Question is ⇒ The disturbance from adjacent telephone line is known as, Options are ⇒ (A) cross fire, (B) cross talk, (C) inductive disturbance, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ The disturbance from adjacent telephone line is known as, Options are ⇒ (A) cross fire, (B) cross talk, (C) inductive disturbance, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The disturbance from adjacent telephone line is known as
A.	cross fire [Wrong Answer]
B.	cross talk [Correct Answer]
C.	inductive disturbance [Wrong Answer]
D.	none of the above [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The width of a radio beam from a 1 m diameter parabolic antenna at 10 GHz is about
100°
50°
5°
1°

⇒ A capacitor whose capacitance C_t = C₀ (1- cos ωt) is fed by a sinusoidal voltage v = V₀ sin ωt. The equation for current i is
ω C₀V₀ cos ωt
ω C₀V₀ sin ωt
ω C₀V₀ (cos ωt - cos² ωt)
none of the above

⇒ In a 100 turn coil, if the flux through each turn is (t³ - 2t)mW_b, the magnitude of the induced emf in the coil at a time of 4 sec is
46 mV
56 mV
4.6 V
5.6 V

⇒ For the given truth table, the correct Boolean expressio
XYZ + X YZ + X Y Z
X Y Z + XYZ + X YZ
X Y Z + XYZ + XY Z
XYZ + XYZ + XY Z

⇒ A tachometer has a sensitivity of 4 V/1000 rpm. Express the gain constant of the tachometer in the units volts/(rad/sec).
0.0489
0.0381
2
none of these

⇒ In following figure find V_GG by assuming gate current is negligible for the p-channel JFET. (if I_DQ = - 6 mA, R_S = 0, V_DD = -18 V, R_D = 2 kΩ, I_DSS = - 10 mA, I_PO = - 3 V)
0.67 V
6.7 V
7 V
0.3 V

⇒ In a low level AM system, the amplifier which follows the modulated stage must be the
linear device
harmonic device
class C amplifier
non-linear device

⇒ Which configuration is suitable for impedance matching?
CB
CE
CC
CB and CE

⇒ Directivity and beamwidth is related as
D ∝ B
D ∝ 1/B
D ∝ B
D ∝ B²

⇒ In the analysis of common emitter amplifier we may neglect
h_re
h_oe
h_fe
h_ie

⇒ The output voltage waveform of a CE amplifier is fed to a dc coupled CRO. The trace on the screen will be
dc output voltage
ac output voltage
sum of dc and ac output voltage
either (a) or (b)

⇒ With negative feedback the closed loop gain is always less than open loop gain.
TRUE
FALSE

⇒ A gate function which occurs at t = t₀ and lasts for duration T can be written as
u (t - t₀ - T)
u(t - t₀) = u(t - t₀ - T)
u(t - t₀) - u(t - t₀ - T)
u(t - t₀) - u(t - t₀ + T)

⇒ A copper specimen has resistivity equal to 1.8 x 10^-8 ohm-m at room temperature. At a temperature of 700 K, the resistivity is likely to be
1.6 x 10^-8 Ω-m
2 x 10^-8 Ω-m
3 x 10^-8 Ω-m
6 x 10^-8 Ω-m

⇒ Out of 5 M x 8, 1 M x 16, 2 M x 16 and 3M x 8 memories, which memory can store more bits?
5 M x 8
2 M x 16
3 M x 8
1 M x 16

⇒ In what condition does BJT act like an open switch
cut off
saturation
active
both (b) and (c)

⇒ Which of the following is not valid in case of bipolars?
It has a low input impedance
It has high voltage gain
It is a current controlled device
It is difficult to bias

⇒ Which of the following directives in 8085 causes two bytes to be reserved in the memory?
D S
D B
D W
E Q U

⇒ If A = 3 + j1, A⁴ =
3.16 ∠18.4°
100 ∠73.72°
100 ∠18.4°
3.16 ∠73.22°

⇒ Magnetic effect of current is used in
ammeters
voltmeters
wattmeters
ammeters, voltmeters, wattmeters and energy meters

⇒ In the circuit of figure, PIV can be u
E_m
2 E_m
0.5 E_m
2 E_m

⇒ A system has 12 poles or 2 zeros. Its high frequency asymptote in its magnitude plot has slope of
-200 dB/decade
-240 dB/decade
-280 dB/decade
-320 dB/decade

⇒ At absolute zero temperature a semiconductor behaves like
an insulator
a super conductor
a good conductor
a variable resistor

⇒ In 8085 microprocessor, in order to enable INTR interrupt, which of the following instruction are needed?
EI only
SIM only
El and SIM both
None

⇒ Which of the following waves do not exist in waveguides?
TE waves
TM waves
TE and TM waves
TEM waves

⇒ Find the power absorbed or delivered by each sou
a = -32 b = - 12 c = -80 d = -60
a = -32 b = - 12 c = 80 d = 60
a = 32 b = 12 c = -80 d = 60
a = -32 b = 12 c = 80 d = -60

⇒ A counter has 4 flip flops. It divides the input frequency by
4
2
8
16

⇒ A resistance strain gauge has a resistance of about
100 Ω
25 Ω
10 Ω
1 Ω

⇒ Ohmic range of carbon composition resistors is
10 to 100 ohms
10 to 10 K ohms
10 to 200 ohms
10 to 25 M ohms

⇒

Assertion (A): A resistor is a passive load and a transistor is an active load

Reason (R): Op-amp is mostly used in feedback mode

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct