Question is ⇒ The direction of force an a conductor carrying current and lying in a magnetic field can be found by using, Options are ⇒ (A) Fleming's left hand rule, (B) Fleming's right hand rule, (C) Cork screw rule, (D) Any of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ The direction of force an a conductor carrying current and lying in a magnetic field can be found by using, Options are ⇒ (A) Fleming's left hand rule, (B) Fleming's right hand rule, (C) Cork screw rule, (D) Any of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The direction of force an a conductor carrying current and lying in a magnetic field can be found by using
A.	Fleming's left hand rule [Correct Answer]
B.	Fleming's right hand rule [Wrong Answer]
C.	Cork screw rule [Wrong Answer]
D.	Any of the above [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The units of thermal capacitance are
k cal/°C
°C/k cal
°C sec/k cal
none of the above

⇒ If we need a low noise device, we should use
BJT
FET
thyristor
UJT

⇒ Which one of the following theorem can be conveniently used to calculate the power consumed by the 10 Ω resistor in the network shown in the above fig
Thevenin's theorem
Maximum power transfer theorem
Millman's theorem
Superposition theorem

⇒ In controlled heating circuits, thyristors act as
rectifier
inverter
ac regulator
chopper

⇒ One of the following can be used to generate a pulse whenever triggered
flip-flop
monostable multivibrator
stable multivibrator
Schmitt trigger

⇒ An AM signal is detected using an envelope detector, the carrier frequency and modulating signal frequency are 1 MHz and 2 kHz respectively. An appropriate value for the time constant of the envelope detector is
500 μ sec
20 μ sec
0.2 μ sec
1 μ sec

⇒ Radiation resistance of an antenna is a
dc resistance
ac resistance
either (a) or (b)
none of the above

⇒ The power to the base unit of a cordless telephone is supplied by
battery
AC mains
both battery and AC mains
either battery or AC mains

⇒ If the number of information bits is m, the number of parity bits p in the Hamming code is given by equation
2^p = m + p + 1
2^p ≥ m + p + 1
2^P = m + p
2^p ≥ m + p

⇒ In a moving iron voltmeter the coil has a resistance of 20 Ω and an inductance of 0.3 H. The swamping resistance in 2000 Ω. To ensure correct reading with dc as well as 50 Hz ac, the value of capacitor to be connected in parallel with swamping resistance should be
0.0125 μF
0.0311 μF
0.0521 μF
0.0622 μF

⇒

Match the following:

	List I (Transmission system)		List II (Mode)
A.	Rectangular waveguide	1.	TE/TM
B.	Circular waveguide	2.	TEM
C.	Coaxial line	3.	Quasi TEM
D.	Microstrip line

A-1, B-1, C-2, D-3
A-1, B-2, C-2, D-3
A-2, B-2, C-3, D-3
A-3, B-1, C-2, D-2

⇒ In a radar, the return echo arrives after the allocated pulse interval. Then
the receiver may be over loaded
the target will appear closer than its actual position
the return echo may interfere with transmitter operation
none of the above

⇒

Match the following:

	List I (Bit Pattern)		List II (Register pairs)
A.	00	1.	SP
B.	01	2.	B-C
C.	10	3.	D-E
D.	11	4.	H-L

A-1, B-2, C-3, D-4
A-2, B-3, C-4, D-1
A-2, B-3, C-1, D-4
A-4, B-3, C-2, D-1

⇒

Assertion (A): In p-n-p transistor collector current is termed negative.

Reason (R): In p-n-p transistor holes are majority carriers.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ Two products are sold from a vending machine, which has two push buttons P₁ and P₂. When a button is pressed, the price of the corresponding product is displayed in a 7-segment display. If no buttons are pressed, '0' is displayed, signifying 'Rs' .0'. If only P₁ is pressed, '2' is displayed, signifying 'Rs.
g = P₁ + P₂, d = c + e
g = P₁ + P₂, d = c + e
g = P₁ + P₂, e = b + c
g = P₁ + P₂, e = b + c

⇒ Electrostatic voltmeter is suitable only for low voltages.
TRUE
FALSE

⇒ In which frequency range is the noise figure in a transistor independent of frequency
intermediate frequencies
high frequency
low frequencies
both low and high frequencies

⇒ A pre-emphasis circuit provides extra noise immunity by
converting the phase modulation to frequency modulation
pre-amplifying the whole audio band
boosting the base frequencies
amplifying the higher audio frequencies

⇒

Assertion (A): C has a large number of library functions classified as arithmetic functions, data conversion functions, character classified functions, string manipulation functions, searching and sorting functions etc.

Reason (R): 8086 uses a segment : offset addressing scheme.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ Dielectric constant and conductivity of rocky soil and flat sandy soil are around
10 and 20 mho/cm respectively
20 and 10 mho/cm respectively
2 and 5 mho/cm respectively
0.5 and 2 mho/cm respectively

⇒ The impulse response h(t) of a linear invariant continuous time system is given by h(t) = exp (- 2t) u(t), where u(t) denotes the unit step function. The output of this system to the sinusoidal input x(t) = 2cos(2t) for all time t, is
0
2^-0.25 cos (2t - 0.125p)
2^-0.5 cos (2t - 0.125p)
2^-0.5 cos (2t - 0.25p)

⇒

Assertion (A): In 8085, the zero flag is set when ALU operation results in 0. If the result is not 0, this flag is reset.

Reason (R): In 8085 the S flag is set when the contents of accumulator become negative during execution of an instruction.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ In a JFET, the lower end is called the __________ and the upper end is called the __________ .
source, channel
channel, drain
source, drain
drain source

⇒ A class A transformer coupled power amplifier is to deliver 10 W output. The power rating of transistor should not be less than
5 W
10 W
20 W
40 W

⇒ The term VLSI generally refers to a digital IC having
more than 1000 gates
more than 100 gates
more than 1000 but less than 9999 gates
more than 100 but less than 999 gates

⇒

Assertion (A): A self bias circuit is the most commonly used bias circuit for bipolar junction transistors

Reason (R): A self bias circuit limits the increase in collector or emitter current due to change in junction temperature.

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ Hay's bridge is suitable for inductances having low L/R ratio.
TRUE
FALSE

⇒ In an ac circuit that delivers constant power at varying p.f., the current is
lowest when p.f. is leading
lowest when p.f. is lagging
lowest when p.f is unity
the same for all power factors

⇒ Which of the following instructions in 8085 does not belong to data transfer group?
L X I rp, data 16
MOV M, r
MVIM, data
ADC M

⇒ The 2 out of 5 code has
two 0s and three 0s in each code group
one 1s and four 0s in each code group
four 1s and one 0s in each code group
three 1s and two 0s in each code group