Users Also Read

MCQ's Search Engine

Electrical Engineering

Mechanical Engineering

Civil Engineering

Automobile Engineering

Chemical Engineering

Computer Engineering

Electronics Engineering

Medical Science Engg

Q1. | The correct relation between energy and charge is |

A. | Energy = voltage/charge [Wrong Answer] |

B. | Charge = Energy x voltage [Wrong Answer] |

C. | Energy = voltage (charge)^{0.5} [Wrong Answer] |

D. | Energy = voltage x charge [Correct Answer] |

View Answer
Explanation:-
Answer : DDiscuss it below :!! OOPS Login [Click here] is required to post your answer/resultHelp other students, write article, leave your comments |

**Also Read Similar Questions Below :**

⇒ The capacitance of a cylindrical capacitor is directly proportional to its length.

TRUE

FALSE

⇒ (2)

_{3}+ (3)

_{4}= (?)

_{5}

4

11

none of these

not possible

⇒ Choose correct option

var (X + Y) = Var (X) + Var (Y)

var (X - Y) = Var (X) + Var (Y)

var (X + Y) = Var (X) x Var (Y)

Both (a) and (b)

⇒ From the noise point of view, bandwidth should

be large

not be too large

should be as large as possible

should be infinite

⇒ Both OR and AND gates can have only two inputs.

TRUE

FALSE

⇒ A network has 10 nodes and 17 branches. The number of different node pair are

7

9

10

45

⇒ Which of the following flip-flop is used as a latch?

J K flip-flop

R S flip-flop

T flip-flop

D flip-flop

⇒ If operator '

*a*' = 1 ∠120° then (1 +

*a*

^{2}) =

3

3 ∠30°

3 ∠ - 30°

3 ∠60°

⇒ A dipole antenna was radiating with some excitation in free space radiating a certain amount of the power. If this antenna is immersed in a lake where water is non-dissipative but has a dielectric constant of 81, the radiated power with the same excitation will

decrease to finite non-zero value

remain the same

increase

decrease to zero

⇒ In which of the following case the rating of the transformer to deliver 100 watts of d.c. power to a load, will be least?

Half wave rectifier

Full wave rectifier

Bridge type full wave rectifier

Three phase full wave rectifier

⇒ Assuming accumulator contain A 64 and the carry is set (1). What will register A and (CY) contain after ACI 0 A4 H?

4 AH, 0

4 AH, 1

4 BH, 0

4 BH, 1

⇒ The damping ratio of a pair of complex poles when expressed in terms of angle θ measured from

*j*ω axis equal to

sin θ

cos θ

tan θ

cot θ

⇒ Fortran 77, C and Pascal are high level languages.

TRUE

FALSE

⇒ Which one of the following is an active component?

Diode (

*p*-

*n*)

Transistor as Amplifier

Transformer

Inductor

⇒ In the circuit of fi

V

_{a}would always lag V

_{b}

V

_{a}would always lead V

_{b}

V

_{a}and V

_{b}would always be in phase

V

_{a}may lag or lead V

_{b}

⇒ The op-amp used in nonlinear mode is

integrators

active filters

Schmitt triggers

instrumentation amplifiers

⇒ The thin parallel wires are carrying current along the same direction. The force experienced by one due to the other is

parallel to the lines

perpendicular to the lines and attractive

perpendicular to the lines and repulsive

zero

⇒ In order to receive a vertical polarized wave, the conductor of the dipole should be mounted

horizontally

vertically

at an angle of 45°

at an angle of 90°

⇒ Consider the following statem

1 alone

2 alone

3 alone

1 and 3

⇒ The magnitude of transport lag factor is always zero.

TRUE

FALSE

⇒ Which of these has highly doped

*p*and

*n*region?

PIN diode

Tunnel diode

Schottky diode

Photodiode

⇒ The relation between thermal conductivity K (W/m/°C), heat flow density Q (watt/m

^{2}) and

*d*T/

*dx*(°C per metre) is

Q = K(

*d*T/

*dx*)

Q = - K(

*d*T/

*dx*)

K = Q(

*d*T/

*dx*)

*d*T/

*dx*= - QK

⇒ As regards ∈

_{0}and ∈

_{r}(absolute and relative permittivity)

both ∈

_{0}and ∈

_{r}can be interpreted in terms of atomic properties of medium

only ∈

_{r}can be interpreted in terms of atomic properties of medium

only ∈

_{0}can be interpreted in terms of atomic properties

∈

_{r}has no physical significance

⇒ If

*f*is more than

*f*

_{unity}the gain of op-amp becomes less than 1.

TRUE

FALSE

⇒

**Assertion (A):** Hall effect is observed in all metals but is very appreciable in semiconductors.

**Reason (R):** Hall effect transducer is very suitable for measurement of magnetic flux density.

Both A and R are true and R is correct explanation of A

Both A and R are true but R is not correct explanation of A

A is true R is false

A is false R is true

⇒ The silicon sample with unit cross-sectional area shown below is in thermal equilibrium. The following information is given: T = 300 K, electronic charge = 1.6 x 10

^{-19}C, thermal voltage = 26mV and electron mobility = 1350 cm

^{2}

2.16 x 10

^{4}A/cm

^{2}

1.08 x 10

^{4}A/cm

^{2}

4.32 x 10

^{3}A/cm

^{2}

6.48 x 10

^{2}A/cm

^{2}

⇒ A lag compensator provides attenuation in

very low frequency range

low frequency range

high frequency range

none of the above

⇒ A NAND gate has 3 inputs and one output. The number of thyristors required for this gate are

1

2

3

3 or 4

⇒ In the NMOS inverter

the driver and achieve load are enhancement type

the driver is enhancement type and load depletion type

both driver and load are depletion type

the driver and load are depletion type

⇒ A current 10 sin (200

*t*) A flows through a 5 mH inductance. The expression for voltage is

10 sin (200

*t*+ 90°)

10 sin (200

*t*- 90°)

10 sin(1000

*t*+ 90°)

10 sin (1000

*t*- 90°)