Question is ⇒ The amount of dielectric heating is inversely proportional to frequency., Options are ⇒ (A) TRUE, (B) FALSE, (C) , (D) , (E) , Leave your comments or Download question paper.

Question is ⇒ The amount of dielectric heating is inversely proportional to frequency., Options are ⇒ (A) TRUE, (B) FALSE, (C) , (D) , (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The amount of dielectric heating is inversely proportional to frequency.
A.	TRUE [Wrong Answer]
B.	FALSE [Correct Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ How is an N-channel junction Field Effect Transistor operated as an amplifier?
With a forward bias gate source junction
With a reverse bias gate-source junction
With a open gate source junction
With a shorted gate source junction

⇒ In floating point representation, mantissa is expressed in
excess 3 notation
gray code
excess 32 notation
2's complement

⇒

Assertion (A): A balun is an RF impedance matching transformer.

Reason (R): Sometimes a booster amplifier is used with a TV set.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Why does a FM radio station perform better than and AM station radiating the same actual power?
FM is immune to noise
AM has only two sidebands while FM has more
FM uses larger bandwidth for large modulation depth.
Capture effects appears in FM.

⇒ The reflection coefficient is generally a
complex number
fraction
imaginary number
none of the above

⇒ The circuit shown in figure
oscillate at 456 kHz
oscillate at 228 kHz
oscillate at microwave frequency
not oscillate

⇒ For the logic circuit given, what is the simplified Boolean funct
X = AB + C
X = BC + A
X = AB + AC
X = AC + B

⇒

Assertion (A): When the phase margin of a control system is improved using a lead network, noise transmission increases.

Reason (R): Phase lead compensation increases bandwidth.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒

Assertion (A): In an RC coupled amplifier the junction capacitances can be neglected at low frequencies but not at high frequencies

Reason (R): Capacitive reactance is inversely proportional to frequency.

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ The fuse material used in electrical lines must have which one of the following properties?
High resistivity
Low conductivity
High melting point
Low melting point

⇒ Fermi level is the amount of energy in which
a hole can have at room temperature
an electron can have at room temperature
must be given to an electron move to conduction band
none of the above

⇒ In which region of a CE bipolar transistor is collector current almost constant?
Saturation region
Active region
Breakdown region
Both saturation and active region

⇒ To evaluate X = (A + B + 1.2) * (A + B - C) the sequence of operation is
+ + + - * =
* + + + - =
+ + - * + =
- + + + * =

⇒ SWR for a transmission line is infinity when the load is

Short circuit
Complex impedance
Open circuit
Pure reactance

Of the above statements:
1, 3, 4 are correct
1 and 3 are correct
2, 3, 4 are correct
1, 2, 4 are correct

⇒ Maxterm designation for A + B + C is
M₀
M₁
M₃
M₄

⇒ An energy signal has G(f) = 10. Its energy density spectrum is
10
100
50
20

⇒ Which of the following is not necessarily the advantages of a push pull amplifier?
It gives more output
It removes odd a well as even harmonics
There is no effect of ripple of the power supply
It consumes least power

⇒ The reverse saturation current depends on the reverse bias.
TRUE
FALSE

⇒ A narrowband amplifier is one that has a passband
limited to 2000 Hz only
limited to audio frequency range only
near cut off region of active device
approximately 10% of its central frequency

⇒ In the forward blocking region of a silicon, controlled rectifier, the SCR is
in the off-state
in the ON state
reverse biased
at the point of breakdown

⇒ The circuit in figur
positive clamper
negative clamper
positive peak clipper
negative peak clipper

⇒ An ammeter is
secondary instrument
absolute instrument
recording instrument
integrating instrument

⇒ The hexadecimal number 'A0' has the decimal value
80
256
100
160

⇒ The no. of comparators required in a 3 bit comparator type ADC is
2
3
7
8

⇒ In a specimen of ferromagnetic material, as the flux density is increased from zero to 2.5 T, µ_r will
increase
decrease
first decrease then increase
first increase then decrease

⇒ In the schematic representation of bipolar junction transistor, the direction of arrow shows the direction of flow of
holes
electrons
holes in pnp and electrons in npn
electrons in pnp and holes in npn

⇒ The concentration of minority carriers in a semiconductor depends mainly on
the extent of doping
temperature
the applied bias
none of the above

⇒ Which of the following is not an omnidirectional antenna?
Log periodic
Half-wave dipole
Discone
Marconi

⇒ The resolution of a DAC depends on which of the following?
The number of bits
Monotonicity
Reference voltage
The values of resistance

⇒

Assertion (A): Ferrites are very useful at very high frequencies.

Reason (R): Ferrites have high permeability and high resistivity.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true