Question is ⇒ The clock shown in figure has a frequency of 6 MHz. The frequency of the Q output wil, Options are ⇒ (A) 12 MHz, (B) 24 MHz, (C) 3 MHz, (D) 1.5 MHz, (E) , Leave your comments or Download question paper.

Question is ⇒ The clock shown in figure has a frequency of 6 MHz. The frequency of the Q output wil, Options are ⇒ (A) 12 MHz, (B) 24 MHz, (C) 3 MHz, (D) 1.5 MHz, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The clock shown in figure has a frequency of 6 MHz. The frequency of the Q output wil
A.	12 MHz [Wrong Answer]
B.	24 MHz [Wrong Answer]
C.	3 MHz [Correct Answer]
D.	1.5 MHz [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : Po Said on 2022-06-13 09:40:03 con di me m !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The number of flip-flops required to build a mod-19 counter is
4
5
6
7

⇒ Two 16 : 1 and one 2 : 1 multiplexers can be connected to form a
16 : 1 multiplexer
32 : 1 multiplexer
64 : 1 multiplexer
8 : 1 multiplexer

⇒ Which of the following statement regarding single-sideband (SSB) transmission is not correct?
In such transmission only or sideband is transmitted, leaving of the other sideband and the carrier
It has gained general acceptance of use in home-entertainment equipment
It is generally reserved for point-to-point communication
The amount of power and bandwidth necessary to be transmitted for a given amount of information are appreciable reduced

⇒ A buffer is a device that isolates other devices. Typically a buffer has
a high input impedance and a low output impedance
a high input impedance as well as output impedance
a low input impedance and a high output impedance
a low input impedance as well as output impedance

⇒ In a full wave diode rectifier circuit each diode carries current for
90° in each cycle
180° in each cycle
270° in each cycle
360° in each cycle

⇒ An RL impedance function can also be realized as
RC impedance function
RC admittance function
LC impedance function
LC admittance function

⇒ In a horizontal polarized wave
magnetic field is perpendicular to ground
magnetic field component is parallel to ground
electric field component is perpendicular to ground
electric field is parallel to ground

⇒ The main purpose of using transformer coupling in a class A amplifier is to make it more
efficient
less costly
less bulky
distortion free

⇒ Which of the following is not a valid variable name in C?
p_ce1
1p_ce
p1_ce
p _ced

⇒ The wave applied to X plates, for ohtaining trace of voltage wave, is
sawtooth wave
sinusoidal wave
rectangular wave
either (a) or (c)

⇒ Which of the following conditions should be satisfied to call an astable multivibrator circuit using discrete components as a digital circuit?

A flip-flop is always a digital circuit.
Only when we assign 1 and 0 to the high and low levels of the output, a flip-flop is called a digital circuit.
Only if the power, supply voltage is maintained at + 5 V or - 5 V, it is called a digital circuit.
Only if it is in IC form, following the technology of IC manufacture, it is called a digital circuit.

Select the correct answer from the codes given below:
1 only
2 and 3
2 only
3 and 4

⇒

Assertion (A): An electronic tuner uses varactor diode

Reason (R): The capacitance of a varactor diode depends on the magnitude of reverse bias.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Which of the following are difficult to be fabricated in a monolithic IC?
Inductors
Large capacitors
Small capacitors
Both (a) and (b)

⇒ A 16 bit type ADC uses 1 MHz clock its maximum conversion time is __________ .
16 μs
15 ms
6.5 ms
66 ms

⇒ The no. of comparators required in a 3 bit comparator type ADC is
2
3
7
8

⇒ The 8085 instruction LDA FFA is an example of
Direct addressing
Register addressing
Immediate addressing
Register indirect addressing

⇒ Consider an incremental vector element of length ΔL and angle between an electric field E and ΔL s cos &the
In the direction of E
In opposite direction of E
In the angle of 45° with E
In the angle of 60° with E

⇒ If S represents the carrier synchronization at the receiver and r represents the bandwidth efficiency, then the correct statement for the coherent binary PSK is
r = 0.5, S is required
r = 1.0, S is required
r = 0.5, S is not required
r = 1.0, S is not required

⇒ Which of these instrument does not have a control spring?
Moving iron ammeter
PMMC ammeter
Electrostatic voltmeters
Power factor meter

⇒ The phenomenon known as "Early effect" in a BJT refers to a reduction of the effective base width caused by
electron-hole recombination at the base
reverse biasing of the base collector junction
forward biasing of emitter base junction
the early removal of stored base charge during saturation to cut off switching

⇒ A rhombic antenna is a
resonant antenna
non-resonant antenna
coupled antenna
none of the above

⇒ Which of the following is a valid expression in FORTRAN 77?
B * - 3
B * (- 3)
B * * - 3
B * + 2

⇒ For an amplifier, the coupling method which gives the highest gain in
impedance coupling
transformer coupling
capacitance coupling
resistance coupling

⇒ A square corner reflector is used in
radio astronomy
tv broadcast
point to point communication
all of the above

⇒ The resistance of series field winding is a low resistance.
TRUE
FALSE

⇒ Consider the following statements:

Taking 2's complement is equivalent to sign change.
In the 2's complement representation the most significant bit (MSB) is zero for a positive number.
In a 4 bit binary representation of a binary number A, A + 1's complement of A = 2⁴.

Which of the above statements are correct?
1 and 2 only
1 and 3 only
2 and 3 only
1, 2 and 3

⇒ What does a link budget for satellite communication include?
Total cost of satellite
Cost of satellite plus launch vehicle
Signal and noise levels is dB
Margins of error permitted

⇒ The power required to produce a gain of 10 dB over 4 W of original power is __________ watt.
80
40
0.4
8

⇒ A Schottky diode clamp is used along with switching BJT for
reducing the power dissipation
reducing the switching time
increasing the value of β
reducing the base current

⇒ In a half wave voltage doubler circuit the input frequency is 50 Hz. The ripple frequency is
25 Hz
50 Hz
100 Hz
150 Hz