Question is ⇒ The circuit in figure, the switched on at <i>t</i> = 0. After a long time the current through 5 Ω resistanc, Options are ⇒ (A) 0.0416666666666667, (B) 0.166666666666667, (C) 0.416666666666667, (D) 0, (E) , Leave your comments or Download question paper.

Question is ⇒ The circuit in figure, the switched on at <i>t</i> = 0. After a long time the current through 5 Ω resistanc, Options are ⇒ (A) 0.0416666666666667, (B) 0.166666666666667, (C) 0.416666666666667, (D) 0, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The circuit in figure, the switched on at t = 0. After a long time the current through 5 Ω resistanc
A.	0.0416666666666667 [Wrong Answer]
B.	0.166666666666667 [Wrong Answer]
C.	0.416666666666667 [Wrong Answer]
D.	0 [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ For representing two sinusoidal voltages on a phasor diagram
Both voltages must be of the same frequency
Both voltages must be sinusoidal but may be of different frequencies
One of the voltages must be of 50 Hz
The frequency of one must be integral of that of other

⇒ The phase velocity v in a transmission line is
LC
C/L
L/C
1/LC

⇒ RESET OUT signal when high indicates that
program counter etc. are being set
program counter etc. are being reset
either (a) or (b)
none of the above

⇒ For a wave v = V _1m sin (ωt + θ₁ ) - V_3m sin (3ωt + θ₃), the rms value is (0.5 V²_1m + 0.5 V²_3m)^0.5
TRUE
FALSE

⇒

Assertion (A): A cycloconverter may be line commutated or forced commutated

Reason (R): A step up cycloconverter requires forced commutation.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ A battery charger can drive a current of 5A with 1Ω resistance connected at its output. If it can charge 2 V battery at 7 A rate, its Thevenin's equivalent circuit will be
7.5 in series with 0.5 Ω resistance
1.25 V in series with 1.5 Ω resistance
7.5 V in parallel with 0.5 Ω resistance
12.5 V in parallel with 1.5 Ω resistance

⇒

Assertion (A): A coaxial line is a non-radiating line.

Reason (R): In a coaxial line the electric and magnetic fields are confined to the region between the concentric conductors.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The number of thyristors in a single phase fully controlled bridge rectifier is
16
8
4
2

⇒ When a diode is forward biased, the diode current is
high
low
zero
low or zero

⇒ The emitter resistor R_E in the emitter of CE amplifier stabilizes the dc operating point against variation in
temperature only
β of transistor
both temperature and β
none of the above

⇒ Indicate the false statement: To combat noise
reduce signalling rate
increase transmitted power
use redundancy
increase channel bandwidth

⇒ Decimal number 5436 when converted into 9's complement will become
4356
4653
4563
4655

⇒ The O/P char, of a FET is given in the figure. In which region is the device biased for small signal amplificat
AB
BC
CD
BD

⇒ A particular current is made up of two components 10A dc and sinusoidal current of peak value 14.14A. The average of resultant current is
zero
24.14A
10A
14.14A

⇒ The phenomenon known as "Early effect" in a BJT refers to a reduction of the effective base width caused by
electron-hole recombination at the base
reverse biasing of the base collector junction
forward biasing of emitter base junction
the early removal of stored base charge during saturation to cut off switching

⇒ In the network of figure, the voltage drops across R₁, R₂, R₃ are 6 V, 8 V and 12 V with polarities as shown. The value of R_{312 Ω
8 Ω
5 Ω
3 Ω}

⇒ The primary colours are
blue and green
blue and red
red and green
blue, red and green

⇒ Which is the displacement transducer with excellent sensitivity, linearity and resolution?
Incremental encoder
Absolute encoder
LVDT
Strain gauge

⇒ In the assembler, which one of the following is required for variable name in symbol table?
Addresses
Values
Registers
Storage

⇒ One commercial unit of energy is equal to
1 watt-sec
1 kilowatt-sec
1 kilowatt-hour
One watt-hour

⇒ The circuit of the figure is an example of feedback of the following
current series
current shunt
voltage series
voltage shunt

⇒ If frames are repeated at 60 Hz and each frame has 525 lines, the time for scanning one horizontal line (for progressive scanning and no interlacing) is about
320 μs
32 μs
3.2 μs
0.32 μs

⇒ A signal x(n) = sin(ω₀n + φ) is the input to a linear time invariant system having a frequency response H(e^jω) If the O/P of the system is Ax(n -n₀), then the general form of H(e^jω) will be
- n₀ω₀ + β for any arbitrary real β
- n₀ω₀ + 2pk for any arbitrary integer k
n₀ω₀ + 2pk for any arbitrary integer k
- n₀ω₀ + φ

⇒

Assertion (A): If an event A can happen in m ways and another event B can happen in n ways, both can happen in mn ways.

Reason (R): Two events are mutually exclusive if happening of either precludes the occurrence of other.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒

Match the following:

	List I (Microwave device)		List II (Application)
A.	PIN diode	1.	Microwave amplification
B.	GaAs MOSFET	2.	Low noise microwave generation
C.	Transferred electron device	3.	Electronic tuning of MW oscillator
D.	Varactor diode	4.	Light wave detection

A-1, B-2, C-4, D-3
A-4, B-1, C-2, D-3
A-2, B-3, C-1, D-4
A-3, B-4, C-2, D-1

⇒ A pole zero pattern of a certain filter is shown in figure. This filter mus
LPF
BFP
HPF
APF

⇒ In a broadcast superheterodynes receiver having no RF amplifier, the loaded Q of the antenna coupling circuit is 100. If the intermediate frequency is 455 kHz. The rejection ratio at 25 MHz will be
1.116
1.386
2.116
2.386

⇒ An op-amp has
low input and output impedance
low input impedance and high output impedance
low output impedance and high input impedance
high output impedance and high input impedance

⇒ Which of the following devices has substrate?
JFET
Depletion Type MOSFET
Enhancement type MOSFET
Both (b) and (c)

⇒ What is the maximum output voltage from the 741 op-amp?
Zero
Approximately 1 V
Approximately 3 V
Approximately 5 V