Question is ⇒ The circuit shown depic, Options are ⇒ (A) voltage series negative feedback, (B) voltage shunt negative feedback, (C) current series negative feedback, (D) current shunt negative feedback, (E) , Leave your comments or Download question paper.

Question is ⇒ The circuit shown depic, Options are ⇒ (A) voltage series negative feedback, (B) voltage shunt negative feedback, (C) current series negative feedback, (D) current shunt negative feedback, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The circuit shown depic
A.	voltage series negative feedback [Wrong Answer]
B.	voltage shunt negative feedback [Wrong Answer]
C.	current series negative feedback [Wrong Answer]
D.	current shunt negative feedback [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The M circle for M = 1 is the
straight line at x = - 0.5
critical point (-l, jo)
circle with r = 0.33
circle with r = 0.67

⇒ In figure, D₂ turns on
v_i is more positive than V₁
v_i is less positive than V₁
v_i is more negative than V₂
v_i is less negative than V₂

⇒ The manufacturing technique used to manufacture strip type transmission line is
photoetching technique
oxidation technique
cladding
epitaxial

⇒ In figure the current distribution is represented
curve A
curve B
curve C
curve D

⇒ At a given probability of error, binary coherent FSK is interior to binary coherent PSK by
6 dB
3 dB
2 dB
0 dB

⇒ IN 3242 is a
P-N-P transistor
N-P-N transistor
UJT
semi-conductor diode

⇒ How can the bandwidth of a control system be increased?
By the use of phase lead network
By the use of phase lag network
By the use of both phase-lag and phase-lead network
By the use of cascaded amplifiers in the system

⇒ The circuit of figur
Precision integrator
Hartley oscillator
Butterworth high pass filter
Wien bridge oscillator

⇒ The total field developed by an antenna array at a distant point is
phasor sum of fields produced by individual antennas of the array
algebraic sum of fields produced by individual antennas of the array
either (a) or (b) depending on type of array
neither (a) nor (b)

⇒ What is the major cause of creeping in an energy-meter?
Over compensation for friction
Mechanical vibrations
Excessive voltage across the potential coil
Stray magnetic fields

⇒ Calculate cut off frequency for dominant mode in rectangular waveguide if dimensions are a = 2, b = 1 cm.
7.5 GHz
1.5 GHz
15 GHz
150 GHz

⇒ Which DOS command improves memory usage?
MEM MAKER
MOVE
MEM IM
None on the above

⇒ For the switch circuit, taking open as 0 and closed as 1, the expression for the circuit is Y. Y is give
A + (B + C) D
A + BC + D
A(BC + D)
none of these

⇒ When there is rapid attenuation of field inside the conductor, the field current are concentrated close to the surface of the conductor; this phenomenon is called
skin effect
EM concentration effect
Faraday's effect
Ohm's effect

⇒ In a FM waveform, the side bands are spaced at intervals equal to
four times the modulating frequency
twice the modulating frequency
half the modulating frequency
modulating frequency

⇒ Peak inverse voltage will be highest for
half wave rectifier
full wave rectifier
bridge rectifier
three phase full wave rectifier

⇒ A signal f(t) = cos 10pt + 3 cos 4pt is instantaneously sampled. The maximum allowable value of sampling interval T_s in sec is
1 / 4 sec
1 / 8 sec
1 / 8p sec
1 / 10 sec

⇒

Match the following:

	List I		List II
A.	D Layer	1.	110 km
B.	E layer	2.	10 km
C.	F layer	3.	60 km
D.	Troposphere	4.	350 km

A-3, B-1, C-4, D-2
A-2, B-1, C-4, D-2
A-3, B-2, C-1, D-4
A-4, B-3, C-1, D-2

⇒ A temperature sensistive transducer is subjected to sudden temperature change. It takes 10 seconds for transducer to reach equilibrium condition (five times time constant). The time taken to reach half of temperature difference will be
1.38 s
5 s
8.62 s
0.9 s

⇒ PAM stands for
Phase Angle Modulation
Phase Amplitude Modulation
Pulse Amplitude Modulation
Pulse Angle Modulation

⇒ His rather casual remarks on politics __________ his lack of seriousness about the subject.
masked
belied
cherish
conserve

⇒ Which amplifier has the higher power gain?
Common emitter
Common collector
Common base
Both CC and CE

⇒ Loading effect is primarily caused by instruments having
high resistance
high sensitivity
low sensitivity
high range

⇒

Assertion (A): FM requires more bandwidth than AM

Reason (R): Wide band FM is used for broadcast transmissions.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ CMOS is extensively used in
pocket calculators
digital wrist watches
satellites
all of the above

⇒ In the epitaxial diffused method of fabricating integrating circuits the process involved are __________

Epitaxial growth
Diffusion
Silicon diode growth
Vacuum evaporation of aluminium
Photoetching

The correct order is
1 - 2 - 3 - 4 - 5
1 - 3 - 5 - 2 - 4
3 - 1 - 4 - 5 - 2
1 - 3 - 2 - 4 - 5

⇒ Magnetic susceptibility of a medium is the ratio of
magnetic field strength to mmf
intensity of magnetization to magnetic flux density
intensity of magnetization to field strength
mmf to magnetic field strength

⇒ AM-SC stands for
Amplitude Modulated-Suppressed Carrier
Amplitude Modulated-Single Carrier
Amplitude Modulated-Synchronous Carrier
Amplitude Modulated-Self Carrier

⇒ Which of the following is non-sinusoidal oscillator?
Multivibrator
Relaxation oscillator using UJT
Relaxation oscillator using tunnel diode
Any of the above

⇒ An energy signal has G(f) = 10. Its energy density spectrum is
10
100
50
20