Question is ⇒ The colour code on a carbon resistor is red-red-black-silver. The value of resistor is, Options are ⇒ (A) 22000 Ω, (B) 2200 Ω, (C) 22 ± 5% Ω, (D) 22 ± 10% Ω, (E) , Leave your comments or Download question paper.

Question is ⇒ The colour code on a carbon resistor is red-red-black-silver. The value of resistor is, Options are ⇒ (A) 22000 Ω, (B) 2200 Ω, (C) 22 ± 5% Ω, (D) 22 ± 10% Ω, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The colour code on a carbon resistor is red-red-black-silver. The value of resistor is
A.	22000 Ω [Wrong Answer]
B.	2200 Ω [Wrong Answer]
C.	22 ± 5% Ω [Wrong Answer]
D.	22 ± 10% Ω [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Assertion (A): The turn on time of SCR is about 1 to 4 ms.

Reason (R): The turn off time of SCR is about 10 to 300 ms.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Dielectric materials have high specific resistance.
TRUE
FALSE

⇒ Binary number 11001 is equivalent to decimal number
35
15
105
25

⇒ The input to ALU are the contents of accumulator and temporary register.
TRUE
FALSE

⇒ In a carbon-zinc cell the function of the depolarizer is that
it synthesizes the decomposed electrolyte
it converts the produced hydrogen into water
it absorbs the oxygen produced in the cell
it prevents the fast chemical action on the zinc container

⇒ A reflex klystron oscillator is a
low power device
high power device
high efficiency device
both (a) and (b)

⇒ The dynamic resistance of a forward biased p-n diode
varies inversely with current
varies directly with current
is constant
is either constant or varies directly with current

⇒ The ionosphere plays a significant role in radio wave propagation at
high frequency
ultra-high frequencies
microwave frequency
optical frequencies

⇒

Assertion (A): Positive feedback is not used in any circuit.

Reason (R): Positive feedback leads to instability.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ The silicon sample with unit cross-sectional area shown below is in thermal equilibrium. The following information is given: T = 300 K, electronic charge = 1.6 x 10^-19C, thermal voltage = 26mV and electron mobility = 1350 cm²
1 kV/cm
5 kV/cm
10 kV/cm
26 kV/cm

⇒ T.V. antennas are usually
Yagi-Uda
loops
helical
parabolic

⇒

Assertion (A): Radar gave birth to microwave technology.

Reason (R): In radar systems very high frequencies give the most accurate results.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ An intrinsic silicon sample has 2 million free electrons. The number of holes in the sample is
2 million
almost zero
more than 2 million
less than 2 million

⇒ If frames are repeated at 60 Hz and each frame has 525 lines, the time for scanning one horizontal line (for progressive scanning and no interlacing) is about
320 μs
32 μs
3.2 μs
0.32 μs

⇒ The signumm function written as [sgn(t)] is defined as
sgn(t) = - 1 for t < 0, = 0 for t = 0 and = 1 for t > 0
sgn(t) = 1 for t < 0, = 0 for t = 0 and = - 1 for t > 0
sgn(t) = 0 for t < 0, = 1 for t = 0 and = 0 for t > 0
sgn(t) = 0 for t < 0, = 1 for t³ 0

⇒ In the circuit of figure, the switch is closed at t = 0 with i_L (0) = 0 and V_C (0) = 0. In the steady state n_c equ
100 v
0 v
∞
- 100 v

⇒ The widely used binary multiplication method is
repeated addition
add and shift
shift and add
any of the above

⇒ In 8085 microprocessor system, what will be the total delay provided by the following loop.3.154 msec
3.514 msec
2.644 msec
3.166 msec

⇒ A non-inverting voltage feedback amplifier is a
voltage amplifier
current amplifier
current to voltage converter
voltage to current converter

⇒ The voltage induced in a loop of wire rotating in a strong and steady magnetic field is
pulsating dc
dc
rectified ac
ac

⇒ The function shown in the given Figure can be writte
sum of two sinusoidal functions
sum of two sinusoidal functions one originating at t = 0 and the other at t = 1
difference of two sinusoidal functions one originating at t = 0 and the other at t = 1
none of the above

⇒ The cut in voltages for germanium and silicon diodes respectively as
0.3 V and 0.7 V
0.7 V and 0.3 V
0.6 V and 0.9 V
0.5 V and 0.7 V

⇒ Final value theorem is used to find
steady state value of system output
initial value of output
transient beaviour of output
none of these

⇒ The factor η for a UJT is about
0.1
0.2
0.6
0.9

⇒ In a N-P-N transistor, when emitter junction is forward biased and collector junction is reverse biased the transistor will operate in
active region
saturation region
cut-off region
inverted region

⇒ Which of the following identifiers is invalid in Pascal?
BETA
MAX 40
2ND
A MAX

⇒ An FM signal has modulating frequency f_m and maximum frequency deviation of δ. The bandwidth will be nearly equal to
δ
2 δ
2f_m δ
f_m δ

⇒ Two rectangular waveforms of duration t₁ and t₂ seconds are convolved. What is the shape of the resulting waveform?
Triangular
Rectangular
Trapezoidal
Semi-circular

⇒ In a 4 input OR gate, the total number of High outputs for the 16 input states are
16
15
14
13

⇒

Assertion (A): A p-n junction is used as rectifier.

Reason (R): A p-n junction has low resistance in forward direction and high resistance in reverse direction.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true