Question is ⇒ The amplifier used in miller voltage sweep should have a gain of, Options are ⇒ (A) -∞, (B) 1, (C) +∞, (D) -1, (E) , Leave your comments or Download question paper.

Question is ⇒ The amplifier used in miller voltage sweep should have a gain of, Options are ⇒ (A) -∞, (B) 1, (C) +∞, (D) -1, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The amplifier used in miller voltage sweep should have a gain of
A.	-∞ [Correct Answer]
B.	1 [Wrong Answer]
C.	+∞ [Wrong Answer]
D.	-1 [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In practical commercial FM system, channel bandwidth is
150 kHz
100 kHz
88 MHz
108 MHz

⇒ Read the following statement

Multi-processing operation permits highly efficient parallel processing at several levels.
Multi processing involves use of several processing units jointly on a common program and severally on different programs.
In multi-processing the assignment of facilities to tasks, loading of programs and monitoring of I/O activity is taken care of by operating system.

Which of the above are correct?
All
1 and 2 only
1 and 3 only
2 and 3 only

⇒ Image frequency rejection mainly depends upon
detector
mixer
IF
RF

⇒ In 8086 the number of bytes which can be addressed directly is about
1000
10000
100000
one million

⇒ Which one of the following blocks is not common in both AM and FM receivers?
RF amplifier
Mixer
IF amplifier
Slope detector

⇒ Single parity check is not reliable in case of
paper tape
magnetic tape
magnetic drum
cores

⇒ Highest resistivity of the following is
nichrome
constantan
metal
manganin

⇒ In a resistance strain gauge, G = 2, stress = 1050 kg/cm², R = 1000 Ω. The value of ΔR will be
2 Ω
3 Ω
4 Ω
1 Ω

⇒ Which of them radiates emission?
LED only
LCD only
Both LED and LCD
Neither LED nor LCD

⇒ N-channel FETs are superior to p-channel FETs because
mobility of electrons is smaller than that of holes
mobility of electrons is greater than that of holes
they consume less power
they have high switching time

⇒ With a variable reluctance tachometer having 60 rotor teeth the count reads 3600 counts per minute. The speed in RPM is
36
60
360
3600

⇒ Which of the following statement is incorrect?
UJT is a 3-terminal diode having two unequally doped regions
A UJT can be triggered by any one of its three terminals
The bi-directional switching characteristics of a diac are symmetrical
As compared to JFETs, MOSFETs generate less noise in high gain amplifiers

⇒ Given below a block diagram of oscillator circuit with various reactance elemen
x₁ = C, x₂ = L, x₃ = C
x₁ = C, x₂ = L, x₃ = L
x₁ = C, x₂ = C, x₃ = L
x₁ = L, x₂ = C, x₃ = L

⇒ Two linearly polarized plane waves A and B travelling in free space in the positive x direction meet at a point. Wave A is polarized in the y direction and the wave B is polarized in the z direction. If the two waves are of equal amplitude and are in phase quadrature, the resultant wave will be
circularly polarized
elliptically polarized
linearly polarized
vertically polarized

⇒ For the system with given characteristic equat
3, 2, 0
4, 0, 1
3, 0, 2
4, 1, 0

⇒ Find the radiation resistance of an antenna of length λ/10 meter?
8 Ω
780 Ω
7.8 Ω
78 Ω

⇒ In the signal flow graph of figure, y/x equ
3
42857
2
None of the above

⇒ The characteristic equation for the next state (Q_n+1) of a J-K flip-flop is
Q_n+1 = JQ_n + KQ_n
Q_n+1 = JQ_n + KQ_n
Q_n+1 = JQ_n + KQ_n
Q_n+1 = JQ_n + KQ_n

⇒ Which circuit is called swamped amplifier?
CC
CE
CB
Both (a) and (b)

⇒ 300 to 3000 MHz frequency is categorized as
MF
HF
UHF
SHF

⇒ Sound wave travels as
longitudinal waves
transverse waves
both longitudinal and transverse waves
either longitudinal or transverse wave

⇒ V_th = 0, if
there is no independent source in circuit
there is no dependent source in circuit
voltage source of infinite magnitude
none

⇒ Avalanche beakdown is primarily dependent on the phenomenon of
doping
collision
recombination
ionization

⇒ The load end of a quarter wave transformer gets disconnected thereby causing an open-circuited load. What will be the input impedance of the transformer?
Zero
Infinite
Finite and Positive
Finite and Negative

⇒ The atmospheric absorption of radio waves depends on
frequency of wave
the distance from transmitter
wave polarisation
atmospheric polarisation

⇒ If average correlation between v₁(t) and v₂(t) is R₁₂(t) and average correlation between v₂(t) and v₁(t) is R₂₁(t) then
R₁₂(t) = R₂₁(t)
R₂₁(t) = R₁₂(t)
R₁₂(t) = - R₂₁(t)
none of these

⇒ The communicating capacitor reduces turn on time because
it acts as an open circuit
it allows maximum base circuit to flow
it aids in removing the excess carrier from the base region
none of these

⇒ A voltage of about 200 V dc can be measured
directly by dc potentiometer
by dc potentiometer in conjunction with a volt ratio box
a dc potentiometer in conjunction with a known resistance
both (b) and (c)

⇒ The degree of the nodes 1, 2, 3,
2
3
2 for 1, 2, 3, and 3 for 4
all 3

⇒

Assertion (A): In an op-amp the voltage gain and band width can be adjusted as per requirement

Reason (R): Large value capacitor can also be fabricated on a chip

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct