Question is ⇒ The current due to thermionic emission is proportional to, Options are ⇒ (A) T, (B) T2, (C) T3, (D) T4, (E) , Leave your comments or Download question paper.

Question is ⇒ The current due to thermionic emission is proportional to, Options are ⇒ (A) T, (B) T2, (C) T3, (D) T4, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The current due to thermionic emission is proportional to
A.	T [Wrong Answer]
B.	T² [Correct Answer]
C.	T³ [Wrong Answer]
D.	T⁴ [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ From a measurement of the rise time of the output pulse of an amplifier whose input is a small amplitude square wave, one can estimate the following parameter of the amplifier
gain bandwidth product
slew rate
upper 3 dB frequency
lower 3 dB frequency

⇒ A feedback network to be used with an amplifier to provide oscillation is tested and found to give an output of 0.124 V with a 0.5 V input. What will be the effect on output if the amplifier's gain is twice that required by the Barkhausen criterion?
Linear oscillations
Non-linear oscillations
Damped oscillations
No oscillations

⇒ The first contribution to logic was made by
George Boole
Copernicus
Aristotle
Shannon

⇒ The four types of integers in Java are called
byte, short, int and long
bit, byte, short and long
nibble, byte, short and long
nibble, byte, int and long

⇒ The input to a parity detector is 1001. The output is
0
1
0 or 1
indeterminate

⇒ The range of value "a" for which system will be stable. If impulse response of DT system is = aⁿ ∪[n]
a > 1
a < 1
1 < a < ∞
-1 < a < 1

⇒

Assertion (A): A synchro control transformer has nearly constant impedance across its rotor terminals.

Reason (R): Rotor of a synchro control transformer is cylindrical so as to give uniform flux distribution.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ A single mode fibre not suffer from which type of dispersion?
Waveguide dispersion
Material dispersion
Intermodal dispersion
Polarization mode dispersion

⇒ An RC coupled amplifier has an open loop gain of 200 and a lower cutoff frequency of 50 Hz. If negative feedback with β = 0.1 is used, the lower cut off frequency will be
about 50 Hz
about 5 Hz
about 2.38 Hz
about 70.5 Hz

⇒ Consider the following statements about DRAM

Page mode read operation is faster than RAS read
RAS input remains active during column address strobe
The row and column addresses are strobed into the internal buffers using RAS and CAS inputs respectively

Which of the above statements are correct?
1 and 3 only
All
1 and 2 only
2 and 3 only

⇒ An atom of a rare gas is placed is an electric field E. Then
the nucleus will be shifted in the direction of E by an amount which is proportional to E.
the nucleus will not be shifted.
the nucleus will be shifted in the direction of E by an amount which is independent of E.
the nucleus will be shifted in a direction opposite to that of E.

⇒ There is no hysteresis phenomenon is any dielectric material.
TRUE
FALSE

⇒ Hall effect is observed in a specimen when it is carrying current and is placed in a magnetic field. The resultant electric field inside the specimen is
normal to both current and magnetic field
in the direction of current
antiparallel to magnetic field
in arbitrary direction

⇒ In the saturation region of CE output characteristics of n-p-n transistor, V_CE is about
0.5 V
15 V
- 0.5 V
- 15 V

⇒ A lead compensator
speeds up the transient response
increases the stability margin
increases the stability margin and speeds up the transient-response.
none of the above.

⇒ Consider the following statements about directional coupler shown in the fi
1 and 2 only
3 and 4 only
1, 2 and 3
2, 3 and 4

⇒ Ohm's law is valid for
dc voltage and current
ac voltage and current
all voltages and current
dc and ac voltages and currents

⇒ The frequency tolerance for the RF carrier in the standard AM radio broadcast band is
zero
+20 Hz
+1000 Hz
+25 Hz

⇒ The accuracy of measurement using CRO is about
± 0.5%
± 0.05 %
± 1%
± 3%

⇒ If V_dc1 is the dc output voltage in half wave controlled rectifier circuit feeding resistive load and V_dc2 is the dc output voltage in full wave controlled rectifier circuit (M - 2 connection) feeding resistive load, then
V_dc1 = 0.5 V_dc2 for all values of firing angle
V_dc1 = V_dc2 for all values of firing angle
V_dc1 ≤ 0.5 V_dc2 for all values of firing angle
V_dc1 ≥ 0.5 V_dc2 for all values of firing angle

⇒ 8085 data bus has 8 lines and is bidirectional.
TRUE
FALSE

⇒ Which of the following Boolean algebra rules is correct?
A . A = 1
A + AB = A + B
A + A B = A + B
A(A + B) = B

⇒

Assertion (A): Gunn diode is a transferred electron device.

Reason (R): A Gunn oscillator uses the phenomenon of transferred electron effect.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ A 4 bit ripple counter is in 0000 state. The clock pulses are applied and then removed. The counter reads 0011. The number of clock pulses which have occurred are
3
3 or 19
3 or 19 or 35
none of the above

⇒ Find the number of loop equation and number of possible trees for the given gr
7, 2097152
7, 262144
7.5764801
6, 823543

⇒ For an P-channel enhancement type MOSFET determine the drain current if K = 0.278 x 10^-3A/V², V_GS = -4V, V_T = -2V, Voltage equivalent at 27°C = 26 mV.
10 mA
1.11 mA
0.751 mA
46.98 mA

⇒ If ω is the frequency of modulating voltage in FM, the modulation index is proportional to
ω
1/ω
ω
1/ω

⇒ If the network in figure (1), (2) are equivalent at terminals A - B, then voltage V and resistance R
100V and 12 Ω
60V and 12 Ω
100V and 30 Ω
60V and 30 Ω

⇒ In a p-n-p transistor the main current carriers and the mechanism of flow respectively are
electrons, drift
holes, drift
holes, diffusion
electrons, diffusion

⇒ The relation AD - BC = 1 where A, B, C, D are transmission parameters of a network is valid for
every network
passive but not reciprocal network
passive and reciprocal network
both active and passive networks