Question is ⇒ The atmospheric absorption of radio waves depends on, Options are ⇒ (A) frequency of wave, (B) the distance from transmitter, (C) wave polarisation, (D) atmospheric polarisation, (E) , Leave your comments or Download question paper.

Question is ⇒ The atmospheric absorption of radio waves depends on, Options are ⇒ (A) frequency of wave, (B) the distance from transmitter, (C) wave polarisation, (D) atmospheric polarisation, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The atmospheric absorption of radio waves depends on
A.	frequency of wave [Correct Answer]
B.	the distance from transmitter [Wrong Answer]
C.	wave polarisation [Wrong Answer]
D.	atmospheric polarisation [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The voltage in a circuit follows the law v = 100 sin ωt if the frequency is 25 Hz, how long will it take for the voltage to rise to 50 volts?
1/150 s
1/100 s
1/300 s
1/600 s

⇒ An SCR has a turn on time of 4 μs. The gate pulse should have a duration of about
2 μs
5 μs
20 μs
50 μs

⇒ Which of the following is operating system?
MS WORD
Ventura
Java
Windows

⇒ Which of the following could be the equation for non-linear resistor shown in figu
a + be + ce² + de³
a - be - ce² - de³
a + be + ce² - de³
a + be - ce² - de³

⇒

Assertion (A): A Smith chart can be used for a number of calculations of a transmission line

Reason (R): Smith chart is basically a polar impedance diagram.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ When a current source I is suddenly connected across a two terminal relaxed RC circuit at time t = 0, the voltage across the current source is shown in figure. The RC circui
a series combination of R and C
a parallel combination of R and C
a series combination of R and parallel combination of R and C
a pure capacitor

⇒ The frequency of the driving network connected between pins 1 and 2 of a 8085 chip must be
equal to the desired clock frequency
twice the desired clock frequency
four times the desired clock frequency
eight times the desired clock frequency

⇒ In a conductor the current flow is due to
holes
electrons
ions
electrons and ions

⇒ If the Q of a single stage single tuned amplifier is doubled, the bandwidth will
remain the same
become half
become double
become four times

⇒ In a N-P-N transistor, when emitter junction is forward biased and collector junction is reverse biased the transistor will operate in
active region
saturation region
cut-off region
inverted region

⇒ For the given truth table, the correct Boolean expressio
XYZ + X YZ + X Y Z
X Y Z + XYZ + X YZ
X Y Z + XYZ + XY Z
XYZ + XYZ + XY Z

⇒ The coil of a moving iron instrument has a resistance of 500 Ω and an inductance of 1 H. It reads 250 V when a 250 V dc is applied. If series resistance is 2000 Ω, its reading when fed by 250 V, 50 Hz ac will be
260 V
252 V
250 V
248 V

⇒ A line has a phase constant of 29.8 rad/m. At 1000 MHz the wavelength is
29.8 m
2.98 m
2.1 m
0.21 m

⇒ In figure, V_{0-1 V
2 V
+1 V
+15 V}

⇒

Assertion (A): Transformer coupling has the disadvantage of the weight of transformer and Saturation of core

Reason (R): Transformer coupling is very suitable for impedance matching

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ In FM noise can be decreased by a feature that AM does not have
increasing deviation
decreasing deviation
reducing modulation index
increasing modulation index

⇒ In a certain '12 channel TDM' system it is found that channel no. 3 and channel no. 8 are connected to the same input signal. This technique
wastes the channel capacity
takes care of different sampling rate
is required when different bandwidth signals are to be transmitted
reduces noise

⇒ The radio receivers mostly used now a days are
TRF receivers
super heterodyne receivers
CW receivers
pulsed receivers

⇒ The transistor of following figure in Si diode with a base current of 40 μA and I_CBO = 0, if V_BB = 6V, R_E = 2 kΩ and β = 90, I_BQ = 20 μA then I_{EQ1800 μA
180 μA
2000 μA
3000 μA}

⇒ A dc power supply has no load voltage of 30 V and full load voltage of 25 V at full load current of 1 A. The output resistance and voltage regulation respectively are
5 Ω and 25%
25 Ω and 20%
5 Ω and 16.7%
25 Ω and 16.7%

⇒ An open loop system has a forward path transfer function (42.25)/s(s + 6.5). The unit step response of the system starting from rest will have its maximum value at a time equal to
0 sec
0.56 sec
5.6 sec
infinity

⇒ If the plate supply voltage for a plate modulated class C amplifier is E, the maximum plate cathode voltage could be almost as high as
E
2 E
3 E
4 E

⇒ If f is more than f_unity the gain of op-amp becomes less than 1.
TRUE
FALSE

⇒

Assertion (A): Many times a radar cannot detect 'grounding hopping' military aircraft.

Reason (R): Ground interference limits the range of radar.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The speed at which axial electric field due to signal advances in a TWT is equal to
speed of light
(speed of light) (helix pitch helix circumference)
(speed of light) (helix circumference helix pitch)
(speed of light) (helix pitch) (helix circumference)

⇒ A single phase full converter can operate in
4 quadrants
3 quadrants
2 quadrants
1 quadrant

⇒ The parallel RLC circuit shown in figure is in resonance
I_R < 1 mA
| I_R + I_L | > 1 mA
| I_R + I_L | < 1 mA
| I_L + I_C | > 1 mA

⇒ If the function A, B are A = R + PQ + RS B = PQRS + PQRS + PQRSA = B
A = B
no direct relation between A and B
insufficient data

⇒ In the given figure power meters at A and B indicate 1 mW and 110 μW respectively. VSWR of lin
1.5
2
2.5
3

⇒ Voltage standing wave pattern in a loss less transmission line with characteristic impedance 50 Ω and a resistive load is shown in the figu
-0.6
-1
0.6
0