Question is ⇒ The conductivity of an intrinsic semiconductor is (symbols have the usual meanings)., Options are ⇒ (A) generally less than that a doped semiconductor, (B) σi = eni (μn - μp), (C) σi = eni (μn + μp), (D) σi = ni (μn - μp), (E) , Leave your comments or Download question paper.

Question is ⇒ The conductivity of an intrinsic semiconductor is (symbols have the usual meanings)., Options are ⇒ (A) generally less than that a doped semiconductor, (B) σi = eni (μn - μp), (C) σi = eni (μn + μp), (D) σi = ni (μn - μp), (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The conductivity of an intrinsic semiconductor is (symbols have the usual meanings).
A.	generally less than that a doped semiconductor [Wrong Answer]
B.	σ_i = en_i (μ_n - μ_p) [Wrong Answer]
C.	σ_i = en_i (μ_n + μ_p) [Correct Answer]
D.	σ_i = n_i (μ_n - μ_p) [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In the circuit, S was initially open. At time t = 0, S is closed. When the current through the inductor is 6 A, the rate of change of current through the resistor is 6 A/s. The value of the inductor woul
1 H
2 H
3 H
4 H

⇒ The thermal resistance of a BJT is about
100° C/W
200° C/W
20° C/W
2° C/W

⇒

Assertion (A): Megger is used to check insulation resistance of cables.

Reason (R): Insulation resistance of cables is very high.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒

Assertion (A): An electrostatic voltmeter is free from hysteresis and eddy current errors.

Reason (R): An electrostatic voltmeter has a number of fixed and moving vanes in parallel.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ The amount of photoelectric emission current depends on
frequency of incident radiation
intensity of incident radiation
both frequency and intensity of incident radiation
none of the above

⇒ Which of the following flip-flop is used as a latch?
J K flip-flop
R S flip-flop
T flip-flop
D flip-flop

⇒ A microcomputer has memory locations from 0000 to FFFF, each storing 1 byte. How many bytes can be the memory store?
12333
14666
16384
16655

⇒ It is desired to route data from many registers to one register. The device needed is
decoder
multiplexer
demultiplexer
counter

⇒ For a current transformer, the standard secondary rating is
1 A or 5 A
2.5 A
0.416666666666667
5 A or 10 A

⇒ When a 10 K, 10%, 1/4 Ω resistor is connected in series with a 12 K, ± 1%, 1/4 Ω resistor, the resulting combination has the following specifications
22 K, ± 11%, 1/2 Ω
22 K, ± 5.5%, 1/2 Ω
22 K, ± 5.5%, 1/8 Ω
none of these

⇒ Which of the following instruments has non-linear scale?

Moving coil instrument
Moving iron instrument
Electrostatic instrument
Rectifier instrument

Select the answer as per following codes
2 only
2 and 3 only
2, 3 and 1
1, 2, 3 and 4

⇒ If a transistor is operating with both of its Junctions forward biased, but with the collector base forward biased, but with the collector base forward bias greater than the emitter-base forward bias, then it is operating in the
forward active mode
reverse saturation mode
reverse active mode
forward saturation mode

⇒ Tesla is a unit of
flux
field strength
flux density
MMF

⇒ A 1000 kHz carrier wave modulated 40% at 40000 Hz is applied to a resonant circuit tuned to a carrier frequency and having Q = 140. What is the degree of modulator after transmission through the circuit?
0.4
0.2
0.27
0.54

⇒ In a system an input resistance of 20 kΩ causes a noise voltage of 15μV. If two such input resistances each of 20 kΩ are used in parallel, the total noise voltage will be about
15 μV
30 μV
7.5 μV
10.6 μV

⇒ Which of the following ICs has only one NAND gate?
7410
7420
7430
7447

⇒ A 60 W, 23 V bulb is used for 45 minutes. The electrical energy consumed in commercial units is
2700 units
0.45 units
4.5 units
0.045 units

⇒ The disadvantage of FM over AM is that
high output power is needed
high modulating power is needed
noise is very high for high frequency
large bandwidth is required

⇒ A germanium diode has a reverse saturation current of 30 μA at 125°C and forward current of 1 mA at a forward potential of 0.8 V and the reverse potential is 0.6 V What are its dynamic forward and reverse resistance at this temperature.
10.7 Ω, 70 kΩ
34 Ω, 20 kΩ
80 Ω, 20 kΩ
800 Ω, 40 kΩ

⇒ Which of the following microphones has highest output impedance?
Carbon
Ribbon
Crystal
Condenser

⇒

Match the following:

	List I (Digital circuit)		List II (Circuit type)
A.	BCD to 7 segment decoder	1.	sequential circuit
B.	4-to-1 MUX	2.	combinational circuit
C.	4 bit shift register	3.	neither sequential nor combinational circuit

A-2, B-1, C-2, D-1
A-3, B-2, C-1, D-3
A-2, B-2, C-1, D-1
A-3, B-1, C-2, D-3

⇒ A signal having uniformly distributed amplitude in the interval (- V to + V) is to be encoded using PCM with uniform quantization. The signal to quantization noise ratio is determined by
dynamic range of signal
sampling rate
number of quantizing levels
power spectrum of signal

⇒ In the interconnection of ideal sources shown in the figure, it is known that the 60V source is absorbing p
0.416666666666667
13 A
15 A
18 A

⇒ The maximum current and voltage ratings for a 0.5 W, 10 kW resistor are
7.07 mA and 70.7 V
70.7 mA and 70.7 V
0.707 mA and 70.7 V
7.07 mA and 70.7 x 10³ V

⇒ Some features of advanced mobile phone service are

To provide telephone communication to a large number of telephone users within the area of a metropolitan only
To use minimum amount of frequency spectrum
To permit hand held as well as vehicle operation of telephone

Which of the above are true?
1 and 2 only
1, 2, 3
1 and 3 only
2 and 3 only

⇒ In a Communication system, noise is most likely to affect the signal.
at the transmitter
In the channel
in Information source
at the destination

⇒ High IF in a superheat receiver
improves selectivity
increases tracking problems
decreases tracking problems
reduces adjacent channel rejection

⇒ Almost all high level languages have provision for logical operations.
TRUE
FALSE

⇒ An FM signal with a deviation δ is passed through a mixer, and has its frequency reduced 5 fold. The deviation in the output of the mixer is
5/δ
Intermediate
δ/5
δ

⇒ For use at 50 Hz the range of scale of vibrating reed frequency meter is
25 - 75 Hz
40 - 60 Hz
47 - 53 Hz
42 - 58 Hz