Question is ⇒ The current through R1 is(If β = 99, VBE = 0.7, Options are ⇒ (A) 0.1 mA, (B) 0.35 mA, (C) 0.2 mA, (D) none, (E) , Leave your comments or Download question paper.

Question is ⇒ The current through R1 is(If β = 99, VBE = 0.7, Options are ⇒ (A) 0.1 mA, (B) 0.35 mA, (C) 0.2 mA, (D) none, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The current through R₁ is(If β = 99, V_BE = 0.7
A.	0.1 mA [Correct Answer]
B.	0.35 mA [Wrong Answer]
C.	0.2 mA [Wrong Answer]
D.	none [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Assertion (A): In 8085 when RESET OUT goes low processing begins.

Reason (R): CPU remains reset till RESET IN signal goes high.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ In hexadecimal number system, A is equal to decimal number
10
11
17
18

⇒

Assertion (A): A complicated waveform can be replaced by sum or difference of two or more waveforms.

Reason (R): The method of superposition is applicable only to linear systems.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ The hot resistance of a tungsten lame is about 12 times its cold resistance. Accordingly, the cold resistance of a 60 Ω, 120 V lamp is about __________ ohm.
5
240
2
2880

⇒ For the shaded area in Venn diagram of the given figure, the Boolean expressio
AB + BC + CA
ABC + A B C
ABC + A B C
ABC+AB

⇒ An 8085 executes the following instructionsPC = 2715 H HL = 30A0 H
PC = 30A0H HL = 2715H
PC = 6104 H HL = 6140 H
PC = 6140H HL = 2715H

⇒ N circles for a = a₁, and a = a₁ ± 180° n (where n = 1, 2, 3, ....) are the same.
TRUE
FALSE

⇒ Which multivibrator can be used as a clock timer?
Astable multivibrator
Bistable multivibrator
Any of the above
None of the above

⇒ The input to a parity detector is 1001. The output is
0
1
0 or 1
indeterminate

⇒ Depending on the technique used, digitized television requires a bit rate between __________ millions.
40 and 92.5
25 and 60
30 and 82.5
2

⇒ In a CRO, the frequency of output of time base generator
is only one constant value
is adjustable
varies automatically
either (a) or (c)

⇒ The equivalent circuit shown in figure is
CE
CB
CC
None of the above

⇒ Which of the following logic no resistors are used?
CMOS
TTL
4 n sec ECL
8 sec ECL

⇒ Which of following is linear and bilateral parameter?
Resistors
Semi conductor diodes
Electron tubes
Transistor

⇒ In 8086 the word address is
the address of the least significant byte
the address of most significant byte
either (a) or (b) depending on the word
neither (a) nor (b)

⇒ The output Y of the circuit shown in the figur
(A + B) C + DE
AB + C(D + E)
(A + B) C + D + E
(AB + C) . DE

⇒ A limiter circuit can be built using a diode and resistance.
TRUE
FALSE

⇒ A 3 phase semiconverter when supplying a certain load has a rectification efficiency of 0.6 and transformer utilisation factor of 0.35. When a 3 phase full converter is supplying the same load
rectification efficiency will be more than 0.6 and TUF will be more than 0.35
rectification efficiency will be more than 0.6 but TUF will be less than 0.35
rectification efficiency will be less than 0.6 and TUF will be less than 0.35
rectification efficiency will be less than 0.6 but TUF will be more than 0.35

⇒ Which of these are universal gates?
Only NOR
Only NAND
Both NOR and NAND
NOR, NAND, OR

⇒

Assertion (A): In a parallel circuit with three branches having R, L and C respectively and fed by a step current I, the current through inductance is always zero.

Reason (R): The time constant of R-L circuit is L/R.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ Which of the following statements is true regarding the fundamental mode of the metallic waveguides sh
Only P has no cutoff- frequency
Only Q has no cutoff- frequency
Only P has no cutoff- frequency
All there have cut-off frequency

⇒ PAM stands for
Pulse Analogue Modulation
Phase Analogue Modulation
Pulse Amplitude Modulation
Phase Amplitude Modulation

⇒ Computers use RC circuit for edge triggering.
TRUE
FALSE

⇒ Consider the following statements about instrument landing system of aircraft

It ensures correct landing under conditions of low visibility.
It consists of runaway localizer, glide path equipment and marker beacons.
It is basically a blind landing system.

Which of above statements are correct?
All
1 and 2 only
1 and 3 only
2 only

⇒ For the transport lag G(jω) = e^-jωT, the polar plot is
a semi circle
a circle
a unit circle
none of the above

⇒ Two resistors R₁ = 36 Ω ± 5% and R₂ = 75 Ω ± 5% are connected in series. The total resistance is
111 ± 0 Ω
111 ± 2.778 Ω
111 ± 5.55 Ω
111 ± 7.23 Ω

⇒ Measurement of non-electrical quantity involves the following subsystems

Amplifier block
Display block
Instrumentation block
Transducer block

The correct sequence of these blocks is
4, 1, 3, 2
4, 3, 1, 2
1, 3, 2, 4
1, 2, 3, 4

⇒ Transfer function of a linear system is 200 e^-j10ω The system is a
distortionless Attenuator
amplifier with Phase distortion
distortionless Amplifier
attenuator with Phase distortion

⇒ The derivative of unit step function is
unit impulse
ramp with slope 1
impulse
either (a) or (b)

⇒ Which of these has degenerate p and n materials?
Zener diode
PIN diode
Tunnel diode
Photo diode