Question is ⇒ The divergence of the electric field intensity at any point equals, Options are ⇒ (A) 1/4 pε0 times the volume charge density, (B) l/ε0 times the volume charge density at that point, (C) ε0 times the volume charge density at that point, (D) the volume charge density at that point, (E) , Leave your comments or Download question paper.

Question is ⇒ The divergence of the electric field intensity at any point equals, Options are ⇒ (A) 1/4 pε0 times the volume charge density, (B) l/ε0 times the volume charge density at that point, (C) ε0 times the volume charge density at that point, (D) the volume charge density at that point, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The divergence of the electric field intensity at any point equals
A.	1/4 pε₀ times the volume charge density [Wrong Answer]
B.	l/ε₀ times the volume charge density at that point [Correct Answer]
C.	ε₀ times the volume charge density at that point [Wrong Answer]
D.	the volume charge density at that point [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Data are recorded on a 2, 400 ft reel of magnetic tape at a density of 556 characters per inch. If the record length is of 100 characters and 0.75 inch of record gap, the tape utilization factor is
0.85
0.67
0.19
0.08

⇒ For 0 < M < 1, the centres of M circle lie to the right of origin.
TRUE
FALSE

⇒

Assertion (A): Klystron amplifiers use one or more intermediate cavities in addition to buncher and catcher cavity.

Reason (R): When one or more intermediate cavities are used the bandwidth can be increased.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The parameter h₁₁ for CB circuit is higher than that for CE circuit.
TRUE
FALSE

⇒ The circuit of figur
Precision integrator
Hartley oscillator
Butterworth high pass filter
Wien bridge oscillator

⇒ In a modem digital computer, a subtractor in normally not used because
subtractors are very expensive
the design of a subtractor is very complex
the adder is geared for doing subtraction
most of the programs do not require subtraction

⇒ Skin effect is more pronounced at high frequencies.
TRUE
FALSE

⇒ In a thyristor the gate current is increased, then
anode current will increase
anode current will decrease
anode current will remain constant
anode current may increase or decrease

⇒ Which connection is rarely used?
CE
CB
CC
Both (a) and (b)

⇒ ROC of sequence x[n] = (3)ⁿ ∪[n] + (4)ⁿ ∪[- n - 1]
|z| > 4
3 < |z| < 4
|z| < 4
|z| > 3

⇒ Unlimited number of ICs 7490, 78492 and 7493 are available. Which of these could be used to build the dividse-by-60 circuit of fi
7490
7492
combination of 7490 and 7492
combination of 7492 and 7493

⇒ A wire has a diameter d and resistance R. If the diameter is made 3d, the length and material remaining the same, the new value of resistance will be
R/3
3 R
R/9
9 R

⇒ If μ_n is mobility of free electron and μ_p is mobility of holes then for silicon at 300 K
μ_n = μ_p
μ_n > μ_p
μ_n < μ_p
μ_n may be more or less than μ_p

⇒ The counter in the given figur
Mod 3
Mod 6
Mod 8
Mod 7

⇒ TTL is used in electronic calculators.
TRUE
FALSE

⇒ The circuit shown in figure
oscillate at 456 kHz
oscillate at 228 kHz
oscillate at microwave frequency
not oscillate

⇒ A single phase half wave rectifier is feeding a resistive load. As firing angle is increased
dc output voltage and rms output voltage decrease in the same proportion
dc output voltage and rms output voltage decrease
dc output voltage and rms output voltage increase
dc output voltage and rms output voltage increase in the same proportion

⇒ If the transfer function has zeros only on jω axis or in left half plane, it is a minimum phase function.
TRUE
FALSE

⇒

Match the following:

	List I (Instrument)		List II (Measured quantity)
A.	Hot wire	1.	only voltage
B.	PMMC	2.	phase
C.	Electrostatic	3.	true RMS value
D.	Lock in Amplifier	4.	dc value

A-3, B-2, C-1, D-4
A-1, B-4, C-2, D-3
A-3, B-4, C-1, D-2
A-2, B-3, C-4, D-1

⇒ A circular waveguide carries TE₁₁ mode whose radial electric-field is given
10 cm
3p cm
2p cm
8 cm

⇒ Is the interrupt-enable flag?
Low
High
Never
None

⇒ A crystal is frequently used in digital circuits for timing purpose because of its
low cost
high frequency stability
simple circuitry
ability to set frequency at desired value

⇒ The simplest method of suppression of unwanted side band in AM is
filter method
phase shift method
third method
both (a) and (b)

⇒ Which binary addition is incorrect?
1001.1 + 1011.01 = 10100.11
100010 + 1000101 = 1001010
0.0011 + 0.1110 = 1.1
1011.01 + 1001.11 = 10111

⇒ Which of the following diode is designed to operate in the breakdown region?
Signal diode
Power diode
Zener diode
None of the above

⇒ A rectangular waveguide has a discontinuity in the form of reduced narrow dimension. In the equivalent circuit this discontinuity can be represented by
a shunt capacitance at the discontinuity
a shunt inductance at the discontinuity
a shunt resistance at the discontinuity
none of the above

⇒ Sound wave travels as
longitudinal waves
transverse waves
both longitudinal and transverse waves
either longitudinal or transverse wave

⇒ For global communication, the number of satellites needed is
1
3
10
5

⇒ In a uniform plane wave E and H are related by
E/H = 1
E/H = ε/μ
E/H = μ/ε
none of the above

⇒ In FORTRAN 77 IFIX (-73.2) gives the value
73
-73
-7
-73.2