Question is ⇒ The contents of the commands register are 23 H. Then port C, Options are ⇒ (A) is an input port, (B) is an output port, (C) is both input as well as output port, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ The contents of the commands register are 23 H. Then port C, Options are ⇒ (A) is an input port, (B) is an output port, (C) is both input as well as output port, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The contents of the commands register are 23 H. Then port C
A.	is an input port [Correct Answer]
B.	is an output port [Wrong Answer]
C.	is both input as well as output port [Wrong Answer]
D.	none of the above [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A signal with ± 10 V ranged and 1 KHz band width is being digitized using a sample and hold circuit and a 10 bit quantizer. The quantization step is :
1 x 10^-9 V
5 x 10^-9 V
2.5 x 10^-9 V
0.5 x 10^-9 V

⇒ The internal structure of PL A is similar to
RAM
ROM
both RAM and ROM
neither RAM nor ROM

⇒

Hall coefficient R_H is directly proportional to the charge density
R_H depends upon type of the semiconductor material (n - type or p - type)
Hall co-efficient R_H is directly proportional to hall voltage V_H

From the above statements which are the false statements?
I only
II only
III only
all of the above

⇒ In a CE amplifier circuit, the output voltage
is very small
is always constant
depends on β
none of the above

⇒ In figure, the function of resistor
to reduce ripples in the output
to improve voltage regulation
to limit the surge current
either (a) or (c)

⇒ Digital technologies being used now-a-days are
DTL and EMOS
TTL, ECL, CMOS and RTL
TTL, ECL and CMOS
TTL, ECL. CMOS and DTL

⇒ Antenna is a __________ element
passive
active
resistive
capacitive

⇒ If f_h(t) is the Hilbert transform of f(t), and f(t) is a real valued signal, the pre-envelope of f(t) is
f(t) - jf_h(t)
f(t) + jf_h(t)
f_h(t) + jf(t)
f_h(t) - jf(t)

⇒ In CE approximately, the active region is where the collector curves are
almost horizontal
almost vertical
inclined at 45°
inclined at 60°

⇒ Consider the following statement in Fortran 77 3 values would be read and stored in X (0), X (1), X (2)
4 values would be read and stored in X (0), X (1), X (2), X (3)
5 values would be read and stored in X (0), X (1), X (2), (3)(4)
5 values would be read and stored in X (I), X (2), X (3), X (4), X (5)

⇒ A higher directivity is specified by
high gain low BW (Beamwidth)
high gain high BW
low gain high BW
none of the above

⇒

Assertion (A): McMurray Bredford half bridge inverter uses complementary commutation

Reason (R): Three phase inverter can have two modes of operation.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒

Assertion (A): In C a variable name can have upto 8 characters and special symbols can also be part of variable name.

Reason (R): In C a type declaration at the beginning of program indicates the type of variable name used in the program.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒

Match the following:

	List I		List II
A.	R_T	1.	A = D
B.	R_h	2.	h₁₂ = h₂₁
C.	S_T	3.	AD - BC = 1
D.	S_h	4.	h₂₁ = - h₂₁
		5.	B = C
		6.	Δh = 1

A-3, B-4, C-1, D-6
A-3, B-2, C-5, D-4
A-5, B-4, C-1, D-2
A-5, B-4, C-1, D-6

⇒ The output voltage of a charger is
less than battery voltage
same as battery voltage
more than battery voltage
same or more than battery voltage

⇒ A + A . B =
B
A . B
A
A or B

⇒ The graph of a network has 6 branches with 3 tree branches. The minimum number of equations required for solution of network is
2
3
4
5

⇒ The clear data and present input of the JK flip-flop are known as
direct inputs
synchronous inputs
indirect inputs
either direct inputs or synchronous inputs

⇒

Assertion (A): In FM the frequency of the carrier is varied by the modulating voltage

Reason (R): FM and PM are two forms of angle modulation.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ In low power factor wattmeter, the pressure coil is connected
to the supply side of current coil
to the load side of current coil
in either (a) or (b)
across the mains

⇒ An amplifier operating over a frequency range of 18 to 20 MHz has 10 kΩ input resistance. At a temperature of 27° C, the noise voltage at input of amplifier is (Boltzman constant k = 1.38 x 10^-23 J/K)
18.2 μV
182 μV
16.2 μV
162 μV

⇒ Which of the following is used to provide tracking between RF amplifier and local oscillator stages of receiver?
Variable tuning inductor
Ganged tuning inductor
Variable capacitor
Variable preset

⇒ A full adder has two outputs SUM and CARRY.
TRUE
FALSE

⇒ For the design of a sequential circuit having 9 states, minimum number of memory elements required is
3
4
5
9

⇒ Leak type bias is used in a plate-modulated class C amplifier to
prevent tuned circuit damping
prevent over modulation
increase the bandwidth
prevent excessive grid current

⇒ The function (sin x)/x
has a period 2p, decays with increasing x and has zeros at np, n = ± 1, ± 2
has a period p
has a period p/2
has a period 2p, decays with increasing x, is an even function and has zeros at np, n = ± 1, ± 2

⇒

Assertion (A): When an SCR is conducting, the voltage drop across is about 1 V.

Reason (R): When an SCR is conducting, the junction temperature is about 200°C.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The function to Calculate the maximum value in the specified field of a database is
DM
DMAX
MAX
DBMAX

⇒ For a low level AM system, the amplifiers modulated stage must be
linear devices
harmonic devices
class C amplifiers
non-linear devices

⇒ An electrically neutral semiconductor has
no free charges
no majority carriers
no minority carriers
equal number of positive and negative charges