Question is ⇒ The ASCII code is for information interchange by a binary code for, Options are ⇒ (A) alphabet only, (B) number only, (C) alpha-numeric and other common symbols, (D) none of these, (E) , Leave your comments or Download question paper.

Question is ⇒ The ASCII code is for information interchange by a binary code for, Options are ⇒ (A) alphabet only, (B) number only, (C) alpha-numeric and other common symbols, (D) none of these, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The ASCII code is for information interchange by a binary code for
A.	alphabet only [Wrong Answer]
B.	number only [Wrong Answer]
C.	alpha-numeric and other common symbols [Correct Answer]
D.	none of these [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A n-port network is said to be active if power in the ckt is __________ .
P > 0
P < 0
P = 0
P = ∞

⇒ How many cascaded stage of CE amplifiers will result in polarity inversion of the input signal?
Two
Three
Four
None

⇒ The PAM Signal can be detected by
Band pass filter
Band stop filter
High pass filter
Low pass filter

⇒ The critical frequency of 'F' layer is greater than 30 MHz.
TRUE
FALSE

⇒ The radiation pattern of loop antenna is
circle
semicircle
elliptical
cardoid or Limacon

⇒ The time constant of the circuit after the switch shown in the figure is opene
0.2 s
5 s
0.1 s
dependent on R and hence cannot be determined unless R is known

⇒

Assertion (A): The steady state response, of a stable, linear, time invariant system, to sinusoidal input depends on initial conditions.

Reason (R): Frequency response, in steady state, is obtained by replacing s in the transfer function by jω

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ A remote control for TV uses
LED in receiver and photodiode in transmitter
LED in transmitter and photodiode in receiver
LED in both transmitter and receiver
Photodiode in both transmitter and receiver

⇒ In a stud mounted SCR, the stud is
in thermal contact with heat sink
insulated from heat sink
in electrical and thermal contact with heat sink
in either electrical or thermal contact with heat sink

⇒ The circuit shown below is the equivalent circuit of which one of the following microwave resonator ty
Butterfly resonator
Parallel-wire resonator
Cavity resonator
Coaxial line resonator

⇒ The duty cycle of a radar transmitter is equal to
(PRF) (pulse width)
(PRF)/(pulse width)
(pulse width)/(PRF)
(pulse width) + (PRF)

⇒ A voltage V_BB is applied across the terminals of a UJT. The emitter voltage at peak point is
hV_BB
(h + 1) V_BB
hV_BB + V_D
V_D

⇒ A line is excited by a 100 V dc source. If reflection coefficients at both ends are 1 each then
there will be no oscillations on line
there will be only 1 or 2 oscillations on line
there will be a finite number of oscillations on line
the oscillations will continue indefinitely

⇒

Match the following:

	List I		List II
A.	CTFS	1.	Periodic
B.	DTFS	2.	Non-periodic
C.	CTFT
D.	DTFT

A-2, B-1, C-2, D-2
A-2, B-1, C-2, D-1
A-1, B-2, C-2, D-2
A-1, B-2, C-2, D-1

⇒ For 2 port reciprocal network, o.c. output voltage divided by input current is equal to
B
z₁₂
1/y₁₂
h₁₂

⇒ The range of signed decimal number that can be represented by 6 bit in complement number is
-31 to +31
-63 to +64
-64 to +63
-32 to +31

⇒ DC ampere hour meter is an indicating instrument.
TRUE
FALSE

⇒ Two coils are so wound that 60% of the flux of one links the other. The coefficient of coupling is
1.67
0.6
0.36
0.216

⇒ Determine the voltage V_CB in the circuit bel
3.4 V
5.4 V
7.4 V
9.4 V

⇒ Magnetic flux can be measured by
capacitive pick up
inductive pick up
resistive pick up
hall effect pick up

⇒ When a material becomes a superconductor, its resistivity becomes
very small
zero
about 10% of normal value
about 20% of normal value

⇒ The manufacturing technique used to manufacture strip type transmission line is
photoetching technique
oxidation technique
cladding
epitaxial

⇒ Which of the following pulse communication system is inherently immune to noise?
PPM
PCM
PWM
PAM

⇒ Radio broadcasting is a familiar example of
space multiplexing
time multiplexing
frequency multiplexing
none of the above

⇒ Which of the following method cannot be used to increase the bandwidth for cascaded RF amplifier stages?
Wave traps in each stage
Stagger tuning
A shunt damping resistor across each tuned circuit
Doubled tuned transformers with tighter coupling

⇒ If a small amount of Cu is added to Ni conductor, then
resistivity of Ni will decrease at all temperatures because Cu is a better conductor than Ni
residual resistivity of Ni at low temperature will increase as Cu atoms act as defect centres
resistivity of Ni will increase at all temperatures as Cu destroys the periodicity of Ni and acts as defects
resistivity of Ni remains the same

⇒ For a photoconductor with equal electron and hole mobilities and perfect ohmic contacts at the ends, an increase in illumination results in
a change in O.C. voltage
a change in S.C. current
a decrease in resistance
an increase in resistance

⇒ For the gate in the given figure the output wil
0
1
A
A

⇒ To measure moisture in wood, the most suitable method is
electric conduction
electrical-capacitive
absorption of radiation
equilibrium-moisture Vs humidity

⇒ If a and b are the dimensions of waveguide then
a = 3b
a = 2b
a = b
a = b/4