Question is ⇒ The cut in voltage of a diode is nearly equal to, Options are ⇒ (A) applied forward voltage, (B) applied reverse voltage, (C) barrier potential, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ The cut in voltage of a diode is nearly equal to, Options are ⇒ (A) applied forward voltage, (B) applied reverse voltage, (C) barrier potential, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The cut in voltage of a diode is nearly equal to
A.	applied forward voltage [Wrong Answer]
B.	applied reverse voltage [Wrong Answer]
C.	barrier potential [Correct Answer]
D.	none of the above [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In phase shift keying the input signal is
s_t(t) = A cos ω₀t and s₂(t) = - A cos ω₀t
s₁(t) = s₂(t) = A cos ω₀t
s₁(t) = A cos ω₀t and s₂(t) = A cos (ω₀t + p/2)
s₁(t) = A cos ω₀t and s₂(t) = - A (cos ω₀t + p/2)

⇒ Each of the following statements regarding frequency modulation is true except
amplitude of the modulated wave remains the same as that of carrier wave
the amount of variation of deviation from the original carrier frequency is determined by the frequency of the modulating signal
the rate at which the frequency of modulated wave varies is determined by the frequency of the modulating signal
frequency of modulated wave increases as the signal voltage increases and vice-versa

⇒ Which of the following semiconductor has the highest melting point?
Germanium
Silicon
Gallium arsenide
Lead sulphide

⇒ In a strain measuring device using a strain gauge, the output quantity is
voltage
resistance
impedance
either (a) or (b)

⇒ For broadcasting purpose, full AM signal is preferred to SSB signal because
it requires large bandwidth
generation of full AM is easier
detection of full AM is simpler
none of the above

⇒ Dielectric constant and conductivity of rocky soil and flat sandy soil are around
10 and 20 mho/cm respectively
20 and 10 mho/cm respectively
2 and 5 mho/cm respectively
0.5 and 2 mho/cm respectively

⇒ A zener diode is used in
voltage regulator circuit
amplifier circuits
both voltage regulator and amplifier circuit
none of the above

⇒ In directional coupler of the given figure, the terms |S₁₄| and |S₂₃| of scattering matrix are ne
1 each
0.5 each
0.1 each
1 and 0.5 respectively

⇒ Consider the following in C

An arithmetic operation between integer and an integer gives integer as the result.
An arithmetic operation between a real and a real constant gives real constant as the result.
An arithmetic operation between an integer constant and a real constant is not valid.

Which of the above are correct?
All
1 and 2 only
2 and 3 only
1 and 3 only

⇒ Which of the following is taken as reference antenna for directive gain?
Half wave dipole
Elementary doublet
Isotropic
Infinitesimal dipole

⇒ An ohmmeter is a
moving coil instrument
moving iron instrument
dynamometer instrument
induction instrument

⇒ In a rectangular waveguide if operating frequency is greater than cut off frequency then propagation constant is
purely real
purely imaginary
equal to unit
a complex number

⇒ Binary 101010 is equivalent to decimal number
24
42
44
64

⇒ The noise figure is
3 dB
6 dB
6.6 dB
12 dB

⇒ Which of the following is the software for financial accounting?
COBOL
MS WORD
Page maker
DB III plus

⇒ Computer virus can hide itself in a diskette but not in a hard disk.
TRUE
FALSE

⇒ Which device has internal positive feedback?
Two cavity klystron amplifier
Multi-cavity klystron amplifier
Reflex klystron amplifier
All of the above

⇒ If B_max is the maximum flux density, hysteresis loss is proportional to
B_max
B^1.6_max
B²_max
B³_max

⇒ For the logic circuit shown in figure, the simplified Boolean expression for the output
A + B + C
AB
B
C

⇒ Which of the following components is essential for a voltage multiplier circuit?
Resistor
Inductor
Capacitor
Both (a) and (c)

⇒ When a TTL is driving an CMOS gates it is necessary to ensure that
V_OL(for TTL) ≤ V_IL (for CMOS) and V_0H (for TTL) ≥ VIH (for CMOS)
V_0L (for TTL) ≥ V_IL (for CMOS)
V_0H (for TTL) ≤ V_IH (for CMOS)
V_0L (for TTL) ≥ V_IL (for CMOS) and V_0H (for TTL) ≤ VIH (for CMOS)

⇒ In high power radars, which of the following are used for switching?
Power diode
Power BJT
Power MOSFET
Thyristor

⇒ Find the electric charge required on the earth and moon to balance their gravitational attraction if the charge on the earth is 10 times that on the moon.
1.73 TC
17.3 GC
17.3 TC
1.73 GC

⇒ The received signal frequency at any time of a super-heterodyne receiver having IF = 456 kHz is 1 MHz. The corresponding image signal is
within the medium band
outside the medium band
depend upon modulation index
depends on Modulating frequency

⇒ Thermistor is used in
temperature measurement
temperature control
high temperature alarm circuits of devices
all of the above

⇒ The frequency response of a microphone means
bandwidth of frequencies having output with in ± 1 dB of the output at 1000 Hz
bandwidth of frequencies having output with in ± 3 dB of the output at 1000 Hz
bandwidth of frequencies having output with in ± 1 dB of the output at 500 Hz
bandwidth of frequencies having output with in ± 3 dB of the output at 500 Hz

⇒ For an N-point FFT algorithm with N = 2^m which one of the following statements is TRUE?
It is not possible to construct a signal flow graph with both input and output in normal order
The number of butterflies in the m^th stage is N/m
In-place computation requires storage of only 2N node data
Computation of a butterfly requires only one complex multiplication

⇒ Which of the following can be used to isolate a low impedance from a high impedance source?
Emitter follower
p filter
Darlington pair
Any of the above

⇒ Which instrument needs creep compensation?
Dynamometer wattmeter
Induction wattmeter
Energy meter
Both (b) and (c)

⇒ The relative stability of a system is given by
gain margin alone
phase margin alone
both phase and gain margins
either (a) or (b)