Question is ⇒ The derating factor for a BJT transistor is about, Options are ⇒ (A) 0.5 mW/°C, (B) 2.5 mW/°C, (C) 10 mW/°C, (D) 25 mW/°C, (E) , Leave your comments or Download question paper.

Question is ⇒ The derating factor for a BJT transistor is about, Options are ⇒ (A) 0.5 mW/°C, (B) 2.5 mW/°C, (C) 10 mW/°C, (D) 25 mW/°C, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The derating factor for a BJT transistor is about
A.	0.5 mW/°C [Wrong Answer]
B.	2.5 mW/°C [Correct Answer]
C.	10 mW/°C [Wrong Answer]
D.	25 mW/°C [Wrong Answer]
View Answer 2 -3 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which of the following is a valid real constant?
-81.56
73
10254,1
42

⇒ Donor energy level is n type semiconductor is very near valence band.
TRUE
FALSE

⇒ The current I_CBO flows in
base and emitter leads
base and collector leads
collector and emitter leads
collector, emitter and base leads

⇒ In an n channel JFET, the gate is
n type
p type
either n or p
partially n & partially p

⇒ In a computer the data transfer between hard disk and CPU is nearly the same as that between diskette and CPU.
TRUE
FALSE

⇒ Inputs A and B of the given figure are applied to a NAND gate. The output is
from 0 to 6
from 0 to 2
from 0 to 1 and 2 to 3
from 1 to 2 and 3 to 4

⇒ The logic operations of the two circuits given below
complementary
identical
entirely different
none of these

⇒

Assertion (A): The conditions under which it is possible to write Fourier series of a periodic function are called Drichlet conditions.

Reason (R): If f(t) = - f(- t), it is refereed to as odd symmetry.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ In a C expression using assignment operators, relational operators and arithmetic operators, the hierarchy of operations (in the absence of parenthesis) is
assignment, relational, arithmetic
relational, assignment, arithmetic
arithmetic, assignment, relational
arithmetic, relational, assignment

⇒ In a CE amplifier circuit the emitter by pass capacitor is remove. The ac output voltage
increases
remains the same
increases or decreases
decreases

⇒ In the figure shown, A₁, A₂, A₃ are identical Ammeters. If A₁ and A₃ read 5 and 13 A respectively, reading of A₂ wil
8
13 A
18
0

⇒ The power factor of a single phase load can be calculated if instruments available are
one voltmeter, one ammeter
two ammeters
two voltmeters
one voltmeter, one ammeter and one wattmeter

⇒ Which of the wave remains unaffected whether it is a day or night?
Sky wave
Ground wave
Tropospheric wave
Space wave

⇒ Peak to peak value of a sine wave is equal to twice the peak value
TRUE
FALSE

⇒ For the network shown below, if V_D = 12 V and V_GSQ = - 2 V value of R_S wil
13.35 kΩ
3.35 kΩ
33.31 kΩ
3.95 kΩ

⇒ If V_r is the reverse voltage across a graded P-N Junction, then the junction capacitance c_j is proportional to
(V_r)²
(V_r)ⁿ
(V_r)^-n
(V_r)^3/2

⇒ In the given figure, the curves 1, 2, 3 are respectively
all pass, minimum phase and non-minimum phase functions
minimum phase, all pass and non-minimum phase functions
non-minimum phase, all pass and minimum phase functions
minimum phase, non-minimum phase and all pass functions

⇒ In a half bridge inverter each thyristor is gated at a frequency f. The output frequency is
2 f
f
0.5 f
0.25 f

⇒ To neglect a current source the terminals across the source are
replaced by some resistance
replaced by capacitance
open-circuited
short-circuited

⇒ Transformer oil is
refined vegetable oil
refined mineral oil
mixture of vegetable and mineral oil
none of the above

⇒ The derating factor, for ambient temperature higher than specified, for a transistor is about
2.5 mW/°C
0.5 mW/°C
10 mW/°C
20 mW/°C

⇒ If the frequency of a wave 20 Hz, the time period is
20 secs
2 secs
0.2 secs
0.05 secs

⇒ Which of the following represents constant magnitude locus for M = 1?
x = -0.5
x = 0
x² + y² = 1
(x + 1)² + y² = 1

⇒ In a JFET, the drain current is maximum when
V_GS = 0
V_GS is not zero but is slightly negative
V_GS is negative
V_GS is negative and equal to V_DS

⇒ In a CE amplifier the output coupling capacitor is short circuited. The dc collector voltage
will increase
may increase or decrease
will remain the same
will decrease

⇒ When a TTL is driving an CMOS gates it is necessary to ensure that
V_OL(for TTL) ≤ V_IL (for CMOS) and V_0H (for TTL) ≥ VIH (for CMOS)
V_0L (for TTL) ≥ V_IL (for CMOS)
V_0H (for TTL) ≤ V_IH (for CMOS)
V_0L (for TTL) ≥ V_IL (for CMOS) and V_0H (for TTL) ≤ VIH (for CMOS)

⇒ Which one of the following statements regarding DSI is wrong?
It is a digital form of TASI
Though it is more efficient than TASI, it is much slower
A speaker has to wait (it at all) for only a few milliseconds for reallocation of channel
It has increased the capacity of satellite channels by a factor of 2.2 or more with out degrading speech quality

⇒ Which of the following conditions should be satisfied to call an astable multivibrator circuit using discrete components as a digital circuit?

A flip-flop is always a digital circuit.
Only when we assign 1 and 0 to the high and low levels of the output, a flip-flop is called a digital circuit.
Only if the power, supply voltage is maintained at + 5 V or - 5 V, it is called a digital circuit.
Only if it is in IC form, following the technology of IC manufacture, it is called a digital circuit.

Select the correct answer from the codes given below:
1 only
2 and 3
2 only
3 and 4

⇒ In figure, the power dissipated in 4 resistance is P₁ and power associated with 3 A source is P₂.
P₁ = P₂
P₁ < P₂
P₁ > P₂
P₁ may be equal or less than P₂

⇒ If INT = 50 and LOOT = 30, the result of assignment statement SAL = INT + LOOT is
50
80
8
5