Question is ⇒ The current gain of a transistor is the ratio of, Options are ⇒ (A) emitter current to base current, (B) emitter current to collector current, (C) collector current to base current, (D) collector current to emitter current, (E) , Leave your comments or Download question paper.

Question is ⇒ The current gain of a transistor is the ratio of, Options are ⇒ (A) emitter current to base current, (B) emitter current to collector current, (C) collector current to base current, (D) collector current to emitter current, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The current gain of a transistor is the ratio of
A.	emitter current to base current [Wrong Answer]
B.	emitter current to collector current [Wrong Answer]
C.	collector current to base current [Correct Answer]
D.	collector current to emitter current [Wrong Answer]
View Answer 2 -4 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ To obtain very high I/P and O/P impedances in a feedback amplifier, the topology used is
voltage series
current series
voltage shunt
current shunt

⇒ The main disadvantage of the two-hole directional coupler is
poor directivity
narrow bandwidth
high standing wave ratio
low directional coupling

⇒ A loop antenna may be of
square on triangular shape
hexagonal shape
circular shape
any of the above

⇒ In an op-amp comparator, the positive or negative output is
saturated
amplifier
unsaturated
any of the above

⇒ Which interrupts are masked?
5.5
6.5
7.5
None

⇒ A generator with an internal resistance of 600 Ω drives an amplifier whose input resistance is 400 Ω. The generator's open circuit voltages is 1 mV; the amplifier develops 100mV across an 8kΩ load. The current amplification is
2.5
12.5
25
125

⇒ The noise margin of a TTL gate is about
0.2 V
0.4 V
0.6 V
0.8 V

⇒ In the field controlled motor the entire damping comes from
armature resistance
back emf
motor friction and load
field resistance

⇒ The ac motor used in servo applications is
single phase induction motor
two phase induction motor
3 phase induction motor
synchronous motor

⇒ In a single-stage RC coupled common emitter amplifier, the phase shift at the lower 3 dB frequency is
zero
135°
180°
225°

⇒ In a digital system, the maximum clock frequency that can be used with Master/Slave Clocked flip-flops having total propagation delay of 200 μsec is
20 MHz
50 MHz
100 MHz
200 MHz

⇒ The material which has zero temperature coefficient of resistance is
manganin
porcelain
carbon
aluminium

⇒ In push button type telephone set, pressing a button generates
one frequency
two high frequencies
two low frequencies
one low frequency and one high frequency

⇒ An 8156 has A₁₅ connected to its CE input. A₁₄ to A₈ are unconnected, and AD₇ to AC₀ are connected.Ignoring shadows, the port addresses
80 H
85 H
82 H, 83 H
80 H to 85 H

⇒ The correct sequence of parts in klystron amplifier are
anode, catcher cavity, cathode, buncher cavity
cathode, buncher cavity, catcher cavity, cavity
anode, buncher cavity, catcher cavity, cathode
cathode, catcher cavity, anode, buncher cavity

⇒ Which one of the following rules determines the mapping of s-plane to z-plane?
Right half of the s-plane maps into outside of the unit circle in z-plane
Left half of the s-plane maps into outside of the unit circle.
Imaginary axis in s-plane maps in to the circumference of the unit circle.
All of the above

⇒ An ac network has two sources of the same frequency. The currents in one branch when the sources act independently are 10 ∠30° A and 10 ∠60° A. When both sources act, the current in the branch should be
19.32 ∠45°
15 ∠45°
20 ∠45°
zero

⇒ In single tone AM modulation, the transmission efficiency for m = 1 is
0.333
0.5
1
0.1665

⇒ In telephone, the dial tone has a frequency of
5 Hz
15 Hz
33 Hz
233 Hz

⇒ In the vacuum diode equation i_b = ke_b^1.5, the current is
temperature limited current
space charge limited current
any of the above
none of the above

⇒ In integral cycle control the period of on-off control should be more than mechanical time constant of load.
TRUE
FALSE

⇒ JFET has __________ degree of isolation between input and output, and a __________ noise figure.
low, low
high, high
low, high
high, low

⇒ Two identical hybrid tees are joined as shown in the given figure. If 16 mW power is fed into port 1, the power output at ports 2 , 3, 1', 2', 3' respectivel
8, 4, 2, 2, 0 mW
0, 8, 4, 4, 0 mW
0, 8, 2, 2, mW
8, 2, 4, 2, 0 mW

⇒

Assertion (A): In circular waveguide the attenuation of TE₀₁ mode decreases as the operating frequency increases.

Reason (R): The wall currents in a circular waveguide in TE_Q1 mode are completely circumferential.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ A parallel RLC circuit has ω₀ = 10⁶ and Q = 30, Given C = 30 pF, the value of R is
0
1 μΩ
2 MΩ
1 MΩ

⇒ In solid dielectrics the rate of deterioration doubles for every 10-12°C rise in temperature.
TRUE
FALSE

⇒ In a bipolar transistor
the base is thick and highly doped
the base is thin and highly doped
the base is thick and lightly doped
the base is thin and lightly doped

⇒ Frequency frogging is used in a carrier system to
conserve frequencies
reduce distortion
reduce cross talk
none of the above

⇒ A signal having uniformly distributed amplitude in the interval (- V to + V) is to be encoded using PCM with uniform quantization. The signal to quantization noise ratio is determined by
dynamic range of signal
sampling rate
number of quantizing levels
power spectrum of signal

⇒ The start of modern computer age was started by the event
development of disc drive
development of transistor
development of Hollerith code
design of EVIAC computer