Question is ⇒ The current i(t), though a 10 Ω resistor in series with an inductance, is given by i(t) = 3 + 4 sin (10t + 45°) + 4 sin (300t + 60°) Amperes. The RMS value of the current and the power dissipated in the circuit are, Options are ⇒ (A) 41 A, 410 W, respectively, (B) 35 A, 350 W, respectively, (C) 5 A, 250 W, respectively, (D) 11 A, 1210 W, respectively, (E) , Leave your comments or Download question paper.

Question is ⇒ The current i(t), though a 10 Ω resistor in series with an inductance, is given by i(t) = 3 + 4 sin (10t + 45°) + 4 sin (300t + 60°) Amperes. The RMS value of the current and the power dissipated in the circuit are, Options are ⇒ (A) 41 A, 410 W, respectively, (B) 35 A, 350 W, respectively, (C) 5 A, 250 W, respectively, (D) 11 A, 1210 W, respectively, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The current i(t), though a 10 Ω resistor in series with an inductance, is given by i(t) = 3 + 4 sin (10t + 45°) + 4 sin (300t + 60°) Amperes. The RMS value of the current and the power dissipated in the circuit are
A.	41 A, 410 W, respectively [Correct Answer]
B.	35 A, 350 W, respectively [Wrong Answer]
C.	5 A, 250 W, respectively [Wrong Answer]
D.	11 A, 1210 W, respectively [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Consider the following expression for the driving point imped
2 and 4
1 and 3
1 and 4
2 and 3

⇒

Assertion (A): CMOS devices have very low power consumption

Reason (R): CMOS devices have high noise margin.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ The maximum percent overshoot with maximum value of first overshoot as 3.5 V and steady state value as 2.575 V is
0.3592
0.2643
0.5761
0.1524

⇒

Match the following:

	List I (Microwave device)		List II (Application)
A.	PIN diode	1.	Microwave amplification
B.	GaAs MOSFET	2.	Low noise microwave generation
C.	Transferred electron device	3.	Electronic tuning of MW oscillator
D.	Varactor diode	4.	Light wave detection

A-1, B-2, C-4, D-3
A-4, B-1, C-2, D-3
A-2, B-3, C-1, D-4
A-3, B-4, C-2, D-1

⇒ The arrangement in the given figure is a hybid T. If 100 mW fed at port 1, the power reflected back at port
0
25 mW
50 mW
100 mW

⇒ Which of the following microphones works on the principle of Faraday's law?
Carbon
Condenser
Moving coil
Electret

⇒ The response of D'Arsonval galvanometer is over damped if
D² > 4CJ
D² > 2CJ
D² < 4CJ
D² < 2CJ

⇒ Two similar coils have self inductance of 1 mH each. Coefficient of coupling is 0.5. The mutual inductance M is
0.25 mH
0.5 mH
0.707 mH
1 mH

⇒ The modulation index of an AM wave is changed from 0 to 1. The transmitted power is
unchanged
halved
increased by 50%
quadrupled

⇒ Bipolar IC memories are fabricated using
high density versions of MOSFET or low density versions of bipolar transistor flip-flop.
high density version of MOSFET or bipolar transistor flip-flop
low density versions of MOSFETs
high density versions of the bipolar transistor flip-flop.

⇒ __________ acts as a depolarizer in a dry cell.
ammonium chloride
carbon powder
manganese dioxide
zinc chloride

⇒ Without any addition circuitry, an 8:1 MUX can be used to obtain.
some but not all Boolean functions of 3 variables
all functions of 3 variables but none of 4 variables
all functions of 3 variables and some but not all of 4 variables
all functions of 4 variables

⇒ Four inputs A, B, C, D are fed to a NOR gate. The output of NOR gate is fed to an inverter. The output of inverter is
A + B + C + D
A + B + C + D
ABCD
ABCD

⇒ The bandwidth of DSB suppressed carrier modulation system when the modulating frequency varies between 500 Hz and 5 kHz is
555 kHz
505 kHz
500 kHz
9 kHz

⇒ Rotation of a geosynchronous satellite means its
drift from stationary position
wobbling
three-axis stabilization
three-dimensional stabilization

⇒ If X = 1 in the logic equation [X + Z { Y + (Z + X Y)}] { X + Z (X + Y)} = 1, then
Y = Z
Y = Z
Z = 1
Z = 0

⇒

Assertion (A): C has 32 keywords like auto, if, do, float etc.

Reason (R): Key words can not be used as variable names in C.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ Which of the following can be used for measuring capacitance?
De sauty bridge
Maxwell's bridge
Anderson bridge
Hay's bridge

⇒ In response to a unit step input the controller output in given figure is
proportional controller
proportional plus integral controller
integral controller
none of the above

⇒ SSI is used in flip flops.
TRUE
FALSE

⇒ Greatest mobility can be expected in case of
holes
protons
electrons
negative ions

⇒ A germanium diode has a reverse saturation current of 30 μA at 125°C and forward current of 1 mA at a forward potential of 0.8 V and the reverse potential is 0.6 V What are its dynamic forward and reverse resistance at this temperature.
10.7 Ω, 70 kΩ
34 Ω, 20 kΩ
80 Ω, 20 kΩ
800 Ω, 40 kΩ

⇒ In a practical oscillator, the magnitude of loop gain Aβ is kept slightly larger than unity and the amplitude of oscillations is limited by
the ratio of A to β
the on set of non-linearity of amplifying device
the linearity of amplifying device
all of the above

⇒ For the network shown, determine z₁ , z₀ and A_{vz_i = 1.067 Ω; z₀ = 3 kΩ; A_v = 280
z_i = 1.067 Ω; z₀ = 3 kΩ; A_v = - 280.37
z_i = 937 Ω; z₀ = 3 Ω; A_v = 281
z_i = 937 Ω; z₀ = 33 kΩ; A_v = - 280.37}

⇒

Assertion (A): The conditions under which it is possible to write Fourier series of a periodic function are called Drichlet conditions.

Reason (R): If f(t) = - f(- t), it is refereed to as odd symmetry.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ Two wattmeter method of 3-phase power measurement can be used to find
total active power
total active power and power factor
total active power and reactive power
total active power, power factor, apparent power, and reactive power

⇒ In TV system in India, each frame is divided into
625 horizontal lines
525 horizontal lines
425 horizontal lines
325 horizontal lines

⇒ HVDC transmission systems generally use
12 pulse converters
6 pulse converters
3 pulse converters
either 12 or 6 pulse converters

⇒ The Z transform of a particular signal is given
non causal and stable
causal and stable
unstable and noncausal
can't say

⇒ IF V_CC = 15 V, V_CEQ = 5 V and I_CQ = 50 mA, the efficiency in class A operation is
1
0.5
0.25
0.167