Question is ⇒ The current passing through a resistance of 100 ± 0.2% Ω is 2 ± 0.5% A. The limiting error in computation of power will be, Options are ⇒ (A) ± 0.7%, (B) ± 0.9%, (C) ± 1.2%, (D) ± 0.3%, (E) , Leave your comments or Download question paper.

Question is ⇒ The current passing through a resistance of 100 ± 0.2% Ω is 2 ± 0.5% A. The limiting error in computation of power will be, Options are ⇒ (A) ± 0.7%, (B) ± 0.9%, (C) ± 1.2%, (D) ± 0.3%, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The current passing through a resistance of 100 ± 0.2% Ω is 2 ± 0.5% A. The limiting error in computation of power will be
A.	± 0.7% [Wrong Answer]
B.	± 0.9% [Wrong Answer]
C.	± 1.2% [Correct Answer]
D.	± 0.3% [Wrong Answer]
View Answer 1 -2 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ If operator 'a' = 1 ∠120° then (1 - a²) =
1 ∠ - 30°
1 ∠ 30°
1 ∠ - 60°
1 ∠60°

⇒ In a two terminals network the O.C. voltage measured at the given terminals is 100 V and s.c., currents at the same terminals 5 A. If a load of 80 Ω resistance is connected at the terminals, load current is
0.0416666666666667
1.25 A
0.25
6.25 A

⇒ In which of the following case the rating of the transformer to deliver 100 watts of d.c. power to a load, will be least?
Half wave rectifier
Full wave rectifier
Bridge type full wave rectifier
Three phase full wave rectifier

⇒ The disturbance from adjacent telephone line is known as
cross fire
cross talk
inductive disturbance
none of the above

⇒ Tuned amplifiers are used at radio frequencies.
TRUE
FALSE

⇒ In the circuit of figur
I₁ will always lag I₃
I₂ may be in phase or lag I₃
I₃ will always lag I₂
I₂ and I₃ will be in phase

⇒ A single phase energy meter operates on induction principle.
TRUE
FALSE

⇒ Which of the following pulse modulation is analog?
PCM
Differential PCM
PWM
Delta

⇒ Computers use RC circuit for edge triggering.
TRUE
FALSE

⇒ Equation x_l0 = 11001001₂ when solved for x gives the value of x as
8
111
152
201

⇒ A mod-10 counter can divide the clock frequency by a factor of
10
20
210
102

⇒ A 3 bit synchronous counter uses FF with propagation delay time of 20 ns each. The maximum possible time required for change of state will be.
60 ns
40 ns
20 ns
None

⇒ When an electron rises through a potential of 100 V it will acquired an energy of
100 eV
100 Joules
100 ergs
100 x 10^-6 Newtons

⇒ A certain transistor has a_dc of 0.98 and a collectors leakage current of 5 μA. If I_E = 1 mA, the base current will be
35 μA
25 μA
15 μA
5 μA

⇒ The figure of merit for a logic family is
gain band width product
(propagation delay time) (power dissipation)
(fan out) (power dissipation)
(noise margin) (power dissipation)

⇒ In the analogy between electric and magnetic circuits permeability is analogous to
resistivity
conductivity
electric field intensity
current density

⇒ A TV receiver is 40 cm wide and 30 cm high. The EHT supply required is about
2kV
20 kV
53 kV
10 W

⇒ A device that converts from decimal to binary numbered is called
decoder
encoder
CPU
converter

⇒ The counter shown in the given figure
Synchronous
Johnson
Ring
None of the above

⇒ As the magnitude of reverse bias is increased, the capacitance of varactor diode
increases
decreases
first increase, then decreases
first decreases then increases

⇒

Assertion (A): The maximum efficiency of a class B push pull amplifier is 78.5%

Reason (R): A current mirror uses a compensating diode in parallel with the emitter diode

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ Consider the following statements as regards pulse repetition frequency

Pulse interval should be as large as possible so that a pulse returns before next pulse is transmitted
Greater the number of pulses reflected from a target, greater is the probability of distinguishing it from the noise

Which of the above are correct?
1 only
2 only
both 1 and 2
neither 1 nor 2

⇒ Which of the following does not cause losses in optical fibre cables?
Stepped index operation
Impurities
Microbending
Attenuation in glass

⇒ Consider the following expressions in J
42, 40, 42 respectively
42, 42, 42 respectively
40, 42, 42 respectively
40, 40, 42 respectively

⇒

Assertion (A): The equation D = ∈₀∈_rE is applicable only to isotropic materials.

Reason (R): In polycrystalline materials, the directional effects are absent.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ In a CMOS CS amplifier, the active load is obtained by connecting a
p channel current mirror circuit
n channel transistor
p channel transistor
BJT current mirror

⇒ The number of product terms in the minimized sum of product expression obtained through the following K-map, where d, don't c
2
3
4
5

⇒ 100101.1011₂ = __________ .
115.22₈
115.54₈
215.54₈
100.01₈

⇒ The Sun blots out the transmission of a geosynchronous satellite twice a year when satellite passes directly in front of it. This outage lasts for about
10 minutes on 5 consecutive days
5 minutes on 10 consecutive days
30 minutes for 5 consecutive days
one hour for 5 consecutive days

⇒ If low pressure of 10^-6 mm of Hg is required to be measured, we should use
compound pressure gauge
thermocouple vacuum gauge
Pirani gauge
ionization type vacuum gauge