Question is ⇒ The circuit shown in figure, will act as an ideal current source with respect to terminals A and B, when frequenc, Options are ⇒ (A) zero, (B) 1 rad/s, (C) 4 rad/s, (D) 16 rad/s, (E) , Leave your comments or Download question paper.

Question is ⇒ The circuit shown in figure, will act as an ideal current source with respect to terminals A and B, when frequenc, Options are ⇒ (A) zero, (B) 1 rad/s, (C) 4 rad/s, (D) 16 rad/s, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The circuit shown in figure, will act as an ideal current source with respect to terminals A and B, when frequenc
A.	zero [Wrong Answer]
B.	1 rad/s [Wrong Answer]
C.	4 rad/s [Correct Answer]
D.	16 rad/s [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A load Z_L = R_L + jX_L is to be matched using an ideal transformer to generator of internal impedance Z_S = R_S + jX_S. The ratio of transformer required is __________ .
|Z_S|/|Z_L|
R_L/R_S
R_L/Z_S
|Z_L|/R_S

⇒ The positive peak of an AM wave is 16 V and the minimum value is 4 V Assuming single tone modulation, the modulation index is
0.6
0.25
4
0.36

⇒ A register is
a group is memories
a group of devices that store digital data
a chip used in computers
a pure silica piece used in digital systems

⇒ In most of instruments, the controlling torque is provided by
fluid fraction
spring
eddy current
either (a) or (c)

⇒ The damping ratio of a pair of complex poles when expressed in terms of angle θ measured from jω axis equal to
sin θ
cos θ
tan θ
cot θ

⇒ PIN diode has
p⁺ and n layers separated by i layer
p⁺ and n⁺ layers separated by i layer
p^- and n^- layers separated by i layer
none of the above

⇒ The angle δ for a mica capacitor is about
25°
15°
5°
1°

⇒ In applications where __________ input resistance is needed, the JFET is preferred to the bipolar transistor.
zero
very low
low
high

⇒ In the dimension statement DIMENSION A (50, 50), K (100, 100) the total number of locations reserved will be
2500
100000
125000
250000

⇒ In 8085 microprocessor, which of the following interrupts has the highest priority?
RST 5.5
RST 7.5
TRAP
INTR

⇒ Mark out the WRONG statem
Needs very high-speed burst modems
Faces no problems caused by intermodulation of carriers so that transponder can be used at its full power
Needs high-speed manipulation of bit streams
Is less flexible so that channels of widely different capacities cannot used and intermixed

⇒ The resistance of a photoconductor
increases with increase in light intensity
decreases with increase in light intensity
may increase or decrease with increase in light intensity
remains constant

⇒ The first and the last critical frequency of an RC driving point impedance function must respectively by
a zero and a pole
a zero and a zero
a pole and a pole
a pole and a zero

⇒ A coil has a designed for high Q performance at a rated voltage and a specified frequency. If the frequency of operation is doubled, and the coil is operated at the same rated voltage, then the Q factor and the active power P consumed by the coil will be affected as follows.
P is doubled, Q is halved
P is halved, Q is doubled
P remains constant, Q is doubled
P decreases 4 times, Q is doubled

⇒ The basic storage element in a digital system is
flip flop
counter
multiplexer
encoder

⇒ Which of the following statement is correct?
The input impedance of CE amplifier is usually around 10 Ω
The voltage gain of a transistor amplifier in CE mode is always less than unity
The output impedance of a transistor amplifier is independent of the transistor configuration
The voltage gain of a transistor amplifier is independent of the load resistance

⇒ The following k-map implem
BCD to Decimal Decoder
Decimal to BCD Encoder
1 of 10 Decoder
(a) and (c)

⇒ In TE₁₀mode the largest electric field in a rectangular wave guide, occurs
along centre line of broad wall (i.e. x = a/2)
along the broad wall (i.e. x = 0 and x = a)
either (a) or (b)
neither (a) nor (b)

⇒ In a two stage cascade amplifier, each stage has a gain of 10 dB and noise figure of 10 dB. The overall noise factor is
10
1.09
1
10.9

⇒ The range of life time carriers (electrons and holes) is
1 μs to 100 μs
1 nano sec to 1 μs
1 nano sec to hundreds of μs
none of the above

⇒ In a radio receiver, if the intermediate frequency is too low
Image-frequency rejection will improve
Selectivity will be too sharp
The frequency selectivity of the local oscillator will have to be lowered
All of the above

⇒ When an electron breaks a covalent bond and moves away,
a hole is created
a proton is also lost
atom becomes an ion
rest of the electron move at a faster rate

⇒ If VSWR is infinite, the transmission line is terminated in
short circuit
complex impedance
open circuit
either (a) or (c)

⇒ Assuming accumulator contain A 64 and the carry is set (1). What will register A and carry (CY) contain after ORA A?
A 6 H, 1
A 6 H, 0
00 H, 0
00 H, 1

⇒ The equivalent circuit shown in figure is
CE
CB
CC
None of the above

⇒ Consider the equation s² + 2s + 2 + K(s + 2) = 0. Where do the roots of this equation break on the root loci plot?
-3.414
-2.414
-1.414
-0.414

⇒ In a 3 phase semiconverter, the firing frequency is
equal to line frequency
3 times the line frequency
6 times the line frequency
12 times the line frequency

⇒ The resistance of human body is about
5000 Ω
2000 Ω
1000 Ω
200 Ω

⇒ In following figure, what will be R₁ and R₂ for maximum symmetrical swing if V_CSat ≈ 0. Given that R_E = 200 Ω, R_C = 400 Ω, V_CC = 20 V, β
6 k
3 k, 6 k
9.9 k, 2.4 k
2.4 k, 9.9 k

⇒ It is desired to reduce the reflection at an air porcelain by use of 7/4 plate (for Porcelain μ = 40, and ε_r = 7). The thickness of the polystyrene plate required at 10 GHz will be
5.039 cm
50.39 cm
0.5039 cm
0.05039 cm