Question is ⇒ The basic shift register operations are, Options are ⇒ (A) serial in - serial out, (B) serial in - parallel out, (C) parallel in - serial out, (D) all of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ The basic shift register operations are, Options are ⇒ (A) serial in - serial out, (B) serial in - parallel out, (C) parallel in - serial out, (D) all of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The basic shift register operations are
A.	serial in - serial out [Wrong Answer]
B.	serial in - parallel out [Wrong Answer]
C.	parallel in - serial out [Wrong Answer]
D.	all of the above [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The output voltage waveform of a CE amplifier is fed to a dc coupled CRO. The trace on the screen will be
dc output voltage
ac output voltage
sum of dc and ac output voltage
either (a) or (b)

⇒ In figure, the charge on 0.8 μF capacito
100 μC
50 μC
40 μC
20 μC

⇒ A TRIAC can be turned on :
by applying a positive signal to gate
by applying a negative signal to gate
by applying either positive or negative signal to gate
none of the above

⇒ Class A and Class B power amplifiers predominate at
audio frequencies
radio frequencies
all frequencies
audio and radio frequency

⇒ Germanium and Si phosphorus have their maximum spectral response in the
infrared region
ultraviolet region
visible region
X-ray region

⇒ The poles of an RC function
are simple and lie or negative real axis
are simple and lie on ω axis
must be complex conjugate
may be anywhere on s plane

⇒ In steady state condition inductor behave as
open circuit
short circuit
current source
voltage source

⇒ The torque in induction wattmeters due to
capacitive current
electrostatic effect
hall effect
eddy currents

⇒ The 10 MHz in the specification of CRO means that
the sweep frequency is 10 MHz
the frequency of input signal should not be more than 10 MHz
the vertical amplifier has been designed for 10 MHz
none of the above

⇒ The different access methods which permit many satellite users to operate in parallel through a single transponder without interfering with each other as
Frequency Division Multiple Access (FDMA)
Time Division Multiple Access (TDMA)
Code Division Multiple Access (CDMA)
All of the above

⇒ Which of the following device acts as an N-P-N and a P-N-P transistor connected base to base and emitter to controller?
UJT
SCR
Diac
Triac

⇒ Foster Seeley discriminator uses a
single tuned circuit
double tuned circuit with primary and secondary tuned to the same frequency
double tuned circuit with primary and secondary tuned to the different frequency
none of the above

⇒ A piezoelectric force transducer has a charge sensitivity of 20 pC/N. It is connected to a charge amplifier and overall gain of transducer and amplifier is 50 mV/N. The gain of amplifier is
1 mV/pC
1.5 mV/pC
2.5 mV/pC
4 mV/pC

⇒ Which among the following waveforms can be reconstructed from its samples without distort
1 and 2
2 and 3
1 and 3
Only 2

⇒ In figure, the total power consume
10 W
12 W
16 W
20 W

⇒ Capture effect occurs in
AM
FM
PCM
QAM

⇒

Assertion (A): The closeness of G(jω) locus to (- 1 + j0) point can be used as a measured of margin of stability.

Reason (R): When the G(jω) locus comes close to encircling (- 1 + j0) point the system becomes oscillatory.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ A 10 km long line has a characteristic impedance of 400 ohms. If line length is 100 km, the characteristic impedance is
4000 Ω
400 Ω
40 Ω
4 Ω

⇒ In SSB generation, the most commonly used filter is
low pass
RC
LC
mechanical

⇒ A 24 mm long conductor has a resistance of 128 Ω. The change in resistance is 13.3 Ω and change in length is 1.6 mm under tension. The gauge factor is
1.2
1.6
2.1
2.6

⇒

Match the following:

	List I		List II
A.	Firm ware	1.	Converts program in high level language to machine language
B.	Compiler	2.	Converts assembly language program into machine language
C.	Assembler	3.	Software embedded in hardware
D.	Virtual addressing	4.	Grouping information between various memories

A-1, B-2, C-3, D-4
A-2, B-3, C-4, D-1
A-3, B-4, C-1, D-2
A-3, B-1, C-2, D-4

⇒ To eliminate ghosts in the picture
use a longer transmission line
connect a booster
change the antenna orientation of location
twist the transmission line

⇒ Fourier transform of signal obtained after taking difference between step function and its reverse version is given as __________ .
2jω
2/jω
4/jω
4jω

⇒ The frequency at which phase angle is 180° is called
phase crossover frequency
stability limit frequency
frequency of limited stability
gain margin frequency

⇒ In a resistor the current is i and the voltage is v. The rate of dissipation of heat at any time t is
vi
vit
vt
vit²

⇒ Consider the following statements about diamagnetic material and diamagnetism.

The materials have negative magnetic susceptibility.
At very low temperature diamagnetic materials.

Which of the statements given above is/are correct?
1 only
2 only
Both 1 and 2
neither 1 nor 2

⇒ DMA stands for direct memory access.
TRUE
FALSE

⇒ The function A e^st where s = s + jω represents
A phasor whose magnitude changes with time
A phasor whose frequency is ω
A phasor rotating in counterclockwise direction at angular frequency ω and whose magnitude increases with t
A phasor rotating in clockwise direction at angular frequency ω and whose magnitude increases with t

⇒ If both emitter base and collector base junctions of a BJT are forward biased, the transistor is in
active region
saturated region
cut off region
inverse mode

⇒ The strength of controlled voltage source depends on
value of current elsewhere in the circuit
value of voltage elsewhere in the circuit
value of current or voltage elsewhere in the circuit
none of the above