Question is ⇒ The dual of a link is, Options are ⇒ (A) twig, (B) node, (C) loop, (D) tree branch, (E) , Leave your comments or Download question paper.

Question is ⇒ The dual of a link is, Options are ⇒ (A) twig, (B) node, (C) loop, (D) tree branch, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The dual of a link is
A.	twig [Wrong Answer]
B.	node [Wrong Answer]
C.	loop [Wrong Answer]
D.	tree branch [Correct Answer]
View Answer 1 -2 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ When a current flows through a conductor,
an electric field exists at all points within the conductor
electric field exists only at all points on the surface of the conductor
electric field exists only at ends of the conductor
any of the above depending on magnitude of current

⇒ The gradient of any scalar field always yields __________ .
a solenoidal field
a conservative field
an irrotational field
none of these

⇒ A wave is propagated in a waveguide at frequency of 9 GHz and separation is 2 cm between walls Calculate group velocity for dominant mode.
1.8 x 10⁸ m/sec
5 x 10⁸ m/sec
3 x 10⁸ m/sec
1.5 x 10⁸ m/sec

⇒ An average responding rectifier type electronic voltmeter has its scale calibrated in terms of rms value of sine wave. If 100 V peak value square wave is fed to this voltmeter, the reading will be
111 V
100 V
90.9 V
70.7 V

⇒ In floating point representation, the accuracy is
10 bit
9 bit
8 bit
6 bit

⇒ Resistivity of rubber is about
10² Ω-m
10^-2 Ω-m
5 x 10⁸ Ω m
5 x 10¹² Ω-m

⇒ The gain of a current element is
0 dB
1.67 dB
1.76 dB
3 dB

⇒ For matching over a range of frequencies in a transmission line it is best to use
a balun
a broad band directional coupler
double stub
a single stub of adjustable position

⇒ A 20 Ω resistor, a 1H inductor and 1μF capacitor are connected in parallel the combination is driven by a unit step current. Under the steady state, source current flows through
inductor
capacitor
resistor
all

⇒ The hexadecimal number 64 AC is equivalent to decimal number
25727
25722
25772
25777

⇒ The curve representing Ohm's law is
linear
a parabola
a hyperbola
sine function

⇒ Which of the following has the highest input impedance?
CE
CB
CC
Push pull

⇒ In a microprocessor, the service routine for a certain interrupt starts from a fixed location of memory which cannot be externally set, but the interrupt can be delayed or rejected. Such an interrupt is
non-maskable and non-vectored
maskable and non-vectored
non-maskable and non-vectored
maskable and vectored

⇒ In FORTRAN 77 FLOAT (-28) gives the value
28
-28
-28
none of the above

⇒ Ferroelectric materials are those which
cannot be polarized
have a permanent polarization
have a_e equal to zero
have μ_p = 0

⇒ Data from a satellite is received in serial form (1 bit after another). If this data is coming at a 5 MHz rate and if the clock frequency is 5 MHz how long will it take to serially load a word in a 32-bit shift register?
1.6ms
3.2ms
6.4ms
12.8ms

⇒ If a driving point function N(s) = p(s)/q(s), then
the terms of lowest degree in p(s) and q(s) may differ in degree by zero only
the terms of lowest degree in p(s) and q(s) may differ by one at the most
the terms of lowest degree in p(s) and q(s) may differ in degree by two at the most
the terms of lowest degree in p(s) and q(s) may differ in degree by three at the most

⇒ A material for permanent magnet should have
High retentivity
High permeability
Low hysteresis loss
High hysteresis loss

⇒ The current through common emitter resistor of a differential amplifier is called
differential current
emitter current
ground current
tail current

⇒ A CT is used to feed current coils of wattmeter, energy meter, power factor meter and an ammeter. Then
all the coils are in series
all coils are in parallel
the coils are in series-parallel
either (a) or (b)

⇒

Match the following:

	List I (Operator in C)		List II (Priority of Operation)
A.	!	1.	1
B.	< >	2.	2
C.	∗	3.	3
D.	=	4.	4

A-1, B-2, C-3, D-4
A-1, B-3, C-2, D-4
A-4, B-3, C-2, D-1
A-3, B-2, C-1, D-4

⇒

Assertion (A): Charge is dual of flux.

Reason (R): Short circuit is dual of open circuit.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ Which of the following is present in both TRF receiver and superheterodyne receiver?
Detector
Mixer
IF amplifier
Local oscillator

⇒ When .4546 E 5 and .5433 E 7 are to be added in normalized floating point mode
none of the numbers is changed to any other form
.4546 E 5 is changed .004546 E 7 and .5433 E 7 is not changed
.5433 E 7 is changed to 54.33 E 5 and .4546 E 5 is not changed
both the numbers are changed and their exponents are made equal to 6

⇒ When the channel is noisy, producing a conditional probability of error p = 0.5; the channel capacity and entropy function would be, respectively,
1 and 1
1 and 0.5
0.5 and 1
0 and 1

⇒ Eddy current loss is proportional to
f and B²_m
f² and B²_m
f² and B_m
f and B_m

⇒ An FM signal with a deviation is passes through the mixer, and has its frequency reduced five fold. The deviation in the output of the mixer is
Δ
5Δ
Δ/5
indeterminant

⇒ A narrow band FM does not have the following feature
it has two sidebands
both sideband equal in magnitude
both sideband have same Phase Difference
it does not show Amplitude variation

⇒ Which of the following is very useful as multiband HF receiving antenna?
Square loop
Conical horn
Folded dipole
Log-periodic

⇒ If a small amount of Cu is added to Ni conductor, then
resistivity of Ni will decrease at all temperatures because Cu is a better conductor than Ni
residual resistivity of Ni at low temperature will increase as Cu atoms act as defect centres
resistivity of Ni will increase at all temperatures as Cu destroys the periodicity of Ni and acts as defects
resistivity of Ni remains the same