Question is ⇒ The direction of rotation of a CD is, Options are ⇒ (A) clockwise, (B) anticlockwise, (C) clockwise or anticlockwise depending on frequency of data stored, (D) mostly anticlockwise but some times clockwise, (E) , Leave your comments or Download question paper.

Question is ⇒ The direction of rotation of a CD is, Options are ⇒ (A) clockwise, (B) anticlockwise, (C) clockwise or anticlockwise depending on frequency of data stored, (D) mostly anticlockwise but some times clockwise, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The direction of rotation of a CD is
A.	clockwise [Wrong Answer]
B.	anticlockwise [Correct Answer]
C.	clockwise or anticlockwise depending on frequency of data stored [Wrong Answer]
D.	mostly anticlockwise but some times clockwise [Wrong Answer]
View Answer 3 -2 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In an impedance smith chart, a clockwise movement along a constant resistance circle gives rise to
decrease in the value of reactance
an increase in the value of reactance
no change in the reactance value
no change in the impedance value

⇒ Forbidden energy gap in germanium at 0 K is about
10 eV
5 eV
2 eV
0.78 eV

⇒ A 12-bit binary counter has the following state. The octal number represente
677
7163
7128
7183

⇒ The circuit in the given figur
low pass filter
high pass filter
band Pass filter
band reject filter

⇒ A nibble corresponds to
2 successive bits of data
4 successive bits of data
8 successive bits of data
16 successive bits of data

⇒ A single turn loop is situated in air, with a uniform magnetic field normal to its plane. The area of the loop is 5 m² and the rate of change of flux density is 2 Wb/m²/s. What is the emf appearing at the terminals of the loop?
-5 V
-2 V
-0.4 V
0 V

⇒ For a transfer function the coefficients of the numerator and denominator polynomials in s must be real.
TRUE
FALSE

⇒

Assertion (A): The circuit in figure produces repetitive narrow pulses when input is fed with sine or triangular waveform having peak value more than + V

Reason (R): The high gain op-amp produces voltages at two levels. If input is more than + V, the output is + 15 V otherwise the output is - 1
Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ For resonant long wire antenna 'n' half wavelength long in free space, if 'n' is increased then inclination of the major lobe with wire axis will __________ .
increases
decreases
remains same
none

⇒ The purpose of series quadrature windings in amplidyne is to
neutralize the effect of armature reaction
reduce commutation difficulties
increase the gain
increase response time

⇒ Find V_x V_y V_{zV_x = -6 V_y = 3 V_z = -3
V_x = -6 V_y = -3 V_z = 1
V_x = 6 V_y = 3 V_z = 3
V_x = 6 V_y = 1 V_z = 3}

⇒ On which bands, do the optical fibers operate?

Select the correct answer from the codes given below:
1 only
1 and 2 only
1, 2 and only
1, 3 and 4

⇒ A better SNR can be obtained in a PCM by
increasing sampling rate above Nyquist rate
decreasing the code bits
reducing channel bandwidth
increasing Quantization levels

⇒ If x^k = a^k and k &g
TRUE
FALSE

⇒ An amplifier has open loop gain of 100, input impedance 1 kΩ and output impedance 100 Ω. If negative feedback with β = 0.99 is used, the new input and output impedances are
10 Ω and 1 Ω
10 Ω and 10 kΩ
100 kΩ and 1 Ω
100 kΩ and 10 Ω

⇒ All network theorems of dc are applicable to ac also with different quantities taken as phasors.
TRUE
FALSE

⇒ In a positive edge triggered JK flip flop, J = 1, K = 0 and clock pulse is rising Q will
be 0
be 1
show no change
toggle

⇒ Degaussing in a picture tube means
Adding magnetism in mask and mounting frame
Removing residual magnetism in mask, shield etc...
Increasing resistance of coils to decrease time constant
Decreasing resistance of coils to increase time constant.

⇒ The switch in the circuit shown was on position a for a long time, and is moved to position b at time t = 0. The current i(t) for t > 0 is give
0.2e^-125tu(t) mA
20e^-1250tu(t) mA
0.2e^-1250tu(t) mA
20e^-1000tu(t) mA

⇒ The Y plates of a CRO are excited by a voltage 2 sin 100 t and the X plates are not connected. The display would be
a vertical line
a horizontal line
sine wave
slant line

⇒ A notch filter is sometimes used in communication receivers to
reduce receiver gain at some specific frequency
increase receiver gain at some specific frequency
made selectivity more precise
spread the bandwidth

⇒ The signal flow graph of a system is shown in the given figure. The effect of disturbance T_D can be reduce
increasing G₂ (s)
decreasing G₂ (s)
increasing G₁ (s)
decreasing G₁ (s)

⇒ Which of the following waves do not exist in waveguides?
TE waves
TM waves
TE and TM waves
TEM waves

⇒ In static RAM 6264 the number of address inputs are
10
12
13
15

⇒ The Hilbert transform of cos ω₁t + sin ω₂t is
sin ω₁t + cos ω₂t
sin ω₁t - cos ω₂t
cos ω₁t - cos ω₂t
sin ω₁t + sin ω₂t

⇒ In amplitude modulation
the amplitude of carrier varies in accordance with the amplitude of the modulating signal.
the modulating frequency lies in the audio range
the amplitude of the carrier remains constant
the amplitude of the carrier varies in accordance with the frequency of the modulating signal.

⇒ Which of these are 16 bit microprocessors?
80286
MC68000
Z8000
All

⇒ Electrons within a metal have energy levels from zero to Fermi level E_F.
TRUE
FALSE

⇒ What is typical bandwidths of a 2-wire telephone line?
300 Hz to 3.4 kHz
20 Hz to 4 kHz
dc to 4 kHz
20 Hz to 20 kHz

⇒ If the atomic number of germanium is 32, the number of electrons in the outer most shell will be
2
3
4
6