Question is ⇒ The drift velocity of electrons is, Options are ⇒ (A) very small as compared to speed of light, (B) equal to speed of light, (C) almost equal to speed of light, (D) half the speed of light, (E) , Leave your comments or Download question paper.

Question is ⇒ The drift velocity of electrons is, Options are ⇒ (A) very small as compared to speed of light, (B) equal to speed of light, (C) almost equal to speed of light, (D) half the speed of light, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The drift velocity of electrons is
A.	very small as compared to speed of light [Correct Answer]
B.	equal to speed of light [Wrong Answer]
C.	almost equal to speed of light [Wrong Answer]
D.	half the speed of light [Wrong Answer]
View Answer 1 -2 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ For the network shown below, if V_D = 12 V and V_GSQ = - 2 V value of R_S wil
13.35 kΩ
3.35 kΩ
33.31 kΩ
3.95 kΩ

⇒ The discone antenna is
used in UHF range
circularly polarized
used in radar
used as a direction finding antenna

⇒ In a certain '12 channel TDM' system it is found that channel no. 3 and channel no. 8 are connected to the same input signal. This technique
wastes the channel capacity
takes care of different sampling rate
is required when different bandwidth signals are to be transmitted
reduces noise

⇒ The current I_CBO
increases with increases in temperature
is normally greater for silicon transistor than germanium transistors
mainly depends on the emitter base junction bias
depends largely on the emitter doping

⇒ The frequency range of 300 kHz to 3000 kHz is known as
low frequency
medium frequency
high frequency
very high frequency

⇒ Figure repres
Integrator
Differentiator
High Pass Filter
Band Pass Filter

⇒ For parallel plane waveguides, which is the mode with lowest cut-off frequency?
TE₁₀
TM₁₀
TEM
TE₁₁

⇒ At 0 K the forbidden energy gap in intrinsic semi conductor is about
10 eV
6 eV
1 eV
0.2 eV

⇒ A uniform plane wave in the free space is normally incident on an infinitely thick dielectric slab (dielectric constant ε_r = 9). The magnitude of the reflection coefficient is
0
0.3
0.5
0.8

⇒ A periodic voltage v(t) = 1 + 4 sin ωt + 2 cos ωt is applied across a 1 ohm resistance. The power dissipated is
1 W
11 W
21 W
24.5 W

⇒ The input impedance for folded dipole antenna (two half dipole) is
73 n²
377 n²
73 n
377 n

⇒ In AM, the modulation envelope has a peak value double the unmodulated carrier level, when the modulation is
0.25
0.33
0.5
1

⇒

Match the following:

	List I		List II
A.	Direct addressing	1.	MOV A, M
B.	Register addressing	2.	MOV C, A
C.	Register indirect addressing	3.	LDA 7
D.	Immediate addressing	4.	STA FFC

A-1, B-2, C-3, D-4
A-4, B-2, C-1, D-3
A-2, B-3, C-4, D-1
A-3, B-2, C-1, D-4

⇒ When the length of antenna is a whole wavelength
the radiation at right angles is zero
the radiation at right angles is maximum
the radiation is zero in all directions
the radiation is maximum in all directions

⇒ AGC voltage is applied to the stages which are
before the detector stage
after the detector stage
either before or after the detector stage
none of the above

⇒ Plug and play is a hardware specification.
TRUE
FALSE

⇒ In a single phase power factor meter the phase difference between currents in the two pressure coils is
exactly 0°
approximate 0°
exactly 90°
approximate 90°

⇒ Consider the following statements about Infix and Post fix notations in Pascal

In Infix notation operators appear between the operands on which they operate.
In Post fix notation operators appear after the operand.
The Infix expression A + B - C + D will appear as AB + C - D + in post fix notation.

Which of the above are correct?
All
1 and 2 only
1 and 3 only
2 and 3 only

⇒ Waveform shown in figure is that
FM
PCM
AM-DSB
AM-SSB

⇒ Which of the following is a vector quantity?
Standing wave ratio
Reflection coefficient
Gain
All of the above

⇒ A signal m(t) amplitude modulates a carrier A_c cos ω_ct. The final signal will be
[A_c m(t)] cos ω_ct]
A_c . [1 + m(t)] cos ω_ct
A_c + [m(t)] cos ω_ct
A_c cos ω_ct + m(t)

⇒ A half wave diode rectifier uses a diode having forward resistance of 50 ohms. The load resistance is also 50 ohms. Then the voltage regulation is
0.2
0.5
1
2

⇒

Assertion (A): Fourier series can also be written in exponential form.

Reason (R): sin (n ωt) and cos (n ωt) can be expressed as sum or difference of exponentials.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ An engineer designs an amplifier to have a voltage gain of 60, but when constructed it only had a gain of 50. What percentage of feedback will cause oscillations?
0.001
0.005
0.01
0.02

⇒ Which of the following conditional statements is not valid in Pascal?
If A > = B then B : = C + D + X
If (N = 45) THEN X : = X + 2 ELSEX : = 0
If A < = B then A : = C * D
If (A > = B) X : Y else X : = Z

⇒ The beam of a radar should be
very narrow
very wide
neither too narrow nor very wide
either (b) or (c)

⇒ A dynamometer wattmeter can be used for
dc only
ac only
dc and 50 Hz ac
dc and high frequency ac

⇒ In the epitaxial diffused method of fabricating integrating circuits the process involved are __________

Epitaxial growth
Diffusion
Silicon diode growth
Vacuum evaporation of aluminium
Photoetching

The correct order is
1 - 2 - 3 - 4 - 5
1 - 3 - 5 - 2 - 4
3 - 1 - 4 - 5 - 2
1 - 3 - 2 - 4 - 5

⇒ Which one of the following is not a characteristic of a ferroelectric material?
High dielectric constant
No hysteresis
Ferroelectric characteristic only above the curie point
Electric dipole moment

⇒ PAM stands for
Pulse Analogue Modulation
Phase Analogue Modulation
Pulse Amplitude Modulation
Phase Amplitude Modulation