Question is ⇒ The bandwidth of FM for Commercial Purpose is, Options are ⇒ (A) 88 - 108 MHz, (B) 85 - 110 MHz, (C) 90 - 110 MHz, (D) infinite Range, (E) , Leave your comments or Download question paper.

Question is ⇒ The bandwidth of FM for Commercial Purpose is, Options are ⇒ (A) 88 - 108 MHz, (B) 85 - 110 MHz, (C) 90 - 110 MHz, (D) infinite Range, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The bandwidth of FM for Commercial Purpose is
A.	88 - 108 MHz [Correct Answer]
B.	85 - 110 MHz [Wrong Answer]
C.	90 - 110 MHz [Wrong Answer]
D.	infinite Range [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The rate at which information can be carried through a communication channel depends on
carrier frequency
bandwidth
transmission loss
transmitted power

⇒ In a specimen of n type semiconductor, the initial concentration of holes and electrons is p_no and n_no. When the specimen is subjected to radiation, the hole and electron concentration increase to p_n and n_n. Then
p_n - p_no = n_n - n_no
p_n + p_no = n_n + n_no
p_n - p_no = n_no + n_no
p_n + p_no = n_n - p_no

⇒ Which of the following is not correct?
P(A) = P(A) - 1
0 ≤ P ≤ 1
If A and B are mitual exclusive then P(A + B) = P(A) + P(B)
P(A) = 1 - P(A)

⇒ An amplifier has an input resistance of 10 kΩ and the noise voltage is 10 μV. If two such resistances of 10 kΩ each are connected in series at the input, the total noise voltage is about
20 μV
5μV
14.14 μV
10 μV

⇒ If there are no permanent dipoles in a dielectric material, the dielectric constant is independent of temperature.
TRUE
FALSE

⇒ When deflecting torque and braking torque in an energy meter are zero,
the disc rotates at steady speed
the disc is stationary
the disc accelerates
the disc retards

⇒ What is the terminal count in decimal form?
1579
1681
1881
2014

⇒

Match the following:

	List I		List II
A.	Television	1.	Either AM or FM used
B.	Radio	2.	Both AM and FM are used
C.	Radar	3.	PCM is used
D.	Data Communication	4.	Digital system

A-4, B-3, C-1, D-2
A-2, B-1, C-3, D-4
A-4, B-1, C-3, D-2
A-2, B-3, C-1, D-4

⇒ The feedback resistance r_d in small signal model of MOSFET is of the order of
1000 MΩ
1 MΩ
1 KΩ
100 Ω

⇒ Which of the following frequency is likely to be associated with AM radio broadcast?
1000 kHz
100 MHz
500 MHz
10 GHz

⇒ Parabolic and lens antenna used at
microwave frequency
medium frequency
low frequency
high frequency

⇒ The merger of hole and free electron is called
covalent bonding
recombination
thermal energy
free electrons

⇒ Which of the following represents the equivalent circuit of a crystal for crystal oscilla
Figure A
Figure B
Figure C
None of the above

⇒ A circuit has two branches in parallel and each branch has only one element. The applied voltage and source current are v = 200 sin (200t + 30°) and i = 50 sin (200t + 50°). If one branch has capacitor, the other branch contains
resistance
inductance
capacitance
resistance or capacitance

⇒ Figure shows a NAND latch used as a switch debouncer. With the switch in STOP position. Q will be equal to
0
1
CLK
none of these

⇒ In 8085, to disable the whole interrupt system (except TRAP)
the DI instruction may be used
the DO instruction may be used
the INTERRUPT instruction may be used
the El instruction may be used

⇒ A counter type A/D converter contains a 4 bit binary ladder and a counter driven by a 2 MHz clock. Then conversion time
8 μ sec
10 μ sec
2 μ sec
5 μ sec

⇒ A single phase half wave rectifier is feeding a resistive load. As firing angle is increased
dc output voltage and rms output voltage decrease in the same proportion
dc output voltage and rms output voltage decrease
dc output voltage and rms output voltage increase
dc output voltage and rms output voltage increase in the same proportion

⇒ Energy content of atmospheric noise
does not depend on frequency
decreases as frequency is increased
increases as frequency is increased
either (a) or (c) depending on the temperature

⇒ The first contribution to logic was made by
George Boole
Copernicus
Aristotle
Shannon

⇒ In the decimal number 27, the digital 2 represents
2
20
0.2
200

⇒ The method of triggering SCS is
application of positive pulse at cathode gate or negative pulse at anode gate
application of pulse at anode gate
application of pulse at cathode gate
application of low voltage at anode

⇒ The condition AD - BC = 1 for two port network implies that the network is a
reciprocal
lumped element network
lossless network
unilateral element network

⇒ The data of speed of train V and resistance to motion
6.7 + 0.0092 V²
3 + 0.001 V²
3.2 + 0.0012 V²
5.2 + 0.006 V²

⇒ The bandwidth of an amplifier can be reduced by
miller effect compensation
pole zero compensation
dominant pole compensation
lead compensation

⇒ Reluctivity is analogous to
permeability
conductivity
resistivity
retentivity

⇒ The circuit below represents function X(A, B, C, D)
Σ(5, 8, 13, 14)
∏(0, 1, 2, 3, 4, 6, 7, 8, 10, 11, 12)
Σ(5, 9, 13, 14)
∏(0, 1, 2, 3, 4, 5, 6, 7, 8, 10, 11, 12, 15)

⇒ Figure repres
Adder
Multiplier
Subtractor
Log Amplifier

⇒ A wave is propagated in a waveguide at frequency of 9 GHz and separation is 2 cm between walls calculate the phase velocity for dominant mode.
3 x 10⁸ m/sec
5 x 10⁸ m/sec
1.5 x 10⁸ m/sec
9 x 10⁸ m/sec

⇒ Bode magnitude plot is drawn between
magnitude of network function and ω
dB magnitude and log ω
dB magnitude and ω
log_e (magnitude) and log ω