Question is ⇒ The chip 8257 is a, Options are ⇒ (A) programmable interrupt controller, (B) programmable DMA controller, (C) programmable peripheral interface, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ The chip 8257 is a, Options are ⇒ (A) programmable interrupt controller, (B) programmable DMA controller, (C) programmable peripheral interface, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The chip 8257 is a
A.	programmable interrupt controller [Wrong Answer]
B.	programmable DMA controller [Correct Answer]
C.	programmable peripheral interface [Wrong Answer]
D.	none of the above [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The main difference between the broadside arrays and end fire arrays is that
individual elements are fed with same current in broadside arrays and of different magnitude in end fire arrays
in broadside arrays the elements are equidistant whereas in end fire array the distance between elements increases progressively
the total number of elements in broadside array is always one and a half times that of elements in end fire arrays
in broadside array the individual elements are fed in, out of phase by 180° whereas in end fire array individual elements are fed with currents of equal magnitude but their phases vary progressively along the line in such a way as to make the entire arrangement substantially unidirectional

⇒ In an Anderson bridge the unknown inductance is measured in terms of
known inductance and resistance
known inductance
known capacitance and resistance
known capacitance

⇒ A Hartley oscillator is used for
very low frequencies
radio frequencies
micro wave frequencies
audio frequency

⇒ In p type semiconductor, the hole concentration
is nearly equal to density of acceptor atoms
is much greater than density of acceptor atoms
is much less than density of acceptor atoms
may be equal to or more or less than density of acceptor atoms

⇒

Assertion (A): Silicon is less sensitive to changes in temperature than germanium.

Reason (R): It is more difficult to produce minority carriers in silicon than in germanium.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ Which of these are two state devices?
Lamp
Punched card
Magnetic tape
All of the above

⇒

Assertion (A): The modified ramp function of the given figure can be represented s sum of two ramp functions of the given fig
Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ A dual trace CRO has
one electron gun
two electron guns
one electron gun with one two pole switch
two electron guns with one two pole switch

⇒ In a semi-conductor diode, the barrier offers opposition to
holes in P-region only
free electrons in N-region only
majority carriers in both regions
majority as well as minority carriers in both regions

⇒ A transducer must have
good dynamic response
good sensitivity
good resolution
all of the above

⇒

Assertion (A): The sign and magnitude of displacement can be measured by an LVDT.

Reason (R): LVDT is based on the principle of mutual inductance.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ The number of interrupt lines in 8085 is
2
3
4
5

⇒ The portion of the atmosphere closest to ground is called ionosphere.
TRUE
FALSE

⇒ For an unstable system the gain margin is indicative of how much the gain should be decreased to make the system stable.
TRUE
FALSE

⇒ A three stage telephone switching structure is to have 128 input and 128 output terminals. It has been found that at peak time the utilization probability is 0.1. The number of intermediate links required for non-blocking configuration is 15. If the actual number of intermediate links is 5, the probability of blocking of call is
0.01
0.005
0.002
0.001

⇒ A monostable multivibrator has
no stable state
one stable state
two stable state
none of the above

⇒ If the switch is thrown to the START position, Q and Y will be equal to
Q = 0, Y = 0
Q= 1, Y= 1
Q = 1, Y = CLK
Q = 0, Y = CLK

⇒ A voltage doubler circuit is fed by a voltage V_m sin ωt. The output voltage will be nearly 2 V_m only if
load resistance is small
load resistance is large
load resistance is neither small nor large
either (a) or (c)

⇒ Which of the following logic family is fastest of all?
TTL
RTL
DCTL
ECL

⇒ What is the period of the sinusoidal signal x(n) = 5 cos [0.2 pn]?
10
5
1
0

⇒ In an electrochemical process the mass of material deposited at an electrode is proportional to
time for which current is passed
magnitude of current
electric charge through the electrolyte
none of the above

⇒ The name field effect is related to the __________ layers of a JFET.
depletion
drain
source
gate

⇒ The eigen values of a skew symmetric matrix are
always zero
always pure imaginary
either zero or pure imaginary
always real

⇒ Determine the transistor capacitance of a diffused junction varicap diode of a reverse potential of 4.2 V if C(0) = 80 pf and V_T = 0.7 V
42 pf
153.03 pf
13.33 pf
Data inadequate

⇒ If a sample of Ge and a sample of Si have the same impurity density are kept at room temperature
both will have equal value of resistivity
both will have equal - ve of resistivity
resistivity of germanium will be higher than that of silicon
resistivity of silicon will be higher than of Ge

⇒ In figure, a voltmeter of internal resistance 1200 Ω is connected across 600 Ω resistance and it reads 5 V. The value of
1200 Ω
2400 Ω
3600 Ω
7200 Ω

⇒ When a voltage is applied to a semiconductor crystal then the free electrons will flow.
towards positive terminal
towards negative terminal
either towards positive terminal or negative terminal
towards positive terminal for 1 μs and towards negative terminal for next 1 μs

⇒ A full adder is to be implemented using half adders and OR gates. A 4 bit parallel adder without any initial carry requires
8 half adders and 4 OR gates
8 half adders and 3 OR gates
7 half adders and 3 OR gates
7 half adders and 4 OR gates

⇒ For F₂ layer the critical frequency is about
500 MHz
100 MHz
25 MHz
10 MHz

⇒ A (75 - j 50) Ω load is connected to a coaxial line of Z₀ = 75 Ω at 10 GHz. The best method of matching consists of using
a capacitance at some specific distance from load
a short circuited stub at some specific distance from load
an inductance at load
a short circuited stub at load