones exist simultaneously the dB level is about
50 dB
53 dB
100 dB
200 dB

⇒ Which circuit is called emitter follower?
CC
CE
CB
Both (a) and (b)

⇒ Consider the following statement S₁ and S_{2S₁ is False, S₂ is true
S₁ and S₂ both are true
S₁ and S₂ both are false
S₁ is true, S₂ is false}

⇒ In a driving point function poles and zeros must be conjugate if complex or imaginary.
TRUE
FALSE

⇒ If 100 V is the peak voltage across the secondary of the transformer in a half-wave rectifier (without any filter circuit), then the maximum voltage on the reverse-biased diode is
200 V
141.4 V
100 V
86 V

⇒

Assertion (A): When reverse voltage across a p-n junction is increased, the junction capacitance decreases.

Reason (R): Capacitance of any layer is inversely proportional to thickness.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ A semiconverter feeding an RLE load operates in
first quadrant only
first and second quadrants
first and fourth quadrants
first and third quadrants