Question is ⇒ The attenuation in waveguides near the cut off frequency is, Options are ⇒ (A) very low, (B) very high, (C) medium, (D) zero, (E) , Leave your comments or Download question paper.

Question is ⇒ The attenuation in waveguides near the cut off frequency is, Options are ⇒ (A) very low, (B) very high, (C) medium, (D) zero, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The attenuation in waveguides near the cut off frequency is
A.	very low [Wrong Answer]
B.	very high [Correct Answer]
C.	medium [Wrong Answer]
D.	zero [Wrong Answer]
View Answer 2 -8 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The accuracy of measurement using CRO is about
± 0.5%
± 0.05 %
± 1%
± 3%

⇒ A bridge rectifier circuit has a dc load current of 10 mA and a filter capacitance of 1000 μF. The peak to peak ripple voltage is
0.01 V
0.05 V
0.1 V
0.5 V

⇒ The Nyquist plo
will start from (ω = ∞) in the first quadrant and will terminate (ω = 0) in the second quadrant
will start from (ω = ∞) in the fourth quadrant and will terminate (ω = 0) in the second quadrant
will start form (ω = ∞) in the second quadrant and will terminate (ω = 0) in the fourth quadrant
will start from (ω = ∞) in the first quadrant and will terminate (ω = 0) in the fourth quadrant

⇒ In a bridge rectifier circuit the rms value of input ac voltage is 10 V. The PIV across each diode is
7.07 V
14.14 V
10 V
28.28 V

⇒ The inputs to a 3 bit binary adder are 111₂ and 110₂. The output will be
101
1101
1111
1110

⇒ Which of the following represents constant magnitude locus for M = 1?
x = -0.5
x = 0
x² + y² = 1
(x + 1)² + y² = 1

⇒ As temperature increases the number of free electrons and holes in an intrinsic semiconductor
increases
decreases
remains the same
may increase or decrease

⇒ The type of noise that interfere very much with high frequency transmission is
white
transit time
flicker
shot

⇒ The analog signal given below is sampled at 1200 samples per second. m(t) = 2 sin 120 pt + 3 sin 240 pt + 4 sin 360 pt + 5 sin 480 pt + 6 sin 600 pt + 7 sin 720 pt. The folding (maximum) frequency is __________ .
300 Hz
360 Hz
600 Hz
480 Hz

⇒ In a purely inductive ac circuit the power curve is a sinusoid of the same frequency as the voltage.
TRUE
FALSE

⇒

Assertion (A): In liquid system the ratio of change in liquid level to change in flow rate is called resistance of liquid flow.

Reason (R): In liquid level systems the ratio of change in liquid stored in a tank to the change in head is called capacitance of tank.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ The region between a pin of parallel perfectly conducting planes of infinite extent is y and z directions is partially filled with a dielectric as shown be
-2
2
0
1

⇒ In body centred cubic structure, comers and centre of the cube are occupied by identical atoms.
TRUE
FALSE

⇒ An ideal voltage amplifier should have
low input impedance and high output impedance
high input impedance and low output impedance
high input impedance and high output impedance
low input impedance and low output impedance

⇒ In integral cycle control of ac regulator, the input power factor is equal to
duty cycle a
a²
a
(a)^1/3

⇒ A shadow zone does not receive any space wave
TRUE
FALSE

⇒ The maximum number of alphabets/digits or special symbots for character constants in C is
1
2
4
8

⇒ In a series RC circuit Z = (R² + ω²C²)^0.5.
TRUE
FALSE

⇒ The bunching action which occurs in multicavity klystron amplifier can be represented by Applegate diagram
TRUE
FALSE

⇒ What will be output for decimal input 82?
0.82 V
8 V
0.1 V
10 mV

⇒ The instruction MOV r₁, r₂ in 8085
causes contents of registers r₂ to be moved to r, and uses register addressing
causes contents of registers r₁ to be moved to r₂ and uses register addressing
causes contents of registers r₁ to be moved to r₂ and uses register immediate addressing
causes contents of registers r₂ to be moved to r₁ and uses register immediate addressing

⇒ RF amplifiers are used in radio receivers for
improved image frequency rejection
improved rejection of adjacent unwanted signals
prevention of re-radiation of the local oscillator through the antenna of the receiver
all of the above

⇒ In a 5 x 7 dot matrix, format, to store 64 alphanumeric characters we require
1120 bits
2240 bits
33 bits
64 bits

⇒ In a CD player the laser uses
silicon semiconductor
silicon/germanium semiconductor
aluminium gallium arsenide semiconductor
none of the above

⇒ High speed counter
ring counter
ripple counter
synchronous counter
asynchronous counter

⇒ If a zero is added to a second order underdamped system
the peak overshoot is increased
the peak overshoot is decreased
the peak overshoot remains unchanged
either (a) or (b)

⇒ At very low frequencies a series R-C circuit behaves as almost purely __________ .
resistive
inductive
capacitive
none of the above

⇒ As per Euler's identity e^jωt = cos ωt + j sin ωt
TRUE
FALSE

⇒ For the ring oscillator shown in the figure, the propagation delay of each inverter is 100 pico sec. What is the fundamental frequency of the oscillator output _______
10 MHz
100 MHz
1 GHz
2 GHz

⇒ What is the propagation constant for air filled wave guide with dimensions a = 1.59" and b = 0.795" at 4.95 GHz?
0.6698
0.7698
0.503
0.6598