Question is ⇒ The effect of the inductance of a coil on a constant direct current is that, Options are ⇒ (A) it does not effect the constant direct current, (B) it decreases the current, (C) it strengthens the current, (D) it causes a higher voltage drop, (E) , Leave your comments or Download question paper.

Question is ⇒ The effect of the inductance of a coil on a constant direct current is that, Options are ⇒ (A) it does not effect the constant direct current, (B) it decreases the current, (C) it strengthens the current, (D) it causes a higher voltage drop, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The effect of the inductance of a coil on a constant direct current is that
A.	it does not effect the constant direct current [Correct Answer]
B.	it decreases the current [Wrong Answer]
C.	it strengthens the current [Wrong Answer]
D.	it causes a higher voltage drop [Wrong Answer]
View Answer 3 -2 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A 4 bit ripple counter uses flip flops with propagation delay of 50 ns each. The maximum clock frequency which can be used is
5 MHz
10 MHz
20 MHz
25 MHz

⇒

Assertion (A): FET has characteristics very similar to that of pentode.

Reason (R): Both FET and pentode are voltage controlled devices.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ Class C operation finds application in
RF power amplifiers
frequency multipliers
both (a) and (b)
neither (a) nor (b)

⇒ A 3 phase fully controlled converter is a
3 pulse converter
6 pulse converter
2 pulse converter
12 pulse converter

⇒ Which of the following is not advantage of FM over AM?
Noise immunity
Capture effect
Fidelity
Spluttering effect

⇒ If t_p is the pulse width, Δ_t is the propagation delay, T is period of pulse train then the following condition can avoid the race around condition
t_p = Δt = T
2t_p > Δt > T
t_p < Δt < T
t_p < Δt < T

⇒ The V-i relation for a varistor is
i = kvⁿ
v = kiⁿ
i = kv³
v = ki³

⇒ In 2's complement addition, the carry generated in the last stage is
added to LSB
neglected
added to bit next to MSB
added to the bit next to LSB

⇒ One of the major applications of JFET is in
switching
constant current-source
constant voltage-source
electron flow regulation

⇒ In the given figure shows a logic circuit. The minimum Boolean expression for this circui
A + B
A + B + C
AB + C
AB + AC + BC

⇒ In the network of figure, the voltage drops across R₁, R₂, R₃ are 6 V, 8 V and 12 V with polarities as shown. The value of R_{312 Ω
8 Ω
5 Ω
3 Ω}

⇒ For a given line voltage, four heating coils will produce maximum heat when connected
all in parallel
all in series
with two parallel pairs in series
one pair in parallel with the other two in series

⇒ If the switch is thrown to the START position, Q and Y will be equal to
Q = 0, Y = 0
Q= 1, Y= 1
Q = 1, Y = CLK
Q = 0, Y = CLK

⇒ In the basic series inverter circuit, the source current has
low harmonic content
high harmonic content
low or high harmonic content depending on firing angle
zero harmonic content

⇒ If F_n represents Fourier series coefficient of f(t), then Fourier series coefficient of f(t + t) =
F_ne ^-jω₀^t
F_ne ^jω₀^t
F_ne ^jnω₀^t
F_ne ^-jnω₀^t

⇒ If N = 196, the result of the following program will be 196
16
16
196

⇒ The parallel RLC circuit shown in figure is in resonance
I_R < 1 mA
| I_R + I_L | > 1 mA
| I_R + I_L | < 1 mA
| I_L + I_C | > 1 mA

⇒ If the target cross-section is changing, the best scanning system for accurate tracking is
lobe switching
monopulse
sequential lobing
conical scanning

⇒ What is the addressing mode used in instruction MOV M, C?
Direct
Indirect
Induced
Immediate

⇒ __________ will have the least value of relative permeability.
Palladium
Silver
Cobalt
Iron

⇒ The sensitivity curve of a standard receiver is represente
curve A
curve B
curve C
curve D

⇒ In a bipolar transistor at room temperature if the emitter current is doubled the voltage across its base emitter junction
doubles
halves
increase by about 20 mV
decrease by about 20 mV

⇒ Consider a silicon p-n junction at room temperature having the following paramet
0.15 MV.com^-1, directed from p-region to n-region
0.15 MV.com^-1, directed from n-region to p-region
1.80 MV.com^-1, directed from p-region to n-region
1.80 MV.com^-1, directed from n-region to p-region

⇒ When a p-n Junction is forward biased
the current flow is due to electrons only
the majority carriers in both p and n materials are driven toward the junction.
the majority carriers in both p and n materials are away from the junction.
both (a) and (c).

⇒ The voltage across the secondary of the transformer in a half wave rectifier with a shunt capacitor filter is 50 volts. The maximum voltage that will occur on the reverse biased diode will be
100 V
88 V
50 V
25 V

⇒ In a C expression using assignment operators, relational operators and arithmetic operators, the hierarchy of operations (in the absence of parenthesis) is
assignment, relational, arithmetic
relational, assignment, arithmetic
arithmetic, assignment, relational
arithmetic, relational, assignment

⇒ A coil of resistance R and inductance L is connected in series with 5 μF capacitor. The source frequency is equal to resonance frequency and circuit current is 0.5 A. Another 5 F capacitor is connected in parallel with the above capacitor. The circuit current will be
0.5 A
more than 0.5 A
less than 0.5 A
0.5 A or less

⇒ Which of the following statements defines a full adder?
It adds two binary digits and produces their SUM and CARRY
It adds three inputs (two binary digits and a carry) and produces their SUM and CARRY
It has two inputs and two outputs
None of the above

⇒ The power dissipation in a transistor is the product of
emitter current and emitter to base voltage
emitter current and collector to emitter voltage
collector current and collector to emitter voltage
none of the above

⇒ The resistivity of a semiconductor
increases as the temperature increases
decreases as the temperature increases
remains constant even when temperature varies
none of the above