Question is ⇒ The breakdown voltage in a zener diode, Options are ⇒ (A) is almost constant, (B) is very small, (C) may destroy the diode, (D) decreases with increase in current, (E) , Leave your comments or Download question paper.

Question is ⇒ The breakdown voltage in a zener diode, Options are ⇒ (A) is almost constant, (B) is very small, (C) may destroy the diode, (D) decreases with increase in current, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The breakdown voltage in a zener diode
A.	is almost constant [Correct Answer]
B.	is very small [Wrong Answer]
C.	may destroy the diode [Wrong Answer]
D.	decreases with increase in current [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which of the following is the poorest conductor of electricity?
Aluminium
Nichrome
Copper
All of the above

⇒ A super heterodyne receiver has a IF of 465 kHz. It is tuned to a station broadcasting at 500 KHz and its oscillator is operating at 965 KHz, then the 1330 KHz frequency would be
adjacent channel frequency
image frequency
gyro frequency
maximum usable frequency

⇒ In a medium if ε, μ and σ are constant throughout the medium, then it is known as
perfect vacuum
distributed medium
homogeneous medium
dielectric medium

⇒ A lossless transmission line with air dielectric is 6 m long. what is the phase constant?
1p rad/m
2p rad/m
0.2p rad/m
0.1p rad/m

⇒ In a backward wave oscillator the wave
travelling along the line winds itself back and forth
progresses only in forward direction
progresses only in backward direction
either (a) or (c)

⇒ Consider the following program in B
2.827
28.27
282.7
2827

⇒ A few minutes disturbance in space communications occurs twice a year during Sunblinding when __________ are in line.
Sun and satellite
Sun and Earth station
Satellite and Earth station
Sun, satellite and Earth station

⇒ Which amplifier will be preferred for highest gain?
Darlington's pair
Single stage amplifier
Cascade amplifier
Depends on the circuitry

⇒ The relative permittivity of the ionosphere at ratio frequencies is
> 1
< 1
1
≥ 1

⇒ As compared to LED, LASER has

higher emission efficiency
no tuning arrangement
narrow spectral width
provision for confinement

Of these statements
1, 2, 3 are correct
1, 2, 4 are correct
1 and 3 are correct
1, 3, 4 are correct

⇒ In 8085
P flag is set when the result has even parity
P flag is set when the result has odd parity
P flag is reset when the result has odd parity
P flag is reset when the result has even parity

⇒ The internal impedance of a source is 3 + j 7 Ω. For maximum power transfer, load impedance should be
3 + j 7 Ω
3 - j 7 Ω
7 + j 3 Ω
7 - j 3 Ω

⇒ It is required to measure pressure using LVDT. The additional device needed is
strain gauge
pitot tube
bourden tube
rotameter

⇒ The internal impedance of a source is 3 + j 4 Ω. It is desired to supply maximum power to a resistive load. The load resistance should be
3 Ω
4 Ω
7 Ω
5 Ω

⇒ The M circle for M = 1 is the
straight line at x = - 0.5
critical point (-l, jo)
circle with r = 0.33
circle with r = 0.67

⇒ The given figure shows dB magnitude plots for type 0, type 1 and type 2 systems. Out of t
curves 1, 2, 3 are for type 0, 1, 2 systems respectively
curves 1, 2, 3 are for type 2, 1, 0 systems respectively
curves 1, 2, 3 are for type 1, 0, 2 systems respectively
curves 1, 2, 3 are for type 1, 2, 0 systems respectively

⇒ Low frequency boost can be easily compensated by
attenuating the frequencies from 0 to 1.25 MHz
using an appropriate de-emphasis circuit in the receiver
using an appropriate pre-emphasis circuit in the transmitter
none

⇒ In a thyristor the gate lead is connected to the n layer near the p layer to which anode is connected.
TRUE
FALSE

⇒ A Hartley oscillator is used for generation
very low frequency oscillation
radio frequency oscillation
microwave oscillation
audio-frequency oscillation

⇒ An AND gate has four inputs. One of the inputs is low and other inputs are high. The output
is low
is high
is alternately low and high
may be high or low depending on relative magnitudes of inputs

⇒ In a valence crystal, the valence electrons
are not shared
are shared between neighbouring atoms
are shared by all atoms
any of the above

⇒ The compensator in the given figure
lag compensator
lead compensator
lag-lead compensator
none of the above

⇒

Assertion (A): De sauty's bridge is suitable only for pure capacitor.

Reason (R): Capacitors are mostly perfect.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ FM broadcast lies in which band?
HF
SHF
UHF
VHF

⇒ Which one of the following is not a characteristic of a ferroelectric material?
High dielectric constant
No hysteresis
Ferroelectric characteristic only above the curie point
Electric dipole moment

⇒

Assertion (A): For a given system only one of the static error constants is finite and significant.

Reason (R): If finite static error constant is large, the loop gain becomes smaller as ω approaches zero.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ A network N is dual of network N if
both of them have same mesh equation
both of them have same node equation
mesh equation of one are the node equations of the other
KCL and KVL equations are the same

⇒

Assertion (A): Power transistor has lower switching time than SCR

Reason (R): Power transistor has greater switching time than SCR

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The emitter coupled pair of BJT's gives a linear transfer relation between the differential output voltage and the differential input voltage V_id only when the magnitude of V_id is less a times the thermal voltage, where a is
4
3
2
1

⇒ A broadside array consisting of 200 cm wavelength with 10 half-wave dipole spacing 10 cm. And if each array element feeding with 1 amp. current and operating at same frequency then find the half power beamwidth
4°
2°
10°
15°