Question is ⇒ The correct sequence of parts in klystron amplifier are, Options are ⇒ (A) anode, catcher cavity, cathode, buncher cavity, (B) cathode, buncher cavity, catcher cavity, cavity, (C) anode, buncher cavity, catcher cavity, cathode, (D) cathode, catcher cavity, anode, buncher cavity, (E) , Leave your comments or Download question paper.

Question is ⇒ The correct sequence of parts in klystron amplifier are, Options are ⇒ (A) anode, catcher cavity, cathode, buncher cavity, (B) cathode, buncher cavity, catcher cavity, cavity, (C) anode, buncher cavity, catcher cavity, cathode, (D) cathode, catcher cavity, anode, buncher cavity, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The correct sequence of parts in klystron amplifier are
A.	anode, catcher cavity, cathode, buncher cavity [Wrong Answer]
B.	cathode, buncher cavity, catcher cavity, cavity [Correct Answer]
C.	anode, buncher cavity, catcher cavity, cathode [Wrong Answer]
D.	cathode, catcher cavity, anode, buncher cavity [Wrong Answer]
View Answer 3 -4 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A three-section RC phase shift oscillator has R = 10K ohms and C = 0.001 μF. If the oscillator is to be made variable using the same value of R, what should be the value of capacitor to obtain a frequency if 1 kHz?
636 pF
180 pF
65 pF
30 pF

⇒ If r_e is ac resistance of diode, the Thevenin input impedance of a differential amplifier is
r_e
br_e
2 br_e
0.5 br_e

⇒ When a material becomes a superconductor, its resistivity becomes
very small
zero
about 10% of normal value
about 20% of normal value

⇒ Octal number 12 is equal to decimal number
8
9
10
11

⇒ Each of the following statements regarding frequency modulation is true except
amplitude of the modulated wave remains the same as that of carrier wave
the amount of variation of deviation from the original carrier frequency is determined by the frequency of the modulating signal
the rate at which the frequency of modulated wave varies is determined by the frequency of the modulating signal
frequency of modulated wave increases as the signal voltage increases and vice-versa

⇒ CW Doppler radar is capable of giving accurate measurements of relative velocities.
TRUE
FALSE

⇒ The number of doped regions in PIN diode is
1
2
3
1 or 2

⇒ The first dominant pole encountered in the frequency response of a compensated op-amp is approximately at
5 Hz
10 kHz
1 MHz
100 MHz

⇒ In which of these does thermionic emission occur?
LED
LCD
VF display
None

⇒ A certain network has two ideal voltages sources and a large number of ideal resistances. The power consumed in one of the resistances is 4 W when either of two sources is active and the other source is active and the other source is short circuited. When both sources is short circuited.When both sources are active, the power consumed in the same resistor would be
zero or 16 W
4 W or 8 W
zero or 8 W
8 W or 16 W

⇒ Consider the following statements about DRAM

Page mode read operation is faster than RAS read
RAS input remains active during column address strobe
The row and column addresses are strobed into the internal buffers using RAS and CAS inputs respectively

Which of the above statements are correct?
1 and 3 only
All
1 and 2 only
2 and 3 only

⇒ In 8421 Binary coded Decimal system the decimal number 237 is represented by
1000110111
1000111110
1000110111
10010010011

⇒ The sum S of A and B in a Half Adder can be implemented by using K NAND gates. The value of K is
3
4
5
none of these

⇒

Assertion (A): The capacitance of a reverse biased pin diode is lower than that of reverse biased p-n diode.

Reason (R): A PIN diode has an intrinsic layer between p and n regions.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ In figure if C is replaced by short circuit then R_B wil
425 K
412 K
474 K
400 K

⇒ It is very likely in __________ gate family that when one gate is driving number of gates in __________ , a gate having least voltage for saturation may consume large __________ leaving other gates inoperative and this phenomenon is called __________ .
DTL, parallel, current, current - sinking
DCTL, parallel, current, current-lagging
ECL, series, voltage, voltage-deterioration
DCTL, series, current, current-lagging

⇒ DeMorgan's first theorem shows the equivalence of
OR gate and Exclusive OR gate
NOR gate and Bubbled AND gate
NOR gate and NAND gate
NAND gate and NOT gate

⇒ Consider the following DO statement in Fortran 77 1
11
10
4

⇒ In figure the dc emitter current of each transistor is a
4 mA
2 mA
3 mA
1 mA

⇒ Which of the following is an active device?
Transformer
Silicon controlled rectifier
Electric bulb
Loudspeaker

⇒ A germanium diode has a reverse saturation current of 30 μA at 125°C and forward current of 1 mA at a forward potential of 0.8 V and the reverse potential is 0.6 V What are its dynamic forward and reverse resistance at this temperature.
10.7 Ω, 70 kΩ
34 Ω, 20 kΩ
80 Ω, 20 kΩ
800 Ω, 40 kΩ

⇒ A first order element yields almost exact duplication only for constant or slowly varying phenomenon.
TRUE
FALSE

⇒ In 8086 the word address is
the address of the least significant byte
the address of most significant byte
either (a) or (b) depending on the word
neither (a) nor (b)

⇒ In the given figure shows a root locus plot. Consider the following statements for this plot

The open loop system is a second order system
The system is overdamped for K > 1
The system is stable for all values of K

Which of the above statements are corr
1, 2, 3
1, 3
2, 3
1, 2

⇒ In active filters inductances are divided because they
are always associated with same resistance
are bulky and unsuitable for miniaturization
are non linear
saturate quickly

⇒ TTL is used in electronic calculators.
TRUE
FALSE

⇒ A current wave is i = 100e^-60t The initial and final values of current are
100 and 50
100 and 0
0 and 100
100 and 100

⇒ For the current wave i = 10 + 10 sin θ, the rms value is
0.416666666666667
12.247 A
20 A
14.14 A

⇒ Which of the following statements is not correct for thermistors?
They have negative temperature coefficient of resistance
The sensing element is made of sintered ceramics, which are oxides of metals in the form of beads
The variation of resistance with temperature is linear
The resistance value at ambient temperature may range from 100 Ω to 100 kΩ

⇒ A feedback network to be used with an amplifier to provide oscillation is tested and found to give an output of 0.124 V with a 0.5 V input. What percentage negative feedback should be introduced to the amplifier so that linear oscillations result?
0.0125
0.025
-0.0125
-0.025