Question is ⇒ The carrier mobility in a semiconductor is 0.4 m2/Vs. Its diffusion constant at 300k will be (in m2/s)., Options are ⇒ (A) 0.43, (B) 0.16, (C) 0.04, (D) 0.01, (E) , Leave your comments or Download question paper.

Question is ⇒ The carrier mobility in a semiconductor is 0.4 m2/Vs. Its diffusion constant at 300k will be (in m2/s)., Options are ⇒ (A) 0.43, (B) 0.16, (C) 0.04, (D) 0.01, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The carrier mobility in a semiconductor is 0.4 m²/Vs. Its diffusion constant at 300k will be (in m²/s).
A.	0.43 [Wrong Answer]
B.	0.16 [Correct Answer]
C.	0.04 [Wrong Answer]
D.	0.01 [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A resistance of 5 ohms is connected in one branch of a network. The current in this branch is 2.2. A. If the resistance is increased to 7.5 Ω, the remaining circuit being the same, the current in this branch will be
2.2 A
less than 2.2 A
2.2 A or less than 2.2 A
2.2 A or less or more than 2.2 A

⇒ Lead becomes a superconductor at
9.1 K
7 K
5 K
3 K

⇒ In high power AM transmission, modulation is done at
IF stage
buffer stage
RF stage
oscillator stage

⇒ What is the purpose of using ALE signal high?
To latch low order address from bus to separate A₀ - A₇ lines
To latch data D₀ - D₇ from bus to separate data bus
To disable data bus latch
All of the above

⇒ Consider the following statements

The amplitude of an FM wave is constant
FM is more immune to noise than AM
FM broadcasts operate in upper VHF and UHF frequency ranges
FM transmitting and receiving equipments are simpler as compared to AM transmitting and receiving equipments

Which of the above are correct?
1, 2, 3, 4
1, 2, 3
2, 3, 4
1, 3, 4

⇒ In a 3 byte instruction of 8085, the first, second and third byte respectively indicate
operation code, low order byte of data/address and high order byte of data / address
low order byte of data / address, high order byte of data / address and operation code
high order byte of data / address, low order byte of data / address and operation code
high order byte of data / address, operation code and low order byte of data / address

⇒ The voltage in a circuit follows the law v = 100 sin ωt if the frequency is 25 Hz, how long will it take for the voltage to rise to 50 volts?
1/150 s
1/100 s
1/300 s
1/600 s

⇒ Which of the following, is not a piezoelectric material?
Rochelle salt
Quartz
Lithium sulphate
Sodium bicarbonate

⇒ The frequency at which the piezoelectric effect occurs is primarily determined by
the weight of the crystal
thickness of the crystal
length of the crystal
gain structure of the crystal

⇒ In a polyatomic gas, the types of polarization which exist together are
electronic and orientational
electronic and ionic
ionic and orientational
electronic, orientational and ionic

⇒ The circuit of figur
clipper, sine wave clipped at - 2 V
clamper
clamper, sine wave clamped at zero V
clipper, sine wave clipped at + 2 V

⇒ A network N is dual of network N if
both of them have same mesh equation
both of them have same node equation
mesh equation of one are the node equations of the other
KCL and KVL equations are the same

⇒ For a symmetrical network
z₁₁ = z₂₂
z₁₂ = z₂₁
z₁₁ z₂₂ and z₁₂ = z₂₁
z₁₁ z₁₂ - z₁₂² = 0

⇒ In an RC series circuit excited by dc voltage E, the current at t = 0 is
E/R
E/C
zero
infinity

⇒ For a superconductor, magnetisation M in a field H is
extremely small
- H
- I
zero

⇒ For most static RAM the write pulse width should be at least
10 ns
60 ns
300 ns
1 μs

⇒ Final value theorem is used to find
steady state value of system output
initial value of output
transient beaviour of output
none of these

⇒ Expression ++i is equivalent to
i = i + 2
i = i + 1
i = i - 1
i = i + i + i

⇒ RF amplifiers are used in radio receivers for
improved image frequency rejection
improved rejection of adjacent unwanted signals
prevention of re-radiation of the local oscillator through the antenna of the receiver
all of the above

⇒ In a ratio detector
the linearity is worse than in a phase discriminator
the output is twice that obtainable from a similar phase discriminator
stabilization against signal strength variations is provided
the circuit is the same as in a discriminator, except that the diodes are reversed

⇒ A capacitor stores 0.15C at 5 V. Its capacitance is
0.75 F
0.75 μF
0.03 F
0.03 μF

⇒ A Schottky diode clamp is used along with a switching BJT for
reducing the power
reducing the switching time dissipation
increasing the value of β
reducing the base current

⇒ In the circuit shown, all the transmission line sections are lossless. The Voltage Standing Wave Ration (VSWR) on the 60W lin
1
1.64
2.5
3

⇒ Ferromagnetic materials show hysteresis in B - H characteristic. As the magnetic field in increased slowly from zero value, what is the first process which sets the material to give net magnetization?
Growth of favourably oriented domains at the cost of other domains by reversible boundary displacements
Growth of favourably oriented domains at the cost of other domains by irreversible boundary displacements
Domain wall orientation
A combination of processes (a) and (c) above

⇒ A capacitor with initial charge q₀ at t = 0⁺ acts as
current source
voltage source
short-circuit
open-circuit

⇒ In a piezoelectric crystal, applications of a mechanical stress would produce
plastic deformation of the crystal
magnetic dipoles in the crystal
electrical polarization in the crystal
shift in the Fermi level

⇒ In which of the following 8085 instructions is the CY flag complemented?
CMA
CMC
STC
RRC

⇒ The resistivity of ferrites is
very much lower than that of the ferromagnetic metals
slightly lower than that of the ferromagnetic materials
slightly higher than that of the ferromagnetic metals
very much higher than that of the ferromagnetic metals

⇒

Match the following:

	List I		List II
A.	Word wrap	1.	interleaved execution of two or more programs by the same computer
B.	Client	2.	automatically moves a word to the next line if it does not fit in the current line
C.	Multitasking	3.	an application receiving data
D.	Landscape	4.	orientation of worksheet

A-1, B-2, C-3, D-4
A-2, B-3, C-4, D-1
A-4, B-3, C-2, D-1
A-2, B-3, C-1, D-4

⇒ Which of the following is not a necessary advantage of negative feedback system?
Feedback improves speed of response
Feedback improves stability
Feedback reduces effect of variations in system parameters
Feedback reduces the effect of external disturbances