Question is ⇒ The different access methods which permit many satellite users to operate in parallel through a single transponder without interfering with each other as, Options are ⇒ (A) Frequency Division Multiple Access (FDMA), (B) Time Division Multiple Access (TDMA), (C) Code Division Multiple Access (CDMA), (D) All of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ The different access methods which permit many satellite users to operate in parallel through a single transponder without interfering with each other as, Options are ⇒ (A) Frequency Division Multiple Access (FDMA), (B) Time Division Multiple Access (TDMA), (C) Code Division Multiple Access (CDMA), (D) All of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The different access methods which permit many satellite users to operate in parallel through a single transponder without interfering with each other as
A.	Frequency Division Multiple Access (FDMA) [Wrong Answer]
B.	Time Division Multiple Access (TDMA) [Wrong Answer]
C.	Code Division Multiple Access (CDMA) [Wrong Answer]
D.	All of the above [Correct Answer]
View Answer 2 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ To turn off an SCR, it is necessary to reduce its current to less than :
trigger current
holding current
breakover current
none of the above

⇒ When p-n junction is reverse biased the holes in p material move towards the junction and electrons in n material move away from the junction.
TRUE
FALSE

⇒ The open loop gain of an ideal op-amp is
infinite
very high
neither high nor low
low

⇒ If 8085 is required to add two 32 bit numbers, the numbers of addition sequences is
1
2
4
8

⇒ The number of channels available in MF band (300 kHz - 3 MHz) for AM modulating signal of 20 kHz is
70
67
100
150

⇒ Twelve 1 Ω resistance are used as edges to form a cube. The resistance between two diagonally opposite corners of the cube is
5/6 Ω
1 Ω
6/5 Ω
3/2 Ω

⇒ When the ac base voltage in a CE amplifier circuit is too high, the ac emitter current is
zero
constant
alternating
distorted

⇒ A sequence detector is required to give a logical output of 1 whenever the sequence 1011 is detected in the incoming pulse stream. Minimum number of flip-flops needed to built the sequence detector is
4
3
1
2

⇒

Assertion (A): Different symbols are used for different gates

Reason (R): IEEE symbols are the same as traditional symbols for gates.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ Two port network is said to be symmetrical if
Δ_h = 1
Z₁₁ = Z₂
A = Δ
all

⇒ The addition of impurity in extrinsic semiconductor is about 1 part in 10⁸ parts.
TRUE
FALSE

⇒ Thin gate oxide in a CMOS process in preferably grown using
wet oxidation
dry oxidation
epitaxial deposition
ion implantation

⇒ A shift register can be used for all of the following EXCEPT
ring counter
A/D conversion
series to parallel conversion
generation of delay

⇒ A current increasing at the rate of 1A/s is passed through a 1 H inductor. At t = 0, i = 0. The flux linkages after 1 sec are
0.5 Wb-turn
1 Wb-turn
2 Wb-turn
4 Wb-turn

⇒ If V_dc1 is the dc output voltage in half wave controlled rectifier circuit feeding resistive load and V_dc2 is the dc output voltage in full wave controlled rectifier circuit (M - 2 connection) feeding resistive load, then
V_dc1 = 0.5 V_dc2 for all values of firing angle
V_dc1 = V_dc2 for all values of firing angle
V_dc1 ≤ 0.5 V_dc2 for all values of firing angle
V_dc1 ≥ 0.5 V_dc2 for all values of firing angle

⇒ Wagner earthing device is used to eliminate error due to
electromagnetic coupling
electrostatic coupling
both electrostatic and electromagnetic coupling
either (a) or (b)

⇒ A string variable in Basic is
an alphabet followed by dollar sign
a digit followed by dollar sign
either (a) or (b)
neither (a) nor (b)

⇒ The slope of the transfer characteristics of an N-channel JFET is
positive
negative
constantly varying
zero

⇒ In a single phase full wave ac regulator the firing angles during both half cycles are equal.
TRUE
FALSE

⇒ Hall's effect can be used to measure
magnetic field intensity
average number of holes
carriers concentration
electrostatic field intensity

⇒ A transmission line is feeding 1 watt of power to a horn antenna having a gain of 10 dB. The antenna is matched to the transmission line. The total power radiated by the horn antenna into the free space is
10 watt
1 watt
0.1 watt
0.01 watt

⇒ In case of stabilized reactance modulator AFC system
phase modulator is converted into frequency modulation by equalizer circuit
the discriminator must have a fast time constant to provide demodulation
the higher discriminator frequency, the better oscillator frequency
the discriminator frequency must be too low, or the system will fail

⇒ Three resistances of 15 Ω, 10 Ω and 3 Ω are connected in parallel. The overall resistance is
less than 3 Ω
between 15 and 10 Ω
between 10 and 3 Ω
more than 3 Ω

⇒ In pulse code modulation when the maximum frequency in the signal is f_max the bandwidth required will be
≤ p.f_max
≥ p.f_max
≤ (p.f_max)²
≥ (p.f_max)²

⇒ A two branch parallel circuit has a 20 Ω resistance and 1 H inductance in one branch and a 100 μF capacitor in the second branch. It is fed from 100 V ac supply, at resonance, the input impedance of the circuit is
500 Ω
50 Ω
20 Ω
5 Ω

⇒ A broadcast radio transmitter radiates 5 kW when the modulation percentage is 60. How much of this is carrier power?
6.66 kW
5 kW
4.9 kW
4.23 kW

⇒ The integral of a unit impulse is
a unit step function
a ramp function of slope 1
a pulse function of magnitude 1
none of the above

⇒ For the discrete time system of the given fig
y_k - 0.5 y_k_{- 1} - 0.25 y_k_{- 2} = u_k
y_k + 0.5 y_k_{- 1} - 0.25 y_k_{- 2} = u_k
y_k - 0.5 y_k_{- 1} + 0.25 y_k_{- 2} = u_k
y_k + 0.5 y_k_{- 1} + 0.25 y_k_{- 2} = u_k

⇒ Which of the following pulse-time modulation is least used?
PDM
PPM
PWM
PAM

⇒

Match the following:

	List I		List II
A.	SSB Modulation	1.	Transmission line
B.	Δ . B = 0	2.	Hilbert transform
C.	Model dispersion	3.	Faraday's law
		4.	Absence of magnetic monopoles
		5.	Waveguides
		6.	Phase locked loop

A-1, B-3, C-5
A-5, B-4, C-2
A-6, B-4, C-5
A-2, B-4, C-5