Question is ⇒ The depletion layer in a reverse biased p-n junction is due to the presence of, Options are ⇒ (A) electrons, (B) holes, (C) both electrons and holes, (D) immobile ions, (E) , Leave your comments or Download question paper.

Question is ⇒ The depletion layer in a reverse biased p-n junction is due to the presence of, Options are ⇒ (A) electrons, (B) holes, (C) both electrons and holes, (D) immobile ions, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The depletion layer in a reverse biased p-n junction is due to the presence of
A.	electrons [Wrong Answer]
B.	holes [Wrong Answer]
C.	both electrons and holes [Wrong Answer]
D.	immobile ions [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which of the following computer memories is fastest?
Cache
Primary
Mass storage
Off line back up

⇒

Assertion (A): In design of circuit using BJT, a derating factor is used.

Reason (R): As the ambient temperature increases, heat dissipation becomes slower.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ Loop antennas are mostly employed for direction finding (DF) purposes because they are small and hence portable.
TRUE
FALSE

⇒ If two time varying signals of equal magnitudes and 90° phase displacement are applied to X and Y plates of CRO, the display will be
a straight line
a circle
an ellipse
a rectangle

⇒ To avoid objectionable noise in a microwave TV link, the SNR should be about
50 or more
10 or more
25 or more
200 or more

⇒ For a given voltage, four heating coils will produce maximum heat when connected
all in parallel
all in series
with two parallel pairs in series
one pair in parallel with the other two in series

⇒ The conductivity of intrinsic semiconductor is given by
en_i(μ_p - μ_n)
en_i(μ_p + μ_n)
n_i(μ_p + μ_n)
n_i(μ_pμ_n)

⇒ In Bode plots, frequency is plotted on log scale.
TRUE
FALSE

⇒ Assume that x = 7, the Java operation x = x - means that final value of x is
7
-1
6
-6

⇒ For the circuit of the given figure, the output equatio
Y = ABCD
Y = AB + CD
Y = A + BCD
Y = ABC + D

⇒ The width of a radio beam from a 1 m diameter parabolic antenna at 1 GHz is about
100°
50°
5°
2°

⇒ In a 50 cm TV tube, a path difference of 2 km between direct wave and interfering wave would mean a displacement between main image and ghost image equal to
0.3 cm
3 cm
6 cm
9 cm

⇒ The output of a half adder is
SUM
CARRY
SUM and CARRY
none of the above

⇒ In a single phase full wave ac regulator, the firing angles in the two half cycles
are always equal
are sometimes equal
are never equal
may be equal or unequal

⇒ Which family of logic circuits uses field effect transistors?
TTL
CMOS
Both LED and well as LCD
None of the above

⇒ In figure, Z_a = 100∠50°, Z_b = 300∠-90° and Z_c = 200∠0°. For balanced condition, Z_d will
600∠ - 40°
600∠140°
600∠ - 140°
150∠140°

⇒ An ammeter has a resistance of 50 ohms and a shunt of 0.01 Ω. The deflection is θ. If the shunt resistance is increased to 0.02 Ω, the deflection will be.
θ
2θ
0.5θ
0.25θ

⇒ Thevenin's impedance of an ac network is in general
resistance
R and L in series
R and C in series
Either R and L or R and C in series

⇒

Match the following:

	List I		List II
A.	Resistance	1.	M^-1L^-2T⁴I²
B.	Inductance	2.	ML²T^-2I^-2
C.	Capacitance	3.	ML²T^-3I²

A-1, B-2, C-3
A-2, B-1, C-3
A-2, B-3, C-1
A-3, B-2, C-1

⇒ The emitter follower steps up the impedance by a factor of
a
β
a β
a/β

⇒ The range of a cordless telephone is about
1000 m
500 m
100 m
10 m

⇒ The wavelength of light emitted by GaAs laser is 8670 x 10^-10 m. If h = 6.626 x 10^-34 Js, velocity of light = 3 x 10⁸ m/s and eV = 1.602 x 10^-19 J, the energy gap in GaAs is
0.18 eV
0.7 eV
1.43 eV
2.39 eV

⇒ If G(s)H(s) = K (T₁s + 1)/[s² (T₂s + 1)] the system stability depended an relative magnitudes of T₁ and T₂.
TRUE
FALSE

⇒ A high frequency series inverter consists of
a number of series inverters in series
a number of series inverters in parallel
a number of parallel inverters in parallel
a number of parallel inverters in series

⇒ A sequence detector is required to give a logical output of 1 whenever the sequence 1011 is detected in the incoming pulse stream. Minimum number of flip-flops needed to built the sequence detector is
4
3
1
2

⇒ In an amplifier the voltage gain is the ratio of
output voltage and emitter resistance
output voltage and input current
output voltage and input voltage
none of the above

⇒ A lead compensator is basically a
high pass filter
low pass filter
band stop filter
none of the above

⇒ In figure, the function of resistor
to reduce ripples in the output
to improve voltage regulation
to limit the surge current
either (a) or (c)

⇒ The magnitude of transport lag factor is always zero.
TRUE
FALSE

⇒ The dynamic impedance of an R-L and C parallel circuit at resonance is __________ ohm.
R/LC
C/LR
LC/R
L/CR