Question is ⇒ The circuit shown in the figure conv, Options are ⇒ (A) BCD to Binary code, (B) Binary to excess - 3 code, (C) Excess - 3 to Gray, (D) Gray to Binary, (E) , Leave your comments or Download question paper.

Question is ⇒ The circuit shown in the figure conv, Options are ⇒ (A) BCD to Binary code, (B) Binary to excess - 3 code, (C) Excess - 3 to Gray, (D) Gray to Binary, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The circuit shown in the figure conv
A.	BCD to Binary code [Wrong Answer]
B.	Binary to excess - 3 code [Wrong Answer]
C.	Excess - 3 to Gray [Wrong Answer]
D.	Gray to Binary [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Electrons within a metal have energy levels from zero to Fermi level E_F.
TRUE
FALSE

⇒ Wienbridge oscillator uses
-ve feedback
+ve feedback
both +ve, -ve feedback
feedback is not required

⇒

Assertion (A): The steady state response, of a stable, linear, time invariant system, to sinusoidal input depends on initial conditions.

Reason (R): Frequency response, in steady state, is obtained by replacing s in the transfer function by jω

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ A carrier is phase modulated (PM) with frequency deviation of 10 kHz by a single tone frequency of 1 kHz. If the single tone frequency is increased to 2 kHz, assuming that phase deviation remains unchanged, the bandwidth of the PM signal is
21 kHz
22 kHz
42 kHz
44 kHz

⇒ Which one of the following is true?
Alternating voltage and current contain odd and even harmonics
The inductance in a circuit reduces the effect of harmonics and makes current wave more sinusoidal than voltage wave
Alternating voltage and current waveforms, in general, do not contain odd harmonics
Inductance of a circuit does not alter wave shape at all

⇒

Assertion (A): A binary number is a string of zeros and ones only

Reason (R): The base in a binary system is 2

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ A meter coil has a resistance of 100 Ω and a full scale deflection current of 10 mA. To convert it into a voltmeter of 0-200 V range, the series resistance should be
20 kΩ
19.9 kΩ
1.9 kΩ
20.1 kΩ

⇒ In a semiconductor avalanche breakdown occurs when
reverse bias exceeds the limiting value
forward bias exceeds the limiting value
forward current exceeds the limiting value
potential barrier is reduced to zero

⇒ In an n-p-n transistor, the majority carriers in the base are
electrons
holes
both holes and electrons
either holes or electrons

⇒ Turn on time of a transistor switch is equal to sum of (where t_r is rise time, t_d is delay time)
t_s - t_r
t_s - t_f
t_d + t_r
2t_r

⇒ The value of susceptibility in case of vacuum is taken as
zero
0.5
unity
infinity

⇒ A resistor is rated at 0.75 watt, 1 kΩ. Its current rating is
1 mA
27.386 mA
1.268 mA
5.393 mA

⇒ Find R_L for maximum power tran
3 Ω
1.125 Ω
4.17 Ω
none

⇒ Which of the following couplings may cause unwanted clamping?
Resistive
Inductive
Capacitive
Both (a) or (b)

⇒ In the following transistor circuit V_BE = 0. 7 V, r_c = 25mV/I_E, and β and the capacitance are very l
1 mA
2 mA
5 mA
10 mA

⇒ If operator 'a' = 1 ∠120° then (1 - a) =
3
3 ∠ - 30°
3 ∠ + 30°
3 ∠60°

⇒ A liquid has N permanent dipoles μ_p per unit volume and has been subjected to dc field for a long time such that orientation polarization is P₀. At t = 0, the field is suddenly removed, then polarization
will remain constant at P₀
will become zero at t = 0
will delay to zero with a time constant
either b or c

⇒ Which of the following describe the correct properties of an emitter follower circuit?

It is a voltage series feedback circuit.
It is a current series feedback circuit.
Its voltage gain in less than unity.
Its output impedance is very low.

Select the correct answer from the codes given below:
1, 3 and 4
2, 3 and 4
2 and 3 only
2 and 4 only

⇒ Effect of loading of line is
increase in Z₀, a and β
increase in Z₀ and β but decrease in a
decrease in Z₀, a and β
decrease in Z₀ and β but increase in a

⇒ In a RS flip-flop no change occurs during
prohibited mode
set mode
reset mode
disable mode

⇒ Rise time in a transistor is change from
10% of its final value to 90% of its final value
0% of its final value to 90% of its final value
10% of its final value to 100% of its final value
10% to its final value to 50% of its final value

⇒ The radiation pattern of a parabola antenna is
omnidirectional
a figure of directional
highly directional
none of the above

⇒ Speech amplifiers are usually operated as
class A
classes AB
class B
class C

⇒ The signal flow graph of a system is shown in the given figure. The effect of disturbance T_D can be reduce
increasing G₂ (s)
decreasing G₂ (s)
increasing G₁ (s)
decreasing G₁ (s)

⇒ Consider the z-transform X(z) = 5z² + 4z^-1 + 3; 0 < |z| < ∞ The inverse transform x[n] is
5δ[n + 2] + 3δ[n] + 4δ[n - 1]
5δ[n - 2] + 3δ[n] + 4δ[n + 1]
5u[n + 2] + 3u[n] + 4u[n - 1]
5u[n - 2] + 3u[n] + 4u[n + 1]

⇒ UJT can be used for
firing an SCR
turning off an SCR
both firing and turning off an SCR
none of the above

⇒ If a sample of Ge and a sample of Si have the same impurity density are kept at room temperature
both will have equal value of resistivity
both will have equal - ve of resistivity
resistivity of germanium will be higher than that of silicon
resistivity of silicon will be higher than of Ge

⇒ A duplexer is a device used to
feed more than one receiver from a single antenna
connect two transmitters to the same antenna
connect a receiver and a transmitter to the same antenna
none of these

⇒ In a biased limiter the clipping level can be adjusted by adjusting the voltage of battery.
TRUE
FALSE

⇒

Match the following:

	List I (Octal)		List II (Decimal number)
A.	35	1.	53
B.	65	2.	62
C.	54	3.	29
D.	76	4.	44

A-4, B-3, C-2, D-1
A-1, B-2, C-3, D-4
A-2, B-3, C-1, D-4
A-3, B-1, C-4, D-2