Question is ⇒ The current I<sub>CBO</sub> flows in, Options are ⇒ (A) base and emitter leads, (B) base and collector leads, (C) collector and emitter leads, (D) collector, emitter and base leads, (E) , Leave your comments or Download question paper.

Question is ⇒ The current I<sub>CBO</sub> flows in, Options are ⇒ (A) base and emitter leads, (B) base and collector leads, (C) collector and emitter leads, (D) collector, emitter and base leads, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The current I_CBO flows in
A.	base and emitter leads [Wrong Answer]
B.	base and collector leads [Correct Answer]
C.	collector and emitter leads [Wrong Answer]
D.	collector, emitter and base leads [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ End fire array is called a linear resonant dipole array.
TRUE
FALSE

⇒ Capacitance hats are installed on low frequency antenna is
increase the electrical length
reduce the electrical length
protect against lightening
protect against corona effects

⇒ A 4 cm by 3 cm rectangular waveguide with air cavity, is operating at 12 GHz with TE₁₁ mode. The cut-off frequency is:
6.25 GHz
4.75 GHz
1.5 GHz
8.75 GHz

⇒ A transistor is operated as non-saturated switch to eliminate
turn on time
turn off time
storage time
delay time

⇒ The changes in ambient temperature affect the open loop gain of amplifier.
TRUE
FALSE

⇒ The voltage and current distributions on a grounded λ/4 dipole (Marconi antenna) are similar to those of a half wave dipole in space.
TRUE
FALSE

⇒ In 8085 microprocessor, in order to enable INTR interrupt, which of the following instruction are needed?
EI only
SIM only
El and SIM both
None

⇒ The first dominant pole encountered in the frequency response of a compensated op-amp is approximately at
5 Hz
10 kHz
1 MHz
100 MHz

⇒ Harmonic distortion in CB amplifier may be least when the load resistance is
negligible
very low
very high
infinite

⇒

Assertion (A): Thyristors can be used in controlled heating, excitation systems of alternators, speed control of motors and HVDC

Reason (R): A static var system using thyristors is very commonly used in high voltage ac systems.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ A signal m(t) amplitude modulates a carrier A_c cos ω_ct. The final signal will be
[A_c m(t)] cos ω_ct]
A_c . [1 + m(t)] cos ω_ct
A_c + [m(t)] cos ω_ct
A_c cos ω_ct + m(t)

⇒ Incompatibility between memory and I/O device may be due to
timing according to which data transfer is to take place
electrical characteristics of the two devices
format of data transfer
all of the above

⇒ Auto correlation for t = 0 is equal to
average power S of waveform
square of average power S of waveform
half of average power S of waveform
square root of average power S of waveform

⇒ Which of the following characteristics is not true for TTL Logic?
Good speed
Low power dissipation per gate
High cost
None of these

⇒ In a J-K FF we have J = Q and K = 1. Assuming the FF was initially cleared and then clocked for 6 pulses, the sequence at the Q output wil
10000
11001
10010
10101

⇒ For stable network, the real part of poles and zeros of driving point function must be
negative
negative or zero
zero
positive

⇒ A signal m(t) = 5 cos 2p 100 t frequency modulates a carrier. The resulting FM signal
0.1 kHz
6 kHz
3.2 kHz
100 kHz

⇒ Whenever a wave is incident on a perfect conductor then the reflection coefficient is
1
0
1 < 180°
depend upon η₁, η₂

⇒ In a tape recorder the output from RF oscillator is given to
only erase head coil
only record head coil
coils of both erase head and record head
none of the above

⇒ In atomic physics, a state with l = 0 is called p state.
TRUE
FALSE

⇒ A transistor has a maximum power dissipation of 350 mW at an ambient temperature of 25°C. If derating factor is 2 mW/°C, the maximum power dissipation for 40°C ambient temperature is
300 mW
330 mW
350 mW
380 mW

⇒ Which one of the following rules determines the mapping of s-plane to z-plane?
Right half of the s-plane maps into outside of the unit circle in z-plane
Left half of the s-plane maps into outside of the unit circle.
Imaginary axis in s-plane maps in to the circumference of the unit circle.
All of the above

⇒ A radio station works at 800 kHz and uses AM. If this is a public broadcast system, it should transmit using
parabolic reflector to transmit all round
turnstile antenna for the required land
half wave long horizontal wave
a vertical antenna less than quarter for practical reasons

⇒

Assertion (A): A large negative feedback is deliberately introduced in an amplifier to make its gain independent of variation in parameters of active device.

Reason (R): A large negative value of feedback results in a high value of return difference compared to unity which makes the feedback gain inversely proportional to the feedback factor.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒

Assertion (A): A capacitor with imperfect dielectric can be represented by a capacitance in parallel with resistance.

Reason (R): For imperfect dielectrics, dielectric constant has real and imaginary parts.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ In a semi-conductor diode, the barrier offers opposition to
holes in P-region only
free electrons in N-region only
majority carriers in both regions
majority as well as minority carriers in both regions

⇒ Schmitt trigger can be used as a
comparator
square-wave generator
flip-flop
all of these

⇒ Which of the following configuration has low thermal stability?
CB
CC
CE
All have identical thermal stability

⇒ A series RLC circuit is at resonance at 200 Hz. If capacitance is increased to four times, the circuit will be in resonance at
200 Hz
400 Hz
100 Hz
800 Hz

⇒ Which of the following effects is used in measurement of magnetic flux?
Hall effect
Seeback effect
Piezo electric effect
Photoelectric effect