Question is ⇒ The effect of adding poles and zeros can be determined quickly by, Options are ⇒ (A) Nichols chart, (B) Nyquist plot, (C) Bode plot, (D) Root locus, (E) , Leave your comments or Download question paper.

Question is ⇒ The effect of adding poles and zeros can be determined quickly by, Options are ⇒ (A) Nichols chart, (B) Nyquist plot, (C) Bode plot, (D) Root locus, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The effect of adding poles and zeros can be determined quickly by
A.	Nichols chart [Wrong Answer]
B.	Nyquist plot [Wrong Answer]
C.	Bode plot [Correct Answer]
D.	Root locus [Wrong Answer]
View Answer 2 -3 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The number of stator field windings in an ac tachometer are
1
2
3
4

⇒ An amplifier signal is made up of just two frequencies 1000 Hz. The output signal consists of 500 Hz and 25000 Hz frequencies. This may be attributed to
harmonic distortion
intermodulation distortion
both (a) and (b)
none of the above

⇒ A basic group B
consists of five super groups
has a frequency range of 60 to 108 kHz
consists of erect channels only
is formed at group translating equipment

⇒ Modulation system used for video-modulation in television broadcast is
SSB AM with carrier
SSB with carrier suppressed
DSB AM with carrier
a modified form of SSB with carrier called vestigial sideband

⇒ Some words like READ, WRITE, STOP etc. cannot be used as variable names in Fortran 77.
TRUE
FALSE

⇒ Which is known as flash converter?
Weighted resistor D/A converter
Parallel A/D converter
Stair step A/D converter
Up-down counter type A/D converter

⇒ When energy is fed into open wire transmission line the energy may get dissipated due to
radiation
conductor heating
dielectric heating
all of the above

⇒ Introducing a resistor in the emitter of a common amplifier stabilizes the d.c. operating point against variations in
only the temperature
only β of the transistor
both temperature and β
none of these

⇒ Bitter powder patterns prove the existence of domains.
TRUE
FALSE

⇒ An 8 level encoding scheme is used in a PCM system of 10 kHz channel BW. The channel capacity is
80 kbps
60 kbps
30 kbps
18 kbps

⇒ A JFET
is current controlled device
has low input resistance
has high gate current
is a voltage controlled device

⇒ Piezoelectric effect can be used to measure
force
strain
acceleration
all of the above

⇒ Some ceramic materials become superconducting
below liquid helium temperature
between liquid helium and liquid nitrogen temperature
above liquid nitrogen but below room temperature
at room temperature

⇒ A 16 x 8 ROM stores these words in its first four locations, as given below. Which of this represents 3 CH in hexadecimal?
R₀ = 1110 0010
R₁ = 0101 0111
R₂ = 0011 1100
R₃ = 1011 1111

⇒ The number of channels in a stereophonic system is
8
4
2
1

⇒ A 4 bit parallel type A/D converter uses a 6 volt reference. How many comparators are required and what is the resolution in volts?
0.375 V
15 V
4.5 V
10 V

⇒ Kirchoff's laws are applicable to
dc only
ac sinusoidal wave only
dc and ac sinusoidal waves
all wave shapes

⇒ In a two phase servomotor the two stator windings have a phase difference of
30°
45°
90°
135°

⇒ Hue of a colour means
amount of light energy received by eye
predominant spectral purity of colour light
amount of other colours present
none of the above

⇒

Assertion (A): For same drain current rating N-channel MOSFET occupies more area than p-channel MOSFET.

Reason (R): Electron mobility is much higher than hole mobility.

Both A and R are individually true and R is the correct explanation of A
Both A and R are individually true but R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ If a sequence is causal then ROC is (where a is any number)
|z| > a
|z| < a
|z| = a
Entire Plane

⇒

Assertion (A): The 'do while' statement is used less frequently than the 'while' statement.

Reason (R): For most applications it is more natural to test for continuation of loop at the beginning than at the end of loop.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ In FM signal with a modulation index m_f is passed through a frequency tripler. The wave in the output of the tripler will have a modulation index of
m_f
3m_f
m_f/3
m_f/9

⇒ In LIFO
only the top of the stack is immediately accessible
only the top of the stack is never accessible
only the first-in is accessible
only the first-in is not accessible

⇒ In a biased JFET (Figure) the shape of the channel is as shown bec
it is the property of material used
the drain end is more reverse biased than source end
drain end is more forward biased than source end
impurity profile changes with distance

⇒ Assuming accumulator contain A 64 and the carry is set (1). What will register A and carry (CY) contain after ORA A?
A 6 H, 1
A 6 H, 0
00 H, 0
00 H, 1

⇒ Consider the following statements about 8085

The instruction LDA uses direct addressing mode.
The instruction MVI uses direct addressing mode.
The instruction MVI uses immediate addressing mode.
The instruction LDA uses immediate addressing mode.

Which of the above are correct?
1 and 3 only
3 and 4 only
1 and 2 only
2 only

⇒ With four Boolean variables, how many Boolean expressions can be performed?
16
256
1024 (1 K)
64K (64 x 1024)

⇒ A total of 16 equally probable events exist. If it is required to select one out of them, the number of required bits is
2
4
3
5

⇒ Two resistance R₁ and R₂ are connected in series R₁ = 528 ± 5 Ω and R₂ = 325 ± 3Ω. The total resistance will be
853 ± 2 Ω
853 ± 5 Ω
853 ± 3 Ω
853 ± 8 Ω