Question is ⇒ The characteristic equation of a control system is given as s4 + 8s3 + 24s2 + 32s + K = 0. What is the range of values of K for this system to be stable?, Options are ⇒ (A) 0 ≤ K < 80, (B) 0 ≤ K < 100, (C) 0 ≤ K < 2300, (D) 0 ≤ K < 600, (E) , Leave your comments or Download question paper.

Question is ⇒ The characteristic equation of a control system is given as s4 + 8s3 + 24s2 + 32s + K = 0. What is the range of values of K for this system to be stable?, Options are ⇒ (A) 0 ≤ K < 80, (B) 0 ≤ K < 100, (C) 0 ≤ K < 2300, (D) 0 ≤ K < 600, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The characteristic equation of a control system is given as s⁴ + 8s³ + 24s² + 32s + K = 0. What is the range of values of K for this system to be stable?
A.	0 ≤ K < 80 [Correct Answer]
B.	0 ≤ K < 100 [Wrong Answer]
C.	0 ≤ K < 2300 [Wrong Answer]
D.	0 ≤ K < 600 [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Assertion (A): PIN diode is used as a fast switch.

Reason (R): PIN diode has very high resistance when reverse biased and very low resistance when forward biased.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Which of the following pairs of semiconductors and current carriers is correctly matched?
Intrinsic : number of electrons = number of holes
P type : number of electrons > number of holes
N type : number of electrons < number of holes
Bulk : neither electrons nor holes

⇒ When the core of a saturable reactor is saturated, the inductance is high.
TRUE
FALSE

⇒ Measurement of radiation resistance by reflection method is suitable for
parasitic element antennas
low frequency vertical conductor antenna
all type of antennas
none of the above

⇒

Assertion (A): In p-n-p transistor collector current is termed negative.

Reason (R): In p-n-p transistor holes are majority carriers.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ A 1000 kHz carrier wave modulated 40% at 4000 Hz is applied to a resonant circuit tuned to a carrier frequency and having Q = 140. What is the degree of modulation after transmission through this circuit?
0.4
0.2
0.27
0.54

⇒ If a line having Z₀ = 300 ∠ 0 W is open circuited at far end, VSWR is
0
1
∞
2

⇒ In microwave system the function of mode filter is
to suppress modes with lower cut off frequencies
to suppress modes with higher cut off frequencies
to change mode of wave transmission
both (b) and (c)

⇒ In a single phase power factor meter the phase difference between currents in the two pressure coils is
exactly 0°
approximate 0°
exactly 90°
approximate 90°

⇒ Which of the following constitute the loss resistance of an antenna?
Dielectric loss
Leakage loss in insulation
Loss in earth connections
All of the above

⇒ Consider the followings statements: A multiplier

selects one of the several inputs and steers it to the output
routes the data from a single input to many outputs
converts parallel data into serial data
is a combinational circuit

On the above statements which are correct?
1, 2, 4
2, 3, 4
1, 3, 4
1, 2, 3

⇒ Schrodinger wave equation is partial differential equation.
TRUE
FALSE

⇒ The equivalent circuit of an op-amp has
a virtual ground at input
a virtual ground at output
virtual ground at input as well as at output
none of the above

⇒ The radar cross-section of a target depends an
frequency
polarization of incident wave
aspect of target
all of the above

⇒ Schering bridge operates at a high voltage of about 10 kV.
TRUE
FALSE

⇒ The term critical frequency denotes
the lowest frequency that is reflected by the ionosphere
the highest frequency that is reflected by the ionosphere at vertical distance
the lowest frequency by which communication is possible between two given points
none of the above

⇒ In push pull amplifier, each transistor conducts for
180°
360°
90°
45°

⇒ For an amplifier the input output signals are shown in figure. The class of amplifie
A
AB
B
C

⇒ In a self bias circuit for CE amplifier, an increase in emitter resistance R_E results in
increase in emitter voltage
decrease in emitter voltage
increase in emitter current
decrease in emitter current

⇒ The ratio of tangential component of electric field at the surface of a conductor and the linear current density resulting from this field is __________ impedance
characteristic
critical
surface
polarizing

⇒ (1 2 1)_x = (1 0 0)₄ Then x is equal to
2
3
5
does not exist

⇒ The number of switching functions of 3 variables are
3
8
16
32

⇒ A thyristor has maximum allowable junction temperature of 110° C and the ambient temperature is 40°C, If the maximum internal power dissipation is 50 W, the thermal resistance is
2° C/W
1.4° C/W
0.7°C/W
2.2° C/W

⇒ Consider the following statements about 'Functions' in C

A function can be called any number of times.
A function gets called when the function name is followed by a semicolon.
The order in which functions are defined in a program and the order in which they are called must be the same.

Which of the above statements are correct?
All
1 and 2 only
1 and 3 only
2 and 3 only

⇒ The network has 10 nodes and 17 branches. The number of different node power voltages would be
7
9
10
45

⇒ In AM increased depth of modulation increases __________ and in FM with increased depth of modulation __________ increases.
total transmitted power, bandwidth
bandwidth, bandwidth
bandwidth, total transmitted power
total transmitted power, sideband power

⇒

Assertion (A): In imperfect capacitors, the current does not lead the applied ac voltage by 90°.

Reason (R): When subjected to ac fields, the dielectric constant can be expressed as ∈^'_r - j∈^"_r.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ A divide by 78 counter can be obtained by
6 numbers of mod-13 counters
13 numbers of mod-6 counters
one mod-13 counter followed by mod-6 counter
13 number of mod-13 counters

⇒

Match the following:

	List I (Transducer)		List II (Quantity measured)
A.	LVDT	1.	Pressure
B.	Bourden gauge	2.	Temperature
C.	Strain gauge	3.	Displacement
D.	Thermistor	4.	Stress

A-4, B-3, C-2, D-1
A-3, B-2, C-1, D-4
A-4, B-1, C-3, D-2
A-3, B-1, C-4, D-2

⇒ The unit of ∇ x H is
Ampere
Ampere/meter
Ampere/m²
Ampere-meter