Question is ⇒ The correct sequence of subsystems in an FM receiver is, Options are ⇒ (A) Mixer, RF amplifier, Limiter, IF amplifier. Discriminator, Audio amplifier, (B) RF amplifier, Mixer, IF amplifier, Limiter, Discriminator, Audio amplifier, (C) RF amplifier, Mixer, Limiter, Discriminator IF amplifier, Audio amplifier, (D) Mixer, IF amplifier, RF amplifier, Audio amplifier, Discriminator, (E) , Leave your comments or Download question paper.

Question is ⇒ The correct sequence of subsystems in an FM receiver is, Options are ⇒ (A) Mixer, RF amplifier, Limiter, IF amplifier. Discriminator, Audio amplifier, (B) RF amplifier, Mixer, IF amplifier, Limiter, Discriminator, Audio amplifier, (C) RF amplifier, Mixer, Limiter, Discriminator IF amplifier, Audio amplifier, (D) Mixer, IF amplifier, RF amplifier, Audio amplifier, Discriminator, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The correct sequence of subsystems in an FM receiver is
A.	Mixer, RF amplifier, Limiter, IF amplifier. Discriminator, Audio amplifier [Wrong Answer]
B.	RF amplifier, Mixer, IF amplifier, Limiter, Discriminator, Audio amplifier [Correct Answer]
C.	RF amplifier, Mixer, Limiter, Discriminator IF amplifier, Audio amplifier [Wrong Answer]
D.	Mixer, IF amplifier, RF amplifier, Audio amplifier, Discriminator [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A conditionally stable system is stable for the value of gain between two critical values. It is unstable if
the gain is increased beyond upper critical value
the gain is decreased below lower critical value
both (a) and (b)
none of the above

⇒ The characteristic equation of flip-flop gives the next state Q_{N + 1} in terms of present state Q_N and the inputs. Which one of the following is the characteristic equation of J - K flip-flop?
Q_N+1 = JQ_N + KQ_N
Q_N+1 = J + KQ_N
Q_N+1 = KQ_N + JQ_N
Q_N+1 = K + JQ_N

⇒ To determine the polarity of voltage drop across a resistor, it is sufficient to know
direction of current through the resistor
direction and magnitude of current through the resistor
direction and magnitude of current and value of resistance
magnitude of current through the resistance

⇒ The function f = A ⊕ B ⊕ A ⊕ D ⊕ E ⊕ C ⊕ D ⊕ E ⊕ F ⊕ G ⊕ F ⊕ G ⊕ C ⊕ E ⊕ A ⊕ D ⊕ B ⊕ E ⊕ E ⊕ B ⊕ B ⊕ B ⊕ B ⊕ D can be written as
A ⊕ B ⊕ D
A ⊕ B ⊕ E
A ⊕ E
A ⊕ E

⇒

Assertion (A): In a parallel circuit with three branches having R, L and C respectively and fed by a step current I, the current through inductance is always zero.

Reason (R): The time constant of R-L circuit is L/R.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ Wiedemann-Franz law correlates
electrical and thermal conductivities
electron arrangement in shells
temperature and photo electric emission
all of the above

⇒ In the circuit of figur
I₁ will always lag I₃
I₂ may be in phase or lag I₃
I₃ will always lag I₂
I₂ and I₃ will be in phase

⇒ Which of the following is not an application software?
MS Word
DBMS
Worksheet
Lisp

⇒ When .9432 E - 4 is subtracted from .5452 E - 3 in normalized floating point mode
none of the numbers is changed
.9432 E - 4 is changed to .09432 E - 3 and .5452 E - 3 is not changed
.5452 E - 3 is changed to 5.452 E - 4 but .9432 E - 4 is not changed
both Ihe numbers are changed and their exponents are, made equal to -5

⇒ At 0 K the forbidden energy gap in intrinsic semi conductor is about
10 eV
6 eV
1 eV
0.2 eV

⇒

Assertion (A): If integral control action is included in the controller the offset can be eliminated.

Reason (R): Integral control action may lead to oscillatory response.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ A geosynchronous satellite
has the same period a that of the Earth
has a circular orbit
rotates in the equatorial plane
has all of the above

⇒ For a delayed half wave rectified wave, the average and rms values are lower than those for half wave.
TRUE
FALSE

⇒ A counter has 4 flip flops. It divides the input frequency by
4
2
8
16

⇒ A dynamometer wattmeter is connected in ac circuit. The measured power is
rms power
average power
peak power
instantaneous power

⇒ An active network has
an e.m.f source
a current source
neither of the above
either (a) or (b)

⇒ To find current in a resistance connected in a network, Thevenin's theorem is used V_TH = 20 V and R_TH = 5 Ω. The current through the resistance
is 4 A
is 4 A or less
is less than 4 A
may be 4 A or less or more than 4 A

⇒ An RLC series circuit is excited by a step voltage E. The circuit current at t = 0 is
E/R
E/LC
zero
infinity

⇒ The depth of penetration at 4 MHz is 10 cm, then at 2.5 MHz it is
62.5 cm
13 cm
6.25 cm
8 cm

⇒ A 750 A circuit uses thyristor of current rating 175 A. If derating is 25%, the number of thyristors in parallel is
3
4
6
10

⇒

Assertion (A): At room temperature the fermi level in p type semiconductor lies nearer to the valence band and in n type semiconductor it lies nearer to the conduction band.

Reason (R): At room temperature, the p type semiconductor is rich in holes and n type semiconductor is rich in electrons.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ MF is generally used for
telegraphy
radio and television links
satellite communication
broadcasting, navigation

⇒ In an n type semiconductor the fermi level is 0.35 eV below the conduction band, the concentration of donor atoms is increased to three times. The new position of Fermi level will be
0.35 eV below conduction band
about 0.32 eV below conduction band
about 0.32 eV above conduction band
about 0.1 eV below conduction band

⇒ The power factor of a single phase load can be calculated if instruments available are
one voltmeter, one ammeter
two ammeters
two voltmeters
one voltmeter, one ammeter and one wattmeter

⇒ TTL logic is preferred to DRL logic because
greater fan-out is possible
greater logic levels are possible
greater fan-in is possible
less power consumption is achieve

⇒ VSB modulation is preferred in TV because
it reduces the bandwidth requirement to half
it avoids phase distortion at low frequencies
it results in better reception
none of the above

⇒ In an air cored coil, a current of 0.7 A causes a flux of 5 x 10^-6 Wb. If the core is made of cast iron and the coil is similar, the same current can set up a flux of about
5 x 10^-6 Wb
5 x 10^-8 Wb
10^-2 Wb
5 x 10^-4 Wb

⇒ A memory chip has 65536 cells in it. Then
time required to access cell is same as that to access cell 65536
time required to access cell is less than that required to access cell 65536
time required to access cell is more than that required to access cell 65536
either (a) or (b)

⇒ Consider the CMOS circuit shown, where the gate voltage V_G of the n-MOSEFT is increased from zero, while the gate voltage of the p-MOSFET is kept constant at 3 V. Assume that, for both transistor, the magnitude of the threshold voltage is 1 V and the product of the transconductor parameter and the (W/L) ratio, i.e. the quality μC_0x(W/L), is 1mA. V^{-2Both the MOSFET are in saturation region
Both the MOSFET are in triode region
n-MOSFET is in triode and p-MOSFET is in saturation region
n-MOSFET is in saturation and p-MOSFET is in triode region}

⇒ Logic hardware is available only in NAND and NOR.
TRUE
FALSE