Question is ⇒ The circuit whose properties are same in either direction is known as, Options are ⇒ (A) unilateral circuit, (B) bilateral circuit, (C) irreversible circuit, (D) reversible circuit, (E) , Leave your comments or Download question paper.

Question is ⇒ The circuit whose properties are same in either direction is known as, Options are ⇒ (A) unilateral circuit, (B) bilateral circuit, (C) irreversible circuit, (D) reversible circuit, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The circuit whose properties are same in either direction is known as
A.	unilateral circuit [Wrong Answer]
B.	bilateral circuit [Correct Answer]
C.	irreversible circuit [Wrong Answer]
D.	reversible circuit [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ An 8085 executes the following instructionsPC = 2715 H HL = 30A0 H
PC = 30A0H HL = 2715H
PC = 6104 H HL = 6140 H
PC = 6140H HL = 2715H

⇒ A binary with a digits, all of which are unity has the value
n² - 1
2ⁿ
2(^{n - 1})
2ⁿ - 1

⇒ In FM, the frequency deviation is
always constant
directly proportional to modulating frequency
inversely proportional to modulating frequency
proportional to amplitude of modulating signal

⇒ The number of valence electrons in trivalent impurity is
5
4
3
1

⇒ FM has poor efficiency than
AM
AM-SC
PAM
PCM

⇒ Find 'X' in the circuit be
∏(0, 1, 2, 3, 4, 5, 6, 7, 8, 9, 10, 11, 12, 13, 15)
0
Σ(14)
1

⇒ The value of 2⁵ in octal system is
40
20
100
200

⇒ In a magnetron the magnetic flux density is of the order of
1 mWb/s
1 Wb/m²
10⁶ m/s
10¹² m/s

⇒ How many roots with positive real parts do the equation s³ + s² - s + 1 = 0 have?
Zero
One
Two
Three

⇒ In 8085 microprocessor, if interrupt service requests have been received from all of the following interrupts, then which one will be serviced first?
RST 5.5
RST 6.5
RST 7.5
None

⇒ In using Nyquist stability criterion it is not necessary to determine closed loop poles.
TRUE
FALSE

⇒ The input impedance of a non-inverting amplifier is very low.
TRUE
FALSE

⇒ The Hall constant in Si bar is given by 5 x 10³ cm³/ coulomb, the hole concentration in the bar is given by
10⁵/cm³
1.25 x 10¹⁵/cm³
1.5 x 10¹⁵/cm³
1.6 x 10¹⁵/cm³

⇒ For AM receivers the standard IF frequency is
106 kHz
455 kHz
1.07 MHz
10.7 MHz

⇒ An m derived low pass filter has f_c = 1000 Hz, f_∞ = 1250 Hz and m = 0.6. If m is increased, then
both f_c and f_∞ will increase
both f_c and f_∞ will decrease
f_c will remain constant but f_∞ will decrease
f_c will remain constant but f_∞ will increase

⇒ Assuming a minimum angle of elevation of 5°, a geosynchronous satellite remains in line-of-sight for __________ percentage of Earth's surface.
30.3
42.4
50
25

⇒ The ripple factor of a full wave rectifier is about 0.5
TRUE
FALSE

⇒ The current I flowing in the branc
-12 A
0
0.125
-3 A

⇒ The circuit of the figure is an example of feedback of the following
current series
current shunt
voltage series
voltage shunt

⇒ The minterm designation for ABCD is
m₁₁
m₁₃
m₁₅
m₁₆

⇒ If E_b is the potential of accelerating anode, the energy of electrons as they emerge from electron gun is proportional to
E_b
E_b
E_b^1.5
E_b²

⇒ Out of Metal-film type and Carbon-film type, the one with better tolerance specification is
carbon-film
metal-film type
both have same tolerance
none of these

⇒ A colour monitor usign 16 bits at a resolution of 600 x 400 pixels needs a memory of
240000 B
9600 B
6400 B
480000 B

⇒ For a photoconductor with equal electron and hole mobilities and perfect ohmic contacts at the ends, an increase in illumination results in
a change in O.C. voltage
a change in S.C. current
a decrease in resistance
an increase in resistance

⇒ If N = 196, the result of the following program will be 196
16
16
196

⇒ When sources of different frequencies feed a network the only method of solution is superposition theorem.
TRUE
FALSE

⇒ In a linear op-amp circuit
the product of gain and bandwidth is constant
input can be dc only
input can be ac only
saturation may occur

⇒ What is the purpose of DMA facility in microprocessor based system?
To increase the speed of data transfer between the mP and the I/O devices
To increase the speed of data transfer between the mP and the memory
To increase the speed of data transfer between the memory and the I/O devices
To improve the reliability of the system

⇒ The scaling factor of an MOS device using constant voltage scaling model, the gate area of the device will be scaled as
1/a
1/a²
1/a³
1/a⁴

⇒ A series RLC circuit has a resonant frequency of 1000 Hz. The maximum voltage across C is likely to occur at a frequency of about
1000 Hz
2000 Hz
1025 Hz
975 Hz