Question is ⇒ The duty cycle of a radar transmitter is equal to, Options are ⇒ (A) (PRF) (pulse width), (B) (PRF)/(pulse width), (C) (pulse width)/(PRF), (D) (pulse width) + (PRF), (E) , Leave your comments or Download question paper.


Q1.	The duty cycle of a radar transmitter is equal to
A.	(PRF) (pulse width) [Correct Answer]
B.	(PRF)/(pulse width) [Wrong Answer]
C.	(pulse width)/(PRF) [Wrong Answer]
D.	(pulse width) + (PRF) [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The circuit of the given figur
full adder
magnitude comparator
parity detector
none of the above

⇒ It is desired to route data from many registers to one register. The device needed is
decoder
multiplexer
demultiplexer
counter

⇒ Insertion of a dielectric material between the plates of an air capacitor
increases the capacitance
decreases capacitance
has no effect an capacitance
increases breakdown voltage

⇒ Which of the following cannot be used to demodulate SSB?
Complete phase-shift generator
Product detector
Diode balanced modulator
Bipolar transistor balanced modulator

⇒ Two voltages are 50 ∠0 V and 75 ∠ - 60° V. The sum of these voltages is
109 ∠ - 60° V
109 ∠ - 25° V
109 ∠ - 36.6° V
100 ∠ - 50.1° V

⇒ Troposphere is the portion of atmosphere
nearest to ground
between 50 to 90 km above ground
between 110 to 220 km above ground
between 250 to 350 km above ground

⇒ The cut off wavelength in circular waveguide
guide diameter
square of guide diameter
cube of guide diameter
square root of guide diameter

⇒ A thyristor has its gate current zero. To start conduction the forward voltage must exceed
about 0.5 V
forward breakover voltage
on state voltage
peak working off state forward voltage

⇒ Ohmic range of metal film resistors is
1 to 100 ohms
10 to 1 K ohms
100 to 1 M ohms
100 to 100 M ohms

⇒

Assertion (A): Cut-in voltage for Germanium diode is greater than that for silicon diode.

Reason (R): Germanium diode has a higher reverse saturation current than silicon diode.

Both A and R are individually true and R is the correct explanation of A
Both A and R are individually true but R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ In a class C power amplifier
resonant frequency of tuned circuit is equal to fundamental frequency of pulsed waveform
resonant frequency of tuned circuit is half the fundamental frequency of pulsed waveform
resonant frequency of tuned circuit has no relation to the fundamental frequency of pulsed waveform
either (b) or (c)

⇒ The Thevenin Resistance of the circui
94/7 kΩ
54/7 kΩ
7/54 kΩ
0

⇒ A generator with an internal resistance of 600 Ω drives an amplifier whose input resistance is 400 Ω. The generator's open circuit voltages is 1 mV; the amplifier develops 100mV across an 8kΩ load. The input voltage to the amplifier is
0.1 m V
0.4 m V
1 m V
4 m V

⇒ The pole-zero configuration of the given figure can be
lag compensator
lead compensator
lead-lag compensator
series compensator

⇒ A D.C. amplifier amplify
D.C. only
A.C. only
both A.C. and D.C.
none of the above.

⇒ The main use of JFET with a
frequency mixer
source follower
voltage doubler
trigger

⇒ Which of the following modulation is analog in nature?
PCM
DPCM
DM
PDM

⇒ IC 74181 performs arithmetic operations when M = 1.
TRUE
FALSE

⇒

Assertion (A): The horizontal intercept of dc load line is the same as ideal cut off point

Reason (R): When a transistor is in cut off region, collector current is zero

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ In a radio receiver, if the intermediate frequency is too high
Selectivity will be poor
Tracking difficulties will be least
Adjacent channel rejection will improve
All of the above will occur

⇒ Typical value of reverse current in a semiconductor diode is
0.0416666666666667
0.1 A
1 μA
0.1 μA

⇒ End fire array has narrow bandwidth.
TRUE
FALSE

⇒

Match the following:

	List I (Component)		List II (Dominant TE mode)
A.	Rectangular wave guide	1.	TE₁₀₁
B.	Circular waveguide	2.	TE₁₀
C.	Rectangular cavity	3.	TE₁₁₁
		4.	TE₁₁

A-4, B-2, C-1
A-2, B-1, C-3
A-3, B-4, C-1
A-2, B-3, C-1

⇒ Self bias is an example of __________ feedback that tends to stabilize the drain current against changes in temperature and JFET replacement.
variable
low
negative
positive

⇒ A two branch parallel circuit has a 10 Ω resistance and 0.5 H inductance in one branch and a 100 μF capacitor in the second branch. It is fed from 100 V ac supply. At resonance, the source current is
0.416666666666667
0.0416666666666667
0.2 A
0.05 A

⇒ A Darlington pair is used for
low distortion
high frequency range
high power gain
high current gain

⇒

Assertion (A): Nyquist stability criterion uses the number of encirclements around (-1 + j0) point in GH plane to determine stability

Reason (R): The (-1 + j0) point in the s plane lies in the Nyquist path.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ If the peak value of output of a half wave rectifier is 100 V, the rms value is
100 V
50 V
70.7 V
35.35 V

⇒ The gauge factor of a semiconductor strain gauge is about
2
10
100
1000

⇒ A meter having 0-1000 μA range and 1000 Ω resistance is required to be changed to 0-100 mA meter. The value of shunt resistance is about
1 Ω
10 Ω
99 Ω
100 Ω